- 您現在的位置：買賣IC網 > PDF目錄224115 > LTC4050EMS-4.1#TRPBF (LINEAR TECHNOLOGY CORP) Lithium-Ion Linear Battery Charger Controller with Thermistor Interface; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C PDF資料下載
參數資料
| 型號： | LTC4050EMS-4.1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | Lithium-Ion Linear Battery Charger Controller with Thermistor Interface; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C |
| 中文描述： | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
| 封裝： | PLASTIC, MSOP-10 |
| 文件頁數： | 2/12頁 |
| 文件大?。?/td> | 182K |
| 代理商： | LTC4050EMS-4.1#TRPBF |
10
LTC4050
4050f
If a PNP transistor is chosen as the pass transistor, a
1000pF capacitor is required from the DRV pin to VCC. This
capacitor is needed to help stabilize the voltage loop. A
10
F capacitor at the BAT pin is also recommended when
a battery is not present.
VCC Bypass Capacitor
Many types of capacitors can be used for input bypassing.
However, caution must be exercised when using multi-
layer ceramic capacitors. Because of the self resonant and
high Q characteristics of some types of ceramic capaci-
tors, high voltage transients can be generated under some
start-up conditions, such as connecting the charger input
to a hot power source. These transients can be minimized
by using X5R dielectric capacitors and/or by adding a 1.5
resistor in series with the ceramic input capacitor. For
more information, refer to Application Note 88.
Thermistor Interface
A thermistor connected to the NTC (negative temperature
coefficient) pin can be used to sense the battery tempera-
ture to determine if the battery is within an acceptable
temperature range for charging (between 0
°C and 50°C).
A Dale (curve 2) 10k thermistor is recommended although
many other types of thermistors can also be used. For
example, a BetaCHIP (curve 7) 10k thermistor or other 10k
thermistors with a room temperature beta of approxi-
mately 3400 will work well. The thermistor is connected
from NTC (pin 2) to ground and is biased up by an internal
28.6k trimmed thin film resistor that connects to VCC
through a P-channel MOSFET. This MOSFET also biases
an internal resistor string to ground, from which voltage
thresholds of approximately VCC/2 and VCC/8 are derived.
The NTC pin is compared to these thresholds by two
comparators that have wired-OR outputs. The thresholds
are selected such that an overtemperature condition will
occur when the thermistor resistance is less than approxi-
mately 4.1k and undertemperature condition will occur
when the thermistor resistance is greater than approxi-
mately 28.5k. These correspond to thermistor tempera-
tures of 50
°C and 0°C for the specific type of thermistor
listed above (many others will be close enough for most
purposes). The MOSFET is turned off during undervoltage
conditions, preventing the dividers that are biased from it
from drawing current from the battery when input power
is removed. The drop across the MOSFET is common to
both resistor dividers and does not cause any loss of
accuracy in the circuit. The comparators have approxi-
mately 10mV of hysteresis to prevent oscillations around
the trip points.
When an undertemperature or overtemperature condition
is sensed, the current amplifier pulldown is disabled and
DRV is pulled high, the timer is placed in a hold condition
with the count frozen until the battery temperature is
within an acceptable range. The end-of-charge compara-
tor is also disabled to prevent a premature end of charge
signal due to the lack of battery charging current.
APPLICATIONS INFORMATION
WU
U
–
+
–
+
VCC
UV
28.6k
4050 AI
10k DALE
CURVE 2
NTC
THERMISTOR
TBAD
(TO CA,
EOC, TIMER)
2
NTC
NTC Interface Circuitry
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4050EMS-4.2#PBF | Lithium-Ion Linear Battery Charger Controller with Thermistor Interface; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C |
| LTC4052EMS8E-4.2#PBF | Lithium-Ion Battery Pulse Charger with Overcurrent Protection; Package: MSOP; No of Pins: 8; Temperature Range: -40°C to +125°C |
| LTC4052EMS8E-4.2#TRPBF | Lithium-Ion Battery Pulse Charger with Overcurrent Protection; Package: MSOP; No of Pins: 8; Temperature Range: -40°C to +125°C |
| LTC4053EDD-4.2#PBF | USB Compatible Lithium-Ion Battery Charger with Thermal Regulation; Package: DFN; No of Pins: 10; Temperature Range: -40°C to +125°C |
| LTC4053EMSE-4.2#PBF | USB Compatible Lithium-Ion Battery Charger with Thermal Regulation; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4052 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:150mA Standalone Linear Li-Ion Battery Charger in ThinSOT |
| LTC4052-4.2 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Lithium-Ion Battery Pulse Charger with Overcurrent Protection |
| LTC4052-42 | 制造商:LINEAR 制造商全稱:LINEAR 功能描述:Lithium-Ion Battery Pulse Charger with Overcurrent Protection |
| LTC4052EMS8E-4.2 | 功能描述:IC CHARGER PULSE LI-ION 8-MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC4052EMS8E-4.2#PBF | 功能描述:IC CHARGER PULSE LI-ION 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
發布緊急采購，3分鐘左右您將得到回復。