- 您現在的位置：買賣IC網 > PDF目錄383319 > MAX1444 (Maxim Integrated Products, Inc.) 10-Bit, 40Msps, 3.0V, Low-Power ADC with Internal Reference PDF資料下載
參數資料
| 型號： | MAX1444 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 10-Bit, 40Msps, 3.0V, Low-Power ADC with Internal Reference |
| 中文描述： | 10位、40Msps、3.0V、低功耗ADC，內置電壓基準 |
| 文件頁數： | 14/20頁 |
| 文件大小： | 401K |
| 代理商： | MAX1444 |
M
10-Bit, 40Msps, 3.0V, Low-Power
ADC with Internal Reference
14
______________________________________________________________________________________
N - 6
N
N - 5
N + 1
N - 4
N + 2
N - 3
N + 3
N - 2
N + 4
N - 1
N + 5
N
N + 6
N + 1
N + 7
5.5 CLOCK-CYCLE LATENCY
ANALOG INPUT
CLOCK INPUT
DATA OUTPUT
t
DO
t
AD
t
CL
t
CH
Figure 6. System and Output Timing Diagram
System Timing Requirements
Figure 6 shows the relationship between the clock
input, analog input, and data output. The MAX1444
samples at the falling edge of the input clock. Output
data is valid on the rising edge of the input clock. The
output data has an internal latency of 5.5 clock cycles.
Figure 5 shows the relationship between the input clock
parameters and the valid output data.
__________Applications Information
Figure 7 shows a typical application circuit containing a
single-ended to differential converter. The internal refer-
ence provides a V
DD
/2 output voltage for level shifting
purposes. The input is buffered and then split to a volt-
age follower and inverter. A lowpass filter follows the op
amps to suppress some of the wideband noise associ-
ated with high-speed op amps. The user may select the
R
ISO
and C
IN
values to optimize the filter performance
to suit a particular application. For the application in
Figure 7, an R
ISO
of 50
is placed before the capaci-
tive load to prevent ringing and oscillation. The 22pF
C
IN
capacitor acts as a small bypassing capacitor.
Using Transformer Coupling
An RF transformer (Figure 8) provides an excellent
solution for converting a single-ended source signal to
a fully differential signal, required by the MAX1444 for
optimum performance. Connecting the transformer
’
s
center tap to COM provides a V
DD
/2 DC level shift to
the input. Although a 1:1 transformer is shown, a step-
up transformer may be selected to reduce the drive
requirements. A reduced signal swing from the input
driver, such as an op amp, may also improve the over-
all distortion.
In general, the MAX1444 provides better SFDR and
THD with fully differential input signals than single-
ended drive, especially for very high input frequencies.
In differential input mode, even-order harmonics are
lower since both inputs (IN+, IN-) are balanced, and
each of the inputs only requires half the signal swing
compared to single-ended mode.
Single-Ended AC-Coupled Input Signal
Figure 9 shows an AC-coupled, single-ended applica-
tion. The MAX4108 op amp provides high speed, high
bandwidth, low noise, and low distortion to maintain the
integrity of the input signal.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1444EHJ | 10-Bit, 40Msps, 3.0V, Low-Power ADC with Internal Reference |
| MAX1446 | 10-Bit, 60Msps, 3.0V, Low-Power ADC with Internal Reference |
| MAX1446EHJ | 10-Bit, 60Msps, 3.0V, Low-Power ADC with Internal Reference |
| MAX1447 | 1C Remote and Local TEMPERATURE SENSOR with N-Factor and Series Resistance Correction 16-SSOP/QSOP -40 to 125 |
| MAX1496EAI | 3.5- and 4.5-Digit, Single-Chip ADCs with LED Drivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1444EHJ | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1444EHJ/V+ | 功能描述:模數轉換器 - ADC ANALOG TO DIGITAL CONVERTER RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1444EHJ/V+T | 功能描述:模數轉換器 - ADC 10-Bit 40Msps 3.0V Low-Power ADC with Internal Reference RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1444EHJ+ | 功能描述:模數轉換器 - ADC 10-Bit 40Msps 3V High Speed ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1444EHJ+T | 功能描述:模數轉換器 - ADC 10-Bit 40Msps 3V High Speed ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。