參數資料
型號: LTC490CN8#PBF
廠商: Linear Technology
文件頁數: 10/12頁
文件大小: 0K
描述: IC TXRX RS485 LOW POWER 8-DIP
標準包裝: 50
類型: 收發器
驅動器/接收器數: 1/1
規程: RS422,RS485
電源電壓: 4.75 V ~ 5.25 V
安裝類型: 通孔
封裝/外殼: 8-DIP(0.300",7.62mm)
供應商設備封裝: 8-PDIP
包裝: 管件
產品目錄頁面: 1354 (CN2011-ZH PDF)
7
LTC490
490fb
less flexible, more bulky, and more costly than twisted
pairs. Many cable manufacturers offer a broad range of
120
cables designed for RS485 applications.
Losses in a transmission line are a complex combination
of DC conductor loss, AC losses (skin effect), leakage and
AC losses in the dielectric. In good polyethylene cables
such as the Belden 9841, the conductor losses and
dielectric losses are of the same order of magnitude,
leading to relatively low overall loss (Figure 7).
When using low loss cables, Figure 8 can be used as a
guideline for choosing the maximum line length for a given
data rate. With lower quality PVC cables, the dielectric loss
factor can be 1000 times worse. PVC twisted pairs have
APPLICATIO S I FOR ATIO
WU
UU
terrible losses at high data rates (>100kbs), and greatly
reduce the maximum cable length. At low data rates
however, they are acceptable and much more economical.
Cable Termination
The proper termination of the cable is very important.
If the cable is not terminated with its characteristic
impedance, distorted waveforms will result. In severe
cases, distorted (false) data and nulls will occur.
A quick look at the output of the driver will tell how well the
cable is terminated. It is best to look at a driver connected
to the end of the cable, since this eliminates the possibility
of getting reflections from two directions. Simply look at
the driver output while transmitting square wave data. If
the cable is terminated properly, the waveform will look
like a square wave (Figure 9). If the cable is loaded
excessively (47
), the signal initially sees the surge
impedance of the cable and jumps to an initial amplitude.
The signal travels down the cable and is reflected back out
of phase because of the mistermination. When the re-
flected signal returns to the driver, the amplitude will be
lowered. The width of the pedestal is equal to twice the
electrical length of the cable (about 1.5ns/foot). If the
Figure 7. Attenuation vs Frequency for Belden 9841
Figure 8. RS485 Cable Length Specification. Applies for 24
Gauge, Polyethylene Dielectric Twisted Pair
Figure 9. Termination Effects
FREQUENCY (MHz)
0.1
LOSS
PER
100
FT
(dB)
1.0
10
1.0
10
100
LTC490 F07
DATA RATE (bps)
10k
10
CABLE
LENGTH
(FT)
100
1k
10k
100k
1M
10M
LTC490 F08
2.5M
Rt
DRIVER
DX
RECEIVER
RX
Rt = 120
Rt = 47
Rt = 470
LTC490 F09
PROBE HERE
相關PDF資料
PDF描述
LTC1480CN8#PBF IC TXRX 3.3V RS485 LOWPWR 8-DIP
LT1081CN#PBF IC DVR/RCVR DUAL-RS232 5V 16-DIP
LT1785IS8#PBF IC TXRX RS485/RS422 60V 8-SOIC
KSZ8041TLI IC ETHERNET PHY IND 48-TQFP
KSZ8041FTLI TXRX PHY 10/100 SGL LP 48-TQFP
相關代理商/技術參數
參數描述
LTC490CS8 功能描述:IC TXRX RS485 LOW POWER 8-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC490CS8#PBF 功能描述:IC TXRX RS485 LOW POWER 8-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP(0.209",5.30mm 寬) 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2
LTC490CS8#TR 功能描述:IC TXRX RS485 LOW POWER 8-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC490CS8#TRPBF 功能描述:IC TXRX RS485 LOW POWER 8-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC490CS8PBF 制造商:Linear Technology 功能描述:LTC490CS8PBF