- 您現在的位置：買賣IC網 > PDF目錄45044 > M38238G8-XXXHP 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | M38238G8-XXXHP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 12 X 12 MM, 0.50 MM PITCH, PLASTIC, LQFP-80 |
| 文件頁數： | 32/76頁 |
| 文件大?。?/td> | 896K |
| 代理商： | M38238G8-XXXHP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
Rev.2.02
Jun 19, 2007
page 38 of 73
REJ03B0146-0202
3823 Group
A/D CONVERTER
[AD Conversion Register (ADH, ADL)] 003516
The AD conversion register is a read-only register that contains
the result of an A/D conversion. When reading this register during
an A/D conversion, the previous conversion result is read.The
high-order 8 bits of a conversion result is stored in the AD conver-
sion high-order register (address 003516),and the low-order 2 bits
of the same result are stored in bit 7 and bit 6 of the AD conver-
sion low-order register (address 003616).
The bit 0 in the AD conversion low-order register is used as the
conversion mode selection bit. 8-bit A/D mode is selected by set-
ting this bit to “0” and 10-bit A/D mode is selected by setting it to
“1”.
[AD Control Register (ADCON)] 003416
The AD control register controls the A/D conversion process. Bits
0 to 2 of this register select specific analog input pins. Bit 3 signals
the completion of an A/D conversion. The value of this bit remains
at “0” during an A/D conversion, then changes to “1” when the
A/D conversion is completed. Writing “0” to this bit starts the A/D
conversion. Bit 4 is the VREF input switch bit which controls con-
nection of the resistor ladder and the reference voltage input pin
(VREF). The resistor ladder is always connected to VREF when bit
4 is set to "1". When bit 4 is set to “0”, the resistor ladder is cut off
from VREF except for A/D conversion performed. When bit 5,
which is the AD external trigger valid bit, is set to “1”, this bit en-
ables A/D conversion even by a falling edge of an ADT input. Set
the P57/ADT pin to input mode (set "0" to bit 7 of port P5 direction
register) when using an A/D external trigger.
[Comparison Voltage Generator]
The comparison voltage generator divides the voltage between
AVSS and VREF, and outputs the divided voltages.
[Channel Selector]
The channel selector selects one of the input ports P67/AN7–P60/
AN0, and inputs it to the comparator.
[Comparator and Control Circuit]
The comparator and control circuit compares an analog input volt-
age with the comparison voltage and stores the result in the AD
conversion register. When an A/D conversion is completed, the
control circuit sets the AD conversion completion bit and the AD
interrupt request bit to “1”.
The comparator is constructed linked to a capacitor. The conver-
sion accuracy may be low because the charge is lost if the
conversion speed is not enough. Accordingly, set f(XIN) to at least
500kHz during A/D conversion in the middle-or high-speed mode.
Also, do not execute the STP or WIT instruction during an A/D
conversion.
In the low-speed mode, since the A/D conversion is executed by
the built-in self-oscillation circuit, the minimum value of f(XIN) fre-
quency is not limited.
Fig. 33 Structure of AD conversion-related registers
AD control register
(ADCON : address 003416)
AD conversion completion bit
0 : Conversion in progress
1 : Conversion completed
Analog input pin selection bits
0 0 0 : P60/AN0
0 0 1 : P61/AN1
0 1 0 : P62/AN2
0 1 1 : P63/AN3
1 0 0 : P64/AN4
1 0 1 : P65/AN5
1 1 0 : P66/AN6
1 1 1 : P67/AN7
VREF input switch bit
0 : ON during conversion
1 : Always ON
AD external trigger valid bit
0 : A/D external trigger invalid
1 : A/D external trigger valid
b7
b0
Interrupt source selection bit
0 : Interrupt request at A/D
conversion completed
1 : Interrupt request at ADT
input falling
Not used (returns “0” when read)
AD conversion low-order register
(ADL : address 003616)
AD conversion speed selection bit
00 : f(XIN)/2
(this can be used in CPUM7 = “0” )
01 : f(XIN)
(this can be used in CPUM7 = “0” )
10 : On-chip oscillator
(this can be used in CPUM7 = “0”
and EXPCM0 = “1”)
11 : Disabled
Conversion mode selection bit
0 : 8 bit A/D mode
1 : 10 bit A/D mode
Not used (returns “0” when read)
In 10-bit A/D mode
A/D conversion data storage
In 8-bit A/D mode
Not used (Indefinite at read)
b7
b0
相關PDF資料 |
PDF描述 |
|---|---|
| M3823AGF-XXXHP | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80 |
| M38238G8FP | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80 |
| M3823AGFHP | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80 |
| M38239GC-XXXFP | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80 |
| M38234G4HP | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M38239GCFP#U0 | 功能描述:MCU 2/5V 48K 80-QFP QZ-ROM RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 標準包裝:250 系列:80C 核心處理器:8051 芯體尺寸:8-位 速度:16MHz 連通性:EBI/EMI，I²C，UART/USART 外圍設備:POR，PWM，WDT 輸入/輸出數:40 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-LCC（J 形引線） 包裝:帶卷 (TR) |
| M38239GCHP#U0 | 功能描述:MCU 2/5V 48K 80-LQFP QZ-ROM RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 標準包裝:250 系列:80C 核心處理器:8051 芯體尺寸:8-位 速度:16MHz 連通性:EBI/EMI，I²C，UART/USART 外圍設備:POR，PWM，WDT 輸入/輸出數:40 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-LCC（J 形引線） 包裝:帶卷 (TR) |
| M3823AGFFP#U0 | 功能描述:MCU 2/5V 60K 80-QFP QZ-ROM RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 標準包裝:250 系列:80C 核心處理器:8051 芯體尺寸:8-位 速度:16MHz 連通性:EBI/EMI，I²C，UART/USART 外圍設備:POR，PWM，WDT 輸入/輸出數:40 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-LCC（J 形引線） 包裝:帶卷 (TR) |
| M3823AGFHP#U0 | 功能描述:MCU 2/5V 60K 80-LQFP QZ-ROM RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 標準包裝:250 系列:80C 核心處理器:8051 芯體尺寸:8-位 速度:16MHz 連通性:EBI/EMI，I²C，UART/USART 外圍設備:POR，PWM，WDT 輸入/輸出數:40 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-LCC（J 形引線） 包裝:帶卷 (TR) |
| M3823AT-RLFS | 功能描述:DEV EMULATOR PERSONALITY KIT M38 RoHS:否 類別:編程器，開發系統 >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。