參數資料
型號: M38227ECFP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP80
封裝: 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數: 27/82頁
文件大?。?/td> 1168K
代理商: M38227ECFP
30
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
3822 Group
MITSUBISHI MICROCOMPUTERS
(2) Asynchronous Serial I/O (UART) Mode
Clock asynchronous serial I/O mode (UART) can be selected by
clearing the serial I/O mode selection bit of the serial I/O control
register to “0”.
Eight serial data transfer formats can be selected, and the transfer
formats used by a transmitter and receiver must be identical.
The transmit and receive shift registers each have a buffer regis-
ter, but the two buffers have the same address in memory. Since
the shift register cannot be written to or read from directly, transmit
data is written to the transmit buffer, and receive data is read from
the receive buffer.
The transmit buffer can also hold the next data to be transmitted,
and the receive buffer register can hold a character while the next
character is being received.
Fig. 27 Block diagram of UART serial I/O
Fig. 28 Operation of UART serial I/O function
f(XIN)
1/4
OE
PE FE
1/16
Data bus
Receive buffer register
Address 001816
Receive shift register
Receive buffer full flag (RBF)
Receive interrupt request (RI)
Baud rate generator
Frequency division ratio 1/(n+1)
Address 001C16
ST/SP/PA generator
Transmit buffer register
Data bus
Transmit shift register
Address 001816
Transmit shift register shift completion flag (TSC)
Transmit buffer empty flag (TBE)
Transmit interrupt request (TI)
Address 001916
STdetector
SP detector
UART control register
Address 001B16
Character length selection bit
Address 001A16
BRG count source selection bit
Transmit interrupt source selection bit
Serial I/O synchronous clock selection bit
Clock control circuit
Character length selection bit
7 bits
8 bits
Serial I/O control register
P46/SCLK
Serial I/O status register
P44/RXD
P45/TXD
(f(XCIN) in low-speed mode)
TSC=0
TBE=1
RBF=0
TBE=0
RBF=1
ST
D0
D1
SP
D0
D1
ST
SP
TBE=1
TSC=1
ST
D0
D1
SP
D0
D1
ST
SP
Transmit buffer write signal
Generated at 2nd bit in 2-stop-bit mode
1 start bit
7 or 8 data bits
1 or 0 parity bit
1 or 2 stop bit (s)
1 : Error flag detection occurs at the same time that the RBF flag becomes “1” (at 1st stop bit, during reception).
2 : The transmit interrupt (TI) can be selected to occur when either the TBE or TSC flag becomes “1” by the setting of the transmit interrupt source
selection bit (TIC) of the serial I/O control register.
3 : The receive interrupt (RI) is set when the RBF flag becomes “1”.
4 : After data is written to the transmit buffer register when TSC=1, 0.5 to 1.5 cycles of the data shift cycle is necessary until changing to TSC=0.
Notes
Serial output TXD
Serial input RXD
Receive buffer read signal
Transmit or receive clock
相關PDF資料
PDF描述
M38223M4HXXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP80
M38223E4GP 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP80
M38222M2-XXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP80
M38223M4-XXXHP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP80
M38227M8HXXXHP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
M38227ECFP#U0 功能描述:MCU 3/5V 48K PB-FREE 80-QFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:740/38000 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN,SCI,SPI 外圍設備:POR,PWM,溫度傳感器,WDT 輸入/輸出數:21 程序存儲器容量:40KB(20K x 16) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323
M38227ECFS 制造商:Renesas Electronics Corporation 功能描述:MCU 8BIT 740 CISC 48KB EPROM 5V 80CLCC - Bulk
M38227FGFP 制造商:Renesas Electronics Corporation 功能描述:SLIM740 OTP 16K/512B RAM, W/A-D, LED, 4 - Rail/Tube
M38227RFS 制造商:Renesas Electronics Corporation 功能描述:MCU - Trays
M3823 BK001 制造商:Alpha Wire Company 功能描述:CBL 30COND 18AWG BLK 1000'