- 您現在的位置：買賣IC網 > PDF目錄98005 > M37210M4-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP52 PDF資料下載
參數資料
| 型號： | M37210M4-XXXSP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP52 |
| 封裝： | 0.600 INCH, 1.78 MM PITCH, PLASTIC, SDIP-52 |
| 文件頁數： | 61/62頁 |
| 文件大小： | 845K |
| 代理商： | M37210M4-XXXSP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁當前第61頁第62頁
MITSUBISHI MICROCOMPUTERS
M37210M3-XXXSP/FP, M37210M4-XXXSP, M37211M2-XXXSP
M37210E4-XXXSP/FP, M37210E4SP/FP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
with ON-SCREEN DISPLAY CONTROLLER
5
PIN DESCRIPTION
Pin
VCC,
VSS
CNVSS
RESET
XIN
XOUT
φ
P00 – P07
P11 – P14
P15 – P17
P20 – P27
P30, P31
P32 – P35
P40, P41
P42
P60 – P63
OSC1,
OSC2
HSYNC
VSYNC
R, G, B,
OUT
D-A
Name
Power source voltage
CNVSS
Reset input
Clock input
Clock output
Timing output
I/O port P0
I/O port P1
Input port P1
I/O port P2
I/O port P3
Input port P3
I/O port P4
Input port P4
Output port P6
Clock input for CRT
display
Clock output for CRT
display
HSYNC input
VSYNC input
CRT output
DA Output
Input /
Output
Input
Output
I/O
Input
I/O
Input
I/O
Input
Output
Input
Output
Input
Output
Functions
Apply voltage of 5V ± 10% to VCC, and 0V to VSS.
This is connected to VSS.
To enter the reset state, the reset input pin must be kept at a “L” for 2
s or more (under nor-
mal VCC conditions).
If more time is needed for the crystal oscillator to stabilize, this “L” condition should be main-
tained for the required time.
This chip has an internal clock generating circuit. To control generating frequency, an exter-
nal ceramic resonator or a quartz-crystal oscillator is connected between the XIN and
XOUT pins. If an external clock is used, the clock source should be connected the XIN pin and
the XOUT pin should be left open.
This is the timing output pin.
Port P0 is an 8-bit I/O port with directional registers allowing each I/O bit to be individually
programmed as input or output. At reset, this port is set to input mode. The output structure
is CMOS output.
The output structure is N-channel open-drain output. When PWM4, PWM5, PWM6 and
PWM7 are used, P00, P01, P02 and P03 are in common with PWM output pins of PWM4,
PWM5, PWM6 and PWM7.
Ports P10, P11, P12, P13 and P14 are 5-bit I/O ports and have basically the same functions
as port P0. The output structure is CMOS output.
Ports P15, P16 and P17 are 3-bit input ports and they are in common with input pins of A-D
comparator (A-D1, A-D2 and A-D3).
Port P2 is an 8-bit I/O port and has basically the same functions as port P0.
The output structure is CMOS output.
Ports P30 and P31 are 2-bit I/O ports and have basically the same functions as port P0.
The output structure is CMOS output.
Ports P32, P33, P34 and P35 are 4-bit input ports and ports P32 and P33 are in common
with external clock input pins of timers 2 and 3. Ports P34 and P35 are in common with
external interrupt input pins INT1 and INT2. Port P35 is in common with an input pin of A-D
comparator (A-D4).
Ports P40 and P41 are 2-bit I/O ports and have basically the same functions as port P0.
When serial I/O is used, ports P40 and P41 are in common with SOUT pin and SCLK pin, re-
spectively.
Port P42 is an 1-bit Input port, and it is common with an input pin of A-D comparator (A-D5)
and serial input pin (SIN).
Port P6 is an 4-bit output port. The output structure is N-channel open-drain. This port is in
common with 6-bit PWM output pins PWM0-PWM3.
This is the I/O pins of the clock generating circuit for the CRT display function.
This is the horizontal synchronizing signal input for CRT display.
This is the vertical synchronizing signal input for CRT display.
This is a 4-bit output pin for CRT display. The output structure is CMOS output. This is in
common with port P52 – P55.
This is an output pin for 14-bit PWM.
相關PDF資料 |
PDF描述 |
|---|---|
| M37210M3-XXXSP | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP52 |
| M37212EF-XXXFP | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP80 |
| M37212EF-XXXSP | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP52 |
| M37221M6-XXXSP | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42 |
| M37224M3-XXXSP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP42 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37211M2 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER |
| M37211M2-011SP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER |
| M37211M2-505SP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER |
| M37211M2-526SP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER |
| M37211M2-527SP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。