- 您現在的位置：買賣IC網 > PDF目錄44994 > LTC3851AHMSE#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO16 PDF資料下載
參數資料
| 型號： | LTC3851AHMSE#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO16 |
| 封裝： | LEAD FREE, PLASTIC, MSOP-16 |
| 文件頁數： | 29/30頁 |
| 文件大小： | 430K |
| 代理商： | LTC3851AHMSE#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁
LTC3851A
8
3851afa
pin FuncTions (GN and MSE/UD)
MODE/PLLIN (Pin 1/Pin 15): Forced Continuous Mode,
Burst Mode or Pulse-Skipping Mode Selection Pin and Ex-
ternalSynchronizationInputtoPhaseDetectorPin.Connect
this pin to INTVCC to force continuous conduction mode
of operation. Connect to GND to enable pulse-skipping
mode of operation. To select Burst Mode operation, tie
this pin to INTVCC through a resistor no less than 50k,
but no greater than 250k. A clock on the pin will cause
the controller to operate in forced continuous mode of
operation and synchronize the internal oscillator.
FREQ/PLLFLTR (Pin 2/Pin 16): The phase-locked loop’s
lowpass filter is tied to this pin. Alternatively, a resistor
can be connected between this pin and GND to vary the
frequency of the internal oscillator.
RUN (Pin 3/Pin 1): Run Control Input. A voltage above
1.22V on this pin turns on the IC. However, forcing this
pin below 1.1V causes the IC to shut down the IC. There
is a 2μA pull-up current on this pin.
TK/SS(Pin4/Pin2):OutputVoltageTrackingandSoft-Start
Input. A capacitor to ground at this pin sets the ramp rate
for the output voltage. An internal soft-start current of of
1μA charges this capacitor.
ITH (Pin 5/Pin 3): Current Control Threshold and Error
Amplifier Compensation Point. The current comparator
tripping threshold increases with its ITH control voltage.
FB (Pin 6/Pin 4): Error Amplifier Feedback Input. This pin
receives the remotely sensed feedback voltage from an
external resistive divider across the output.
SENSE–(Pin7/Pin5):CurrentSenseComparatorInverting
Input.The(–)inputtothecurrentcomparatorisconnected
to the output.
SENSE+ (Pin 8/Pin 6): Current Sense Comparator Non-
inverting Input. The (+) input to the current comparator
is normally connected to the DCR sensing network or
current sensing resistor.
ILIM (Pin 9/Pin 7): Current Comparator Sense Voltage
Range Input. Tying this pin to GND, FLOAT or INTVCC
selects the maximum current sense threshold from three
different levels.
GND (Pin 10/Pin 8, Exposed Pad Pin 17): Ground. All
small-signal components and compensation components
shouldbeKelvinconnectedtothisground.The(–)terminal
of CVCC and the (–) terminal of CIN should be closely con-
nected to this pin. The exposed pad should be soldered
to ground for good thermal conductivity.
BG (Pin 11/Pin 9): Bottom Gate Driver Output. This pin
drives the gate of the bottom N-channel MOSFET between
GND and INTVCC.
INTVCC(Pin12/Pin10):Internal5VRegulatorOutput.The
control circuit is powered from this voltage. Decouple this
pin to GND with a minimum 2.2μF low ESR tantalum or
ceramic capacitor.
VIN (Pin 13/Pin 11): Main Input Supply. Decouple this pin
to GND with a capacitor.
BOOST (Pin 14/Pin 12): Boosted Floating Driver Supply.
The (+) terminal of the boost-strap capacitor is connected
to this pin. This pin swings from a diode voltage drop
below INTVCC up to VIN + INTVCC.
TG (Pin 15/Pin 13): Top Gate Driver Output. This is the
output of a floating driver with a voltage swing equal to
INTVCC superimposed on the switch node voltage.
SW (Pin 16/Pin 14): Switch Node Connection to the In-
ductor. Voltage swing at this pin is from a Schottky diode
(external) voltage drop below ground to VIN.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3851AIMSE#PBF | SWITCHING REGULATOR, PDSO16 |
| LTC3851AMPMSE#TRPBF | SWITCHING REGULATOR, PDSO16 |
| LTC3851AEMSE#PBF | SWITCHING REGULATOR, PDSO16 |
| LTC3851EUD-1#PBF | 0.05 A SWITCHING CONTROLLER, 530 kHz SWITCHING FREQ-MAX, PQCC16 |
| LTC3851EMSE-1#PBF | 0.05 A SWITCHING CONTROLLER, 530 kHz SWITCHING FREQ-MAX, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3851AIGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851AIGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851AIMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851AIMSE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851AIMSE-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。