- 您現在的位置：買賣IC網 > PDF目錄224115 > LTC4008EGN-1#TRPBF (LINEAR TECHNOLOGY CORP) 4A, High Efficiency, Multi-Chemistry Battery Charger; Package: SSOP; No of Pins: 20; Temperature Range: -40°C to +125°C PDF資料下載
參數資料
| 型號： | LTC4008EGN-1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 4A, High Efficiency, Multi-Chemistry Battery Charger; Package: SSOP; No of Pins: 20; Temperature Range: -40°C to +125°C |
| 中文描述： | BATTERY CHARGE CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-20 |
| 文件頁數： | 7/24頁 |
| 文件大?。?/td> | 221K |
| 代理商： | LTC4008EGN-1#TRPBF |
LTC4008
15
4008fb
APPLICATIONS INFORMATION
The relatively high ESR of an aluminum electrolytic for
C1, located at the AC adapter input terminal, is helpful
in reducing ringing during the hot-plug event. Refer to
Application Note 88 for more information.
Highest possible voltage rating on the capacitor will
minimize problems. Consult with the manufacturer before
use. Alternatives include high capacity ceramic (at least
20μF) from Tokin, United Chemi-Con/Marcon, et al. Other
alternative capacitors include OS-CON capacitors from
Sanyo.
The output capacitor (C3) is also assumed to absorb
output switching current ripple. The general formula for
capacitor current is:
I
V
Lf
RMS
BAT
DCIN
=
()
()( )
029
1
.–
For example:
VDCIN = 19V, VBAT = 12.6V, L1 = 10μH, and
f = 300kHz, IRMS = 0.41A.
EMI considerations usually make it desirable to minimize
ripple current in the battery leads, and beads or inductors
may be added to increase battery impedance at the 300kHz
switchingfrequency.Switchingripplecurrentsplitsbetween
the battery and the output capacitor depending on the ESR
of the output capacitor and the battery impedance. If the
ESR of C3 is 0.2Ω and the battery impedance is raised to
4Ω with a bead or inductor, only 5% of the current ripple
will ow in the battery.
Inductor Selection
Higher operating frequencies allow the use of smaller
inductor and capacitor values. A higher frequency gener-
ally results in lower efciency because of MOSFET gate
charge losses. In addition, the effect of inductor value
on ripple current and low current operation must also be
considered. The inductor ripple current
ΔILdecreaseswith
higher frequency and increases with higher VIN.
Δ= ()( )
I
fL
V
L
OUT
IN
1
1–
Accepting larger values of
ΔIL allows the use of low
inductances, but results in higher output voltage ripple
and greater core losses. A reasonable starting point for
setting ripple current is
ΔIL = 0.4(IMAX). In no case should
ΔIL exceed 0.6(IMAX) due to limits imposed by IREV and
CA1. Remember the maximum
ΔIL occurs at the maxi-
mum input voltage. In practice 10μH is the lowest value
recommended for use.
Lower charger currents generally call for larger inductor
values. Use Table 4 as a guide for selecting the correct
inductor value for your application.
Table 4
MAXIMUM AVERAGE
CURRENT (A)
INPUT
VOLTAGE (V)
MINIMUM INDUCTOR
VALUE (μH)
1
≤20
40 ±20%
1
>20
56 ±20%
2
≤20
20 ±20%
2
>20
30 ±20%
3
≤20
15 ±20%
3
>20
20 ±20%
4
≤20
10 ±20%
4
>20
15 ±20%
Charger Switching Power MOSFET
and Diode Selection
Two external power MOSFETs must be selected for use
with the charger: a P-channel MOSFET for the top (main)
switch and an N-channel MOSFET for the bottom (syn-
chronous) switch.
The peak-to-peak gate drive levels are set internally. This
voltage is typically 6V. Consequently, logic-level threshold
MOSFETs must be used. Pay close attention to the BVDSS
specication for the MOSFETs as well; many of the logic
level MOSFETs are limited to 30V or less.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4010CFE#PBF | High Efficiency Standalone Nickel Battery Charger; Package: TSSOP; No of Pins: 16; Temperature Range: 0°C to +70°C |
| LTC4010CFE#TRPBF | High Efficiency Standalone Nickel Battery Charger; Package: TSSOP; No of Pins: 16; Temperature Range: 0°C to +70°C |
| LTC4011CFE#PBF | High Efficiency Standalone Nickel Battery Charger; Package: TSSOP; No of Pins: 16; Temperature Range: 0°C to +70°C |
| LTC4011CFE#TRPBF | High Efficiency Standalone Nickel Battery Charger; Package: TSSOP; No of Pins: 16; Temperature Range: 0°C to +70°C |
| LTC4050EMS-4.1#PBF | Lithium-Ion Linear Battery Charger Controller with Thermistor Interface; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4008EGNPBF | 制造商:Linear Technology 功能描述:4A, High Eff Li-Ion Charger LTC4008EGN |
| LTC4009 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Voltage High Current Controller for Battery Charging and Power Management |
| LTC4009-1 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Effi ciency, Multi-Chemistry Battery Charger |
| LTC4009-2 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Effi ciency, Multi-Chemistry Battery Charger |
| LTC4009CUF#PBF | 功能描述:IC CHARGER BATTERY MC 20-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
發布緊急采購，3分鐘左右您將得到回復。