- 您現在的位置：買賣IC網 > PDF目錄44996 > LTC4071IMS8E#TRPBF (LINEAR TECHNOLOGY CORP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 PDF資料下載
參數資料
| 型號： | LTC4071IMS8E#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封裝： | LEAD FREE, PLASTIC, MSOP-8 |
| 文件頁數： | 17/18頁 |
| 文件大小： | 219K |
| 代理商： | LTC4071IMS8E#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁
LTC4071
8
4071fb
operaTion
In cases where the input supply may be shorted to GND
when not supplying power, for example with a solar cell,
add a diode in series with RIN to prevent the input from
loading the battery. For more information, refer to the
photovoltaic charger example in the Applications Infor-
mation section.
Adjustable Float Voltage, VFLOAT
A built-in 3-state decoder connected to the ADJ pin pro-
vides three programmable float voltages: 4.0V, 4.1V, or
4.2V. The float voltage is programmed to 4.0V when ADJ
is tied to GND, 4.1V when ADJ is floating (disconnected),
and 4.2V when ADJ is tied to VCC. The state of the ADJ
pin (and NTC pins) is sampled for about 36s about once
every 1.2 seconds when HBO is high, and when HBO is
low the sampling rate reduces to about once every 3.6
seconds with the same duty cycle. If VCC falls below
VLBD, the sampling stops. When it is being sampled, the
LTC4071 applies a relatively low impedance voltage at the
ADJ pin. This technique prevents low level board leakage
from corrupting the programmed float voltage.
NTC Qualified Float Voltage, VFLOAT(NTC)
The NTC pin voltage is compared against an internal
resistor divider tied to the NTCBIAS pin. This divider has
tap points that are matched to the NTC thermistor resis-
tance/temperature conversion table for a Vishay curve 2
thermistorattemperaturesof40°C,50°C,60°C,and70°C.
The curve 2 thermistor is also designated by a B25/85
value of 3490.
Battery temperature conditioning adjusts the float voltage
down to VFLOAT_EFF when the NTC thermistor indicates
that the battery temperature is too high. For a 10k curve 2
thermistoranda10kNTCBIASresistor,each10°Cincrease
in temperature above 40°C causes the float voltage to drop
by a fixed amount, VFLOAT(NTC),dependingonADJ.IfADJ
is at GND, the float voltage steps down by 50mV for each
10°Ctemperatureincrement.IfADJisfloating,thestepsize
is 75mV. And if ADJ is at VCC, the step size is 100mV. Refer
to Table 1 for the range of VFLOAT_EFF programming.
Table 1. NTC Qualified Float Voltage
ADJ
VFLOAT(NTC) TEMPERATURE
VNTC AS % OF
NTCBIAS
VFLOAT_EFF
GND
50mV
T < 40°C
40°C ≤ T < 50°C
50°C ≤ T < 60°C
60°C ≤ T < 70°C
70°C < T
VNTC > 36.5
29.0 < VNTC ≤ 36.5
22.8 < VNTC ≤ 29.0
17.8 < VNTC ≤ 22.8
VNTC ≤ 17.8
4.000
3.950
3.900
3.850
3.800
Floating
75mV
T < 40°C
40°C ≤ T < 50°C
50°C ≤ T < 60°C
60°C ≤ T < 70°C
70°C < T
VNTC > 36.5
29.0 < VNTC ≤ 36.5
22.8 < VNTC ≤ 29.0
17.8 < VNTC ≤ 22.8
VNTC ≤ 17.8
4.100
4.025
3.950
3.875
3.800
VCC
100mV
T < 40°C
40°C ≤ T < 50°C
50°C ≤ T < 60°C
60°C ≤ T < 70°C
70°C < T
VNTC > 36.5
29.0 < VNTC ≤ 36.5
22.8 < VNTC ≤ 29.0
17.8 < VNTC ≤ 22.8
VNTC ≤ 17.8
4.200
4.100
4.000
3.900
3.800
For all ADJ pin settings the lowest float voltage setting is:
3.8V = VFLOAT_MIN = VFLOAT – 4 VFLOAT(NTC).
This occurs at NTC thermistor temperatures above 70°C,
or if the NTC pin is grounded.
To conserve power in the NTCBIAS and NTC resistors, the
NTCBIAS pin is sampled at a low duty cycle at the same
time that the ADJ pin state is sampled.
High Battery Status Output: HBO
The HBO pin pulls high when VCC rises to within VHBTH
of the programmed float voltage, VFLOAT_EFF, including
NTC qualified float voltage adjustments assuming VCC
has risen above VLBC_VCC.
If VCC drops below the float voltage by more than VHBTH +
VHBHY the HBO pin pulls low to indicate that the battery is
not at full charge. The input supply current to the LTC4071
drops to less than 550nA (typ) as the LTC4071 no longer
shunts current to protect the battery. And the NTCBIAS
sample clock slows to conserve power.
Forexample,iftheNTCthermistorrequiresthefloatvoltage
to be dropped by 100mV (ADJ = VCC and 0.29VNTCBIAS
< VNTC < 0.36VNTCBIAS) then the HBO rising threshold
is detected when VCC rises past:
VFLOAT – VFLOAT(NTC) – VHBTH
= 4.2V – 100mV – 40mV = 3.96V.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4071IDDB#TRMPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC4071EDDB#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC4097EDDB | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO12 |
| LTC4098EUDC-1#TRPBF | BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4098EPDC-1#PBF | BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4075 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Input USB/AC Adapter Standalone Li-Ion Battery Chargers |
| LTC4075EDD | 功能描述:IC CHARG BATT LI-ON USB 10DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC4075EDD#PBF | 功能描述:IC CHARG BATT LI-ON USB 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC4075EDD#TR | 功能描述:IC CHARG BATT LI-ON USB 10DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC4075EDD#TRPBF | 功能描述:IC CHARG BATT LI-ON USB 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。