參數資料
型號: M93C46-MB6P
廠商: STMICROELECTRONICS
元件分類: PROM
英文描述: 64 X 16 MICROWIRE BUS SERIAL EEPROM, DSO8
封裝: 2 X 3 MM, ROHS COMPLIANT, MLP-8
文件頁數: 2/38頁
文件大?。?/td> 348K
代理商: M93C46-MB6P
Operating features
M93C86, M93C76, M93C66, M93C56, M93C46
3
Operating features
3.1
Supply voltage (VCC)
3.1.1
Operating supply voltage VCC
Prior to selecting the memory and issuing instructions to it, a valid and stable VCC voltage
within the specified [VCC(min), VCC(max)] range must be applied. In order to secure a stable
DC supply voltage, it is recommended to decouple the VCC line with a suitable capacitor
(usually of the order of 10 nF to 100 nF) close to the VCC/VSS package pins.
This voltage must remain stable and valid until the end of the transmission of the instruction
and, for a Write instruction, until the completion of the internal write cycle (tW).
3.1.2
Power-up conditions
When the power supply is turned on, VCC rises from VSS to VCC. During this time, the Chip
Select (S) line is not allowed to float and should be driven to VSS, it is therefore
recommended to connect the S line to VCC via a suitable pull-down resistor.
The VCC rise time must not vary faster than 1 V/s.
3.1.3
Power-up and device reset
In order to prevent inadvertent Write operations during power-up, a power on reset (POR)
circuit is included. At power-up (continuous rise of VCC), the device does not respond to any
instruction until VCC has reached the power on reset threshold voltage (this threshold is
lower than the minimum VCC operating voltage defined in Table 9, Table 10 and Table 11).
When VCC passes the POR threshold, the device is reset and is in the following state:
Standby Power mode
deselected (assuming that there is a pull-down resistor on the S line)
3.1.4
Power-down
At power-down (continuous decrease in VCC), as soon as VCC drops from the normal
operating voltage to below the power on reset threshold voltage, the device stops
responding to any instruction sent to it.
During power-down, the device must be deselected and in the Standby Power mode (that is,
there should be no internal Write cycle in progress).
相關PDF資料
PDF描述
M93C66-MN3TP 256 X 16 MICROWIRE BUS SERIAL EEPROM, PDSO8
M93C66-MB3TP 256 X 16 MICROWIRE BUS SERIAL EEPROM, DSO8
M94 FEMALE, RIGHT ANGLE TELECOM AND DATACOM CONNECTOR, SOLDER, SOCKET
M95080-RMB6 1K X 8 SPI BUS SERIAL EEPROM, DSO8
M95320-BN6 4K X 8 SPI BUS SERIAL EEPROM, PDIP8
相關代理商/技術參數
參數描述
M93C46-MB6P/S 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit (8-bit or 16-bit wide) MICROWIRE㈢ serial access EEPROM
M93C46-MB6P/W 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit (8-bit or 16-bit wide) MICROWIRE㈢ serial access EEPROM
M93C46-MB6TG 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit (8-bit or 16-bit wide) MICROWIRE㈢ serial access EEPROM
M93C46-MB6TG/S 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit (8-bit or 16-bit wide) MICROWIRE㈢ serial access EEPROM
M93C46-MB6TG/W 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit (8-bit or 16-bit wide) MICROWIRE㈢ serial access EEPROM