- 您現在的位置：買賣IC網 > PDF目錄10340 > MAX13330GEE/V+T (Maxim Integrated Products)IC AMP STEREO HEADPHONE 16-QSOP PDF資料下載
參數資料
| 型號： | MAX13330GEE/V+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 14/15頁 |
| 文件大小： | 0K |
| 描述： | IC AMP STEREO HEADPHONE 16-QSOP |
| 其它有關文件： | Automotive Product Guide |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 系列： | DirectDrive® |
| 類型： | AB 類 |
| 輸出類型： | 耳機，2-通道（立體聲） |
| 在某負載時最大輸出功率 x 通道數量： | 135mW x 2 @ 32 歐姆 |
| 電源電壓： | 4 V ~ 5.5 V |
| 特點： | 消除爆音，短路保護，關機 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 16-QSOP |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 包裝： | 帶卷 (TR) |
MAX13330/MAX13331
Automotive DirectDrive Headphone Amplifiers
with Output Protection and Diagnostics
8
_______________________________________________________________________________________
Detailed Description
The MAX13330/MAX13331 headphone amplifiers fea-
ture Maxim’s DirectDrive architecture, eliminating the
large output-coupling capacitors required by conven-
tional single-supply headphone amplifiers. The devices
consists of two Class AB headphone amplifiers, under-
voltage lockout (UVLO), low-power shutdown control,
comprehensive click-and-pop suppression, output
short-circuit/ESD protection and output short-circuit
diagnostics.
These devices can drive loads as low as 8
Ω, and deliv-
er up to 120mW per channel into 16
Ω and 135mW into
32
Ω. The MAX13330 features a fixed gain of -1.5V/V,
and the MAX13331 features a programmable gain con-
figured with external resistors. The headphone outputs
feature ±15kV Human Body Model ESD protection, and
enhanced short-circuit protection to ground or battery
(VBAT up to +45V). An integrated short-circuit diagnos-
tic output provides the status of the MAX13330/
MAX13331 during operation as a fraction of the analog
supply voltage.
DirectDrive
Conventional single-supply headphone amplifiers have
their outputs biased about a nominal DC voltage (typi-
cally half the supply) for maximum dynamic range.
Large coupling capacitors are needed to block this DC
bias from the headphone. Without these capacitors, a
significant amount of DC current flows to the head-
phone, resulting in unnecessary power dissipation and
possible damage to both the headphone and the head-
phone amplifier.
Maxim’s DirectDrive architecture uses a charge pump
to create an internal negative-supply voltage, allowing
the MAX13330/MAX13331 outputs to be biased about
SGND (Figure 1). With no DC component, there is no
need for the large DC-blocking capacitors. Instead of
two large (220F, typ) tantalum capacitors, the
MAX13330/MAX13331 charge pump requires two small
ceramic capacitors, conserving board space, reducing
cost, and improving the frequency response of the
headphone amplifier. See the Output Power vs. Load
Resistance
graph
in
the
Typical
Operating
Characteristics for details of the possible capacitor
sizes. There is a low DC voltage on the amplifier out-
puts due to amplifier offset. However, the output offset
of the MAX13330 is typically ±2.5mV which, when com-
bined with a 32
Ω load, results in less than ±78A of DC
current flow to the headphones. Previous attempts to
eliminate the output-coupling capacitors involved bias-
ing the headphone return (sleeve) to the DC-bias volt-
age of the headphone amplifiers.
This method raises some issues:
The sleeve is typically grounded to the chassis.
Using this biasing approach, the sleeve must be
isolated from system ground, complicating product
design.
During an ESD strike, the amplifier’s ESD structures
are the only path to system ground. Thus, the ampli-
fier must be able to withstand the full ESD strike.
When using the headphone jack as a line out to
other equipment, the bias voltage on the sleeve
may conflict with the ground potential from other
equipment, resulting in possible damage to the
amplifiers.
VDD
VSS
GND
VOUT
CONVENTIONAL DRIVER-BIASING SCHEME
DirectDrive BIASING SCHEME
VDD/2
VDD
GND
VOUT
Figure 1. Conventional Driver Output Waveform vs. MAX13330/
MAX13331 Output Waveform
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2480HDD#TRPBF | IC ADC DELTA SIGMA 16BIT 10DFN |
| MAX9789BETJ+T | IC AMP AUDIO 2W STER AB 32TQFN |
| MS27508E10F13PB | CONN RCPT 13POS BOX MNT W/PINS |
| TA3MX | CONN PLUG CORD 3POS MALE MINI |
| MS27467E15B19PA | CONN PLUG 19POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX13331EVKIT+ | 功能描述:音頻 IC 開發工具 MAX13331 DirectDrive Eval Kit RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| MAX13331GEE/V+ | 功能描述:音頻放大器 DirectDrive Head Phone Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX13331GEE/V+T | 功能描述:音頻放大器 DirectDrive Head Phone Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX13335EEVKIT# | 功能描述:放大器 IC 開發工具 MAX13335E Eval Kit RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
| MAX13335EEVKIT+ | 功能描述:放大器 IC 開發工具 MAX13335E Eval Kit RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
發布緊急采購，3分鐘左右您將得到回復。