- 您現在的位置：買賣IC網 > PDF目錄45006 > LX1552CD-TR (MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP) 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO14 PDF資料下載
參數資料
| 型號： | LX1552CD-TR |
| 廠商： | MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | ROHS COMPLIANT, PLASTIC, SOIC-14 |
| 文件頁數： | 5/18頁 |
| 文件大?。?/td> | 483K |
| 代理商： | LX1552CD-TR |
ULTRA-LOW START-UP CURRENT, CURRENT-MODE PWM
LX1552/3/4/5
PRODUCT D A T ABOOK 1996/1997
13
Copyright 1994
Rev. 1.0b
P RODUCTION
D ATA
S HEET
THEO R Y OF OPER A TION
VOLTAGE REFERENCE
The voltage reference is a low drift bandgap design which
provides +5.0V to supply charging current to the oscillator timing
capacitor, as well as supporting internal circuitries.
Initial
accuracy for all devices are specified at ±1% max., which is a 2x
improvement for the commercial product when compared to the
SG384x series. The reference is capable of providing in excess
of 20mA for powering any external control circuitries and has
built-in short circuit protection.
FIGURE 25 — SIMPLIFIED SCHEMATIC OF OSCILLATOR SECTION
OSCILLATOR
The oscillator circuit is designed such that discharge current and
valley voltage are trimmed independently. This results in more
accurate initial oscillator frequency and maximum output duty
cycle, especially important in LX1552/53 applications.
The
oscillator is programmed by the values selected for the timing
components (R
T) and (CT). A simplified schematic of the oscillator
is shown in Figure 25. The operation is as follows; Capacitor (C
T)
is charged from the 5V reference thru resistor (R
T) to a peak
voltage of 2.7V nominally.
Once the voltage reaches this
threshold, comparator (A1) changes state, causing (S1) to switch
to position (2) and (S2) to (V
V) position.
This will allow the
capacitor to discharge with a current equal to the difference
between a constant discharge current (I
D) and current through
charging resistor (I
R),
until the voltage drops down to 1V
nominally and the comparator changes state again, repeating the
cycle. Oscillator charge time results in the output to be in a high
state (on time) and discharge time sets it to a low state (off time).
Since the oscillator period is the sum of the charge and discharge
time, any variations in either of them will ultimately affect stability
of the output frequency and the maximum duty cycle. In fact, this
FIGURE 24 — REFERENCE VOLTAGE vs. TEMPERATURE
4.95
4.99
(T
A)
Ambient Temperature - (°C)
(V
REF
)
Voltage
-
(V)
4.97
5.00
4.96
5.01
5.02
4.98
-75
-50
-25
0
25
50
75
100
125
5.03
V
CC = 15V
I
L = 1mA
FIGURE 26 — DUTY CYCLE VARIATION vs. DISCHARGE CURRENT
20
60
(R
T)
Timing Resistor - ( )
100
Oscillator
Duty
Cycle
-
(%)
40
70
600
700
800
900
1000
T
A = 25°C
V
P = 2.7V
V = 1V
V
REF = 5V
30
80
90
50
I
d = 7.5mA
I
d = 8.0mA
I
d = 8.6mA
I
d = 9.3mA
SG384x Lower Limit
LX155x Limits
SG384x Upper Limit
C
T
R
T
I
R
REF
5V
R
T/CT
I
D = 8.3mA
2
1
OPEN
2.8V
1.1V
S2
V
P
V
S1
A1
TO OUTPUT
STAGE
variation is more pronounced when maximum duty cycle has to
be limited to 50% or less. This is due to the fact that for longer
output off time, capacitor discharge current (I
D - IR) must be
decreased by increasing I
R.
Consequently, this increases the
sensitivity of the frequency and duty cycle to any small variations
of the internal current source (I
D), making this parameter more
critical under those conditions. Because this is a desired feature
in many applications, this parameter is trimmed to a nominal
current value of 8.3±0.3mA at room temperature, and guaranteed
to a maximum range of 7.8 to 8.8mA over the specified ambient
temperature range. Figure 26 shows variation of oscillator duty
cycle versus discharge current for LX155x and SG384x series
devices.
相關PDF資料 |
PDF描述 |
|---|---|
| LX1553IDM-TR | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| LX1555CD-TR | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO14 |
| LX1552IDM-TR | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| LX1554CPW-TR | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LX1555CDM-TR | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LX1552CM | 功能描述:IC REG CTRLR BST FLYBK ISO 8-DIP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LX1552CPW | 功能描述:IC REG CTRLR PWM CM 20-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LX1552ID | 功能描述:IC REG CTRLR PWM CM 14-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LX1552IDM | 功能描述:IC REG CTRLR BST FLYBK ISO 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LX1552IM | 功能描述:IC REG CTRLR BST FLYBK ISO 8-DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。