- 您現在的位置：買賣IC網 > PDF目錄44996 > LTC4267IGN-1 (LINEAR TECHNOLOGY CORP) 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LTC4267IGN-1 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SSOP-16 |
| 文件頁數： | 6/32頁 |
| 文件大小： | 925K |
| 代理商： | LTC4267IGN-1 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC4267-1
14
42671f
the LTC4267-1 will attempt to quickly charge capacitor C1
using an internal secondary current limit circuit. In this
scenario, the PSE current limit should provide the overall
limit for the circuit. For slower rising inputs, the 375mA
current limit in the LTC4267-1 will set the charge rate of
the capacitor C1. In either case, the
PWRGD signal may
go inactive briey while the capacitor is charged up to the
new line voltage. In the design of a PD, it is necessary
to determine if a step in the input voltage will cause the
PWRGD signal to go inactive and how to respond to this
event. In some designs, it may be desirable to lter the
PWRGD signal so that intermittent power bad conditions
are ignored. Figure 7 demonstrates a method to insert a
lowpass lter on the power good interface.
For PD designs that use a large load capacitor and also con-
sume a lot of power, it is important to delay activation of the
switching regulator with the
PWRGD signal. If the regulator
is not disabled during the current-limited turn-on sequence,
the PD circuitry will rob current intended for charging up
the load capacitor and create a slow rising input, possibly
causing the LTC4267-1 to go into thermal shutdown.
The
PWRGD pin connects to an internal open drain, 100V
transistor capable of sinking 1mA. Low impedance to
VPORTN indicates power is good. PWRGD is high imped-
ance during signature and classication probing and in
the event of a thermal overload. During turn-off,
PWRGD
is deactivated when the input voltage drops below 30V.
In addition,
PWRGD may go active briey at turn-on for
fast rising input waveforms.
PWRGD is referenced to the
VPORTN pin and when active, will be near the VPORTN po-
tential. Connect the
PWRGD pin to the switching regulator
circuitry as shown in Figure 7.
Figure 6. LTC4267-1 Power Good
APPLICATIO S I FOR ATIO
WU
UU
Figure 7. Power Good Interface Examples
PD Interface Thermal Protection
The LTC4267-1 PD Interface includes thermal overload
protection in order to provide full device functionality
in a miniature package while maintaining safe operating
temperatures. Several factors create the possibility of
signicant power dissipation within the LTC4267-1. At
turn-on, before the load capacitor has charged up, the
instantaneous power dissipated by the LTC4267-1 can be
as much as 10W. As the load capacitor charges up, the
power dissipation in the LTC4267-1 will decrease until it
reaches a steady-state value dependent on the DC load
current. The size of the load capacitor determines how fast
the power dissipation in the LTC4267-1 will subside. At
room temperature, the LTC4267-1 can typically handle load
capacitors as large as 800μF without going into thermal
shutdown. With large load capacitors, the LTC4267-1 die
temperature will increase by as much as 50°C during a
single turn-on sequence. If for some reason power were
removed from the part and then quickly reapplied so that
the LTC4267-1 had to charge up the load capacitor again,
the temperature rise would be excessive if safety precau-
tions were not implemented.
The LTC4267-1 PD interface protects itself from thermal
damage by monitoring the die temperature. If the die
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4267CGN-1 | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC4270BIUKG#TRPBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
| LTC4270BIUKG#PBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
| LTC4270AIUKG#TRPBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
| LTC4270AIUKG#PBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4267IGN-1#PBF | 功能描述:IC POE 802.3AF 16-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
| LTC4267IGN-1#TRPBF | 功能描述:IC POE 802.3AF INTERFACE 16SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
| LTC4267IGN-1-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power over Ethernet IEEE 802.3af PD Interface with Integrated Switching Regulator |
| LTC4267IGN-1-TR | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power over Ethernet IEEE 802.3af PD Interface with Integrated Switching Regulator |
| LTC4267IGN-1-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power over Ethernet IEEE 802.3af PD Interface with Integrated Switching Regulator |
發布緊急采購，3分鐘左右您將得到回復。