參數資料
型號: MAX1106CUB+
廠商: Maxim Integrated Products
文件頁數: 5/16頁
文件大小: 0K
描述: IC ADC 8BIT LP 10-UMAX
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 50
位數: 8
采樣率(每秒): 25k
數據接口: MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 290µW
電壓電源: 單電源
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 10-TFSOP,10-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 10-µMAX
包裝: 管件
輸入數目和類型: 2 個單端,單極;1 個偽差分,單極
MAX1106/MAX1107
Single-Supply, Low-Power,
Serial 8-Bit ADCs
______________________________________________________________________________________
13
data out of this register at any time after the conversion
is complete. After the eighth data-bit has clocked out,
DOUT goes high impedance and remains so with addi-
tional SCLKs.
Normally leave CONVST low until a new conversion
needs to be started. CONVST should be high for a
maximum of 100s to maintain the 8-bit accuracy of the
Autozero Circuit.
The acquisition time, tACQ, starts immediately after the
end of conversion and a new conversion can be started
immediately after all data has been clocked out by tog-
gling CONVST high. Figure 8 shows a timing diagram
for a conversion at the data rate of 40ksps. Typically
20s are necessary for the conversion to complete, 4s
for reading the eight bits of data with a serial clock of
2MHz, and 1s to complete the zero rail adjustment
and acquisition. The conversion time is guaranteed to
be less than 35s, therefore the data rate should be
limited to 25ksps unless the conversion time for the
specific condition is known. Conversion time can be
determined by measuring the time between CONVST
falling edge and DOUT rising edge with a full-scale
input voltage.
__________Applications Information
Power-On Reset
When power is first applied with SHDN high or connect-
ed to VDD, the MAX1106/MAX1107 is in track mode.
Conversion can be started by toggling CONVST high to
low as soon as the reference is settled when using the
internal reference, or after 20s when an external refer-
ence is used. Powering up the MAX1106/MAX1107 with
CONVST low will not start a conversion. No conversions
should be performed until the reference voltage (inter-
nal or external) has stabilized.
Shutdown Operation
Pulling SHDN low places the converter in low-current
power-down mode. In this state the converter draws
typically 0.5A. In shutdown the analog biasing circuit
and the internal bandgap reference are powered down,
and DOUT goes high impedance.
The conversion stops coincidentally with SHDN going
low. If shutdown occurs during a conversion, power up,
wait 35s, and clock SCLK eight times.
CONVST
SCLK
DOUT
tCSPW
tCONV
tDV
tCH
#1
#8
tCL
tDO
tDV
tTR
tSCC
Figure 7. Detailed Serial Interface Timing
CONVST
5V/div
SCLK
5V/div
DOUT
5V/div
5
s/div
tCONV
Figure 8. 40ksps Timing Diagram
相關PDF資料
PDF描述
MS3114P10-98S CONN RCPT 6POS JAM NUT W/SCKT
MS27497T14A15P CONN RCPT 15POS WALL MNT W/PINS
IDT72V3651L15PF IC SYNCFIFO 2048X36 15NS 120TQFP
MS27473T12F3PB CONN PLUG 3POS STRAIGHT W/PINS
MS27472T10F35PB CONN RCPT 13POS WALL MNT W/PINS
相關代理商/技術參數
參數描述
MAX1106CUB+ 功能描述:模數轉換器 - ADC Single-Supply Low-P Serial 8-Bit RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
MAX1106CUB+T 功能描述:模數轉換器 - ADC Single-Supply Low-P Serial 8-Bit RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
MAX1106CUB-G07 制造商:Maxim Integrated Products 功能描述:+3V SINGLE-SUPPLY, LOW-POWER, SERIAL 8-BIT AD 10 PINS UMAX P - Bulk 制造商:Maxim Integrated Products 功能描述:- Rail/Tube
MAX1106CUBT 制造商:Maxim Integrated Products 功能描述:
MAX1106CUB-T 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32