![](http://datasheet.mmic.net.cn/30000/M37906M8C-XXXFP_datasheet_2360041/M37906M8C-XXXFP_72.png)
72
M37906M4C-XXXFP, M37906M4C-XXXSP, M37906M4H-XXXFP
M37906M4H-XXXSP, M37906M6C-XXXFP, M37906M6C-XXXSP
M37906M8C-XXXFP, M37906M8C-XXXSP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Som
e param
etric
lim
its are
subject
to change.
16-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
Fig. 79 Microcomputer internal register’s status at reset (2)
RESET CIRCUIT
While the power source voltage satisfies the recommended operat-
ing condition, reset state is removed if pin RESET’s level returns
from the stabilized “L” level to the “H” level. As a result, program ex-
ecution starts from the reset vector address. This reset vector ad-
dress is expressed as shown below:
A23 to A16 = 0016
A15 to A8 = Contents at address FFFF16
A7 to A0 = Contents at address FFFE16
Figures 78 and 79 show the microcomputer internal register’s status
at reset, and Figure 80 shows an operation example of the reset cir-
cuit. Apply “L” level voltage to pin RESET for a period (10 s or more)
under the following conditions:
Pin Vcc’s level satisfies the recommended operating condition.
Oscillator’s operation has been stabilized.
Fig. 80 Operation example of reset circuit (Note that proper evalua-
tion is necessary in the system development stage.)
VCC
RESET
Power on
VCC level
0.2VCC level
Oscillation stabilized
10
s
XIN
0V
(A616)
Address
Waveform output mode register
(A816)
Three-phase output data register 0
(A916)
Three-phase output data register 1
(AA16)
Position-data-retain function control register
(D716)
Timer A6 mode register
(AC16)
Serial I/O pin control register
(AE16)
Port P2 pin function control register
(BC16)
Clock control register 0
(C416)
Up-down register 1
(D616)
Timer A5 mode register
(D816)
Timer A7 mode register
(D916)
Timer A8 mode register
Note: The contents of the other registers and RAM are undefined at reset and must be initialized by software.
(DA16)
Timer A9 mode register
(DC16)
Comparator function select register 0
(DE16)
Comparator result register 0
Address
0
00
01 1
000 0
0016
Program bank register PG
Contents at address FFFF16
Program counter PCH
Contents at address FFFE16
Program counter PCL
000016
Direct page registers DPR0 to DPR3
Data bank register DT
FFF16
Stack pointer
Processor status register PS
1??
0
00
? ?
0
0 0
INT7 interrupt control register
0000
(F516)
Timer A5 interrupt control register
(F616)
Timer A6 interrupt control register
(F716)
Timer A7 interrupt control register
0
00
0 0 0
(F916)
Timer A9 interrupt control register
000
(FE16)
INT6 interrupt control register
0
00
0 0 0
(FD16)
INT5 interrupt control register
(F816)
Timer A8 interrupt control register
(FF16)
0
00
0016
1
000 0
0016