- 您現在的位置：買賣IC網 > PDF目錄44992 > LTC3588IDD-1#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO10 PDF資料下載
參數資料
| 型號： | LTC3588IDD-1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO10 |
| 封裝： | 3 X 3 MM, LEAD FREE, PLASTIC, MO-229WEED-2, DFN-10 |
| 文件頁數： | 20/20頁 |
| 文件大?。?/td> | 391K |
| 代理商： | LTC3588IDD-1#TRPBF |
LTC3588-1
9
35881fa
OPERATION
UVLO falling threshold before the output voltage reaches
regulation, the buck converter will shut off and will not
be turned on until the input voltage again rises above the
UVLO rising threshold. During this time the output voltage
will be loaded by less than 100nA. When the buck brings
the output voltage into regulation the converter enters a
low quiescent current sleep state that monitors the output
voltage with a sleep comparator. During this operating mode
load current is provided by the buck output capacitor. When
the output voltage falls below the regulation point the buck
regulator wakes up and the cycle repeats. This hysteretic
method of providing a regulated output reduces losses
associated with FET switching and maintains an output
at light loads. The buck delivers a minimum of 100mA of
average load current when it is switching.
When the sleep comparator signals that the output has
reached the sleep threshold the buck converter may be
in the middle of a cycle with current still owing through
the inductor. Normally both synchronous switches would
turn off and the current in the inductor would freewheel
to zero through the NMOS body diode. The LTC3588-1
keeps the NMOS switch on during this time to prevent the
conduction loss that would occur in the diode if the NMOS
were off. If the PMOS is on when the sleep comparator
trips the NMOS will turn on immediately in order to ramp
down the current. If the NMOS is on it will be kept on until
the current reaches zero.
Though the quiescent current when the buck is switching
is much greater than the sleep quiescent current, it is still
a small percentage of the average inductor current which
results in high efciency over most load conditions. The
buck operates only when sufcient energy has been ac-
cumulated in the input capacitor and the length of time the
converter needs to transfer energy to the output is much
less than the time it takes to accumulate energy. Thus, the
buck operating quiescent current is averaged over a long
period of time so that the total average quiescent current
is low. This feature accommodates sources that harvest
small amounts of ambient energy.
Four selectable voltages are available by tying the output
select bits, D0 and D1, to GND or VIN2. Table 1 shows
the four D0/D1 codes and their corresponding output
voltages.
Table 1. Output Voltage Selection
D1
D0
VOUT
VOUT QUIESCENT CURRENT (IVOUT)
0
1.8V
44nA
0
1
2.5V
62nA
1
0
3.3V
81nA
1
3.6V
89nA
The internal feedback network draws a small amount of
current from VOUT as listed in Table 1.
Power Good Comparator
A power good comparator produces a logic high referenced
to VOUT on the PGOOD pin the rst time the converter
reaches the sleep threshold of the programmed VOUT,
signaling that the output is in regulation. The PGOOD pin
will remain high until VOUT falls to 92% of the desired
regulation voltage. Several sleep cycles may occur during
this time. Additionally, if PGOOD is high and VIN falls below
the UVLO falling threshold, PGOOD will remain high until
VOUT falls to 92% of the desired regulation point. This
allows output energy to be used even if the input is lost.
Figure 2 shows the behavior for VOUT = 3.6V and no load.
At t = 75s VIN becomes high impedance and is discharged
by the quiescent current of the LTC3588-1 and through
servicing VOUT which is discharged by its own leakage
current. VIN crosses UVLO falling but PGOOD remains high
until VOUTdecreasesto92%ofthedesiredregulationpoint.
The PGOOD pin is designed to drive a microprocessor or
other chip I/O and is not intended to drive higher current
loads such as an LED.
TIME (s)
0
VOL
TAGE
(V)
6
3
4
5
2
1
0
200
100
35881 F02
300
VIN
VIN = UVLO FALLING
VOUT
PGOOD
CVIN = CVOUT = 100μF
Figure 2. PGOOD Operation During Transition to UVLO
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3588EDD-1#TRPBF | SWITCHING REGULATOR, PDSO10 |
| LTC3608IWKG#TRPBF | 8 A SWITCHING REGULATOR, PQCC52 |
| LTC3610IWP#TR | SWITCHING REGULATOR, PQCC64 |
| LTC3610IWP | SWITCHING REGULATOR, PQCC64 |
| LTC3610IWP#TRPBF | SWITCHING REGULATOR, PQCC64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3588IDD-2#PBF | 功能描述:IC ENERGY HARVESTING PSU 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3588IDD-2#TRPBF | 功能描述:IC ENERGY HARVESTING PSU 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3588IMSE-1#PBF | 功能描述:IC ENERGY HARVESTING PSU 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:熱電冷卻器 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.173"，4.40mm 寬）裸露焊盤 供應商設備封裝:28-TSSOP 裸露焊盤 包裝:管件 產品目錄頁面:1410 (CN2011-ZH PDF) |
| LTC3588IMSE-1#PBF | 制造商:Linear Technology 功能描述:PIEZOELECTRIC ENERGY HARVESTING POWER SU |
| LTC3588IMSE-1#TRPBF | 功能描述:IC ENERGY HARVESTING PSU 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
發布緊急采購，3分鐘左右您將得到回復。