- 您現在的位置：買賣IC網 > PDF目錄44996 > LTC4267CGN-1 (LINEAR TECHNOLOGY CORP) 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LTC4267CGN-1 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SSOP-16 |
| 文件頁數： | 4/32頁 |
| 文件大?。?/td> | 925K |
| 代理商： | LTC4267CGN-1 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC4267-1
12
42671f
Classication
Once the PSE has detected a PD, the PSE may option-
ally classify the PD. Classication provides a method for
more efcient allocation of power by allowing the PSE
to identify lower power PDs and allocate less power for
these devices. The IEEE 802.3af specication denes ve
classes (Table 2) with varying power levels. The designer
selects the appropriate classication based on the power
consumption of the PD. For each class, there is an as-
sociated load current that the PD asserts onto the line
during classication probing. The PSE measures the PD
load current to determine the proper classication and
PD power requirements.
During classication (Figure 4), the PSE presents a xed
voltage between –15.5V and –20.5V to the PD. With the
input voltage in this range, the LTC4267-1 asserts a load
current from the VPORTP pin through the RCLASS resistor.
The magnitude of the load current is set by the RCLASS
resistor. The resistor values associated with each class are
shown in Table 2. Note that the switching regulator will
not interfere with the classication measurement since the
LTC4267-1 has not passed power to the regulator.
Table 2. Summary of IEEE 802.3af Power Classications and
LTC4267-1 RCLASS Resistor Selection
Class
Usage
Maximum
Power Levels
at Input of PD
(W)
Nominal
Classication
Load Current
(mA)
LTC4267-1
RCLASS
Resistor
(
Ω, 1%)
0
Default
0.44 to 12.95
<5
Open
1
Optional
0.44 to 3.84
10.5
124
2
Optional
3.84 to 6.49
18.5
68.1
3
Optional
6.49 to 12.95
28
45.3
4
Reserved
Reserved*
40
30.9
*Class 4 is currently reserved and should not be used.
The IEEE 802.3af specication limits the classication
time to 75ms because a signicant amount of power is
dissipated in the PD. The LTC4267-1 is designed to handle
the power dissipation for this time period. If the PSE prob-
ing exceeds 75ms, the LTC4267-1 may overheat. In this
situation, the thermal protection circuit will engage and
disable the classication current source in order to protect
the part. The LTC4267-1 stays in classication mode until
the input voltage rises above the UVLO turn-on voltage.
VPORTN Undervoltage Lockout
The IEEE specication dictates a maximum turn-on voltage
of 42V and a minimum turn-off voltage of 30V for the PD.
In addition, the PD must maintain large on-off hysteresis to
prevent resistive losses in the wiring between the PSE and
the PD from causing start-up oscillation. The LTC4267-1
incorporates an undervoltage lockout (UVLO) circuit that
monitors the line voltage at VPORTN to determine when
to apply power to the integrated switching regulator
(Figure 5). Before the power is applied to the switching
regulator, the POUT pin is high impedance and sitting at
the ground potential since there is no charge on capacitor
C1. When the input voltage rises above the UVLO turn-on
threshold, the LTC4267-1 removes the detection and clas-
sication loads and turns on the internal power MOSFET.
C1 charges up under the LTC4267-1 current limit control
and the POUT pin transitions from 0V to VPORTN. This
sequence is shown in Figure 1. The LTC4267-1 includes
a hysteretic UVLO circuit on VPORTN that keeps power
applied to the load until the input voltage falls below the
UVLO turn-off threshold. Once the input voltage drops
below –30V, the internal power MOSFET is turned off and
Figure 4. IEEE 802.3af Classication Probing
APPLICATIO S I FOR ATIO
WU
UU
Figure 3. 25k Signature Resistor with Disable
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4270BIUKG#TRPBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
| LTC4270BIUKG#PBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
| LTC4270AIUKG#TRPBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
| LTC4270AIUKG#PBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
| LTC4274CIUHF#PBF | POWER SUPPLY MANAGEMENT CKT, PQCC38 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4267CGN-1#PBF | 功能描述:IC POE 802.3AF INTERFACE 16SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
| LTC4267CGN-1#TRPBF | 功能描述:IC POE 802.3AF INTERFACE 16SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
| LTC4267CGN-1-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power over Ethernet IEEE 802.3af PD Interface with Integrated Switching Regulator |
| LTC4267CGN-1-TR | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power over Ethernet IEEE 802.3af PD Interface with Integrated Switching Regulator |
| LTC4267CGN-1-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power over Ethernet IEEE 802.3af PD Interface with Integrated Switching Regulator |
發布緊急采購，3分鐘左右您將得到回復。