參數資料
型號: M37150MF-XXXFP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 8.95 MHz, MICROCONTROLLER, PDSO42
封裝: 0.450 INCH, 0.80 MM PITCH, PLASTIC, SSOP-42
文件頁數: 93/142頁
文件大?。?/td> 1712K
代理商: M37150MF-XXXFP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
MITSUBISHI MICROCOMPUTERS
M37150M6/M8/MA/MC/MF-XXXFP, M37150EFFP
53
Rev. 1.0
8.10.2 Clamping Circuit and Low-pass Filter
The clamp circuit clamps the sync chip part of the composite video
signal input from the CVIN pin. The low-pass filter attenuates the noise
of the clamped composite video signal. The CVIN pin to which com-
posite video signal is input requires an external capacitor (0.1
F)
coupling. Pull down the CVIN pin with a resistor of hundreds of kilo-
ohms to 1 M
. In addition, we recommend installing a simple low-
pass filter externally, using a resistor and a capacitor at the CVIN pin
(refer to Figure 8.10.1).
8.10.3 Sync Slice Circuit
This circuit takes out a composite sync signal from the output signal
of the low-pass filter.
8.10.4 Synchronous Signal Separation Circuit
This circuit separates a horizontal synchronous signal and a vertical
synchronous signal from the composite sync signal taken out in the
sync slice circuit.
(1) Horizontal Synchronous Signal (Hsep)
A one-shot horizontal synchronizing signal Hsep is generated at
the falling edge of the composite sync signal.
(2) Vertical Synchronous Signal (Vsep)
As a Vsep signal generating method, it is possible to select one of
the following 2 methods by using bit 4 of data slicer control regis-
ter 2 (address 00E116).
Method 1
The LOW level width of the composite sync signal is
measured. If this width exceeds a certain time, a Vsep
signal is generated in synchronization with the rising
of the timing signal immediately after this LOW level.
Method 2
The LOW level width of the composite sync signal is
measured. If this width exceeds a certain time, it is
detected whether a falling of the composite sync sig-
nal exits or not in the LOW level period of the timing
signal immediately after this LOW level. If a falling
exists, a Vsep signal is generated in synchronization
with the rising of the timing signal (refer to Figure
8.10.6).
Figure 8.10.6 shows a Vsep generating timing. The timing signal shown
in the figure is generated from the reference clock which the timing
generating circuit outputs.
Reading bit 5 of data slicer control register 2 permits determinating
the shape of the V-pulse portion of the composite sync signal. As
shown in Figure 8.10.7, when the A level matches the B level, this bit
is “0.” In the case of a mismatch, the bit is “1.”
Fig. 8.10.6 Vsep Generating Timing (method 2)
Composite s
Timing
signal
Vsep signal
Measure LOW period
A Vsep signal is generated at a rising of the timing signal
immediately after the LOW level width of the composite
sync signal exceeds a certain time.
相關PDF資料
PDF描述
M37150MC-XXXFP 8-BIT, MROM, 8.95 MHz, MICROCONTROLLER, PDSO42
M37151MC-XXXFP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDSO42
M37151MF-XXXFP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDSO42
M37151M6-XXXFP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDSO42
M37151M8-XXXFP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDSO42
相關代理商/技術參數
參數描述
M37151 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
M37151EFFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
M37151EFSS 功能描述:DEV MCU/8BIT CMOS EMULATION CHIP RoHS:否 類別:編程器,開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像,彩色(RGB) 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP
M37151ERSS 制造商:Renesas Electronics Corporation 功能描述:DEV MCU/8BIT CMOS EMULATION CHIP - Bulk
M37151M6 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 8-BIT CMOS MICROCOMPUTER