- 您現在的位置：買賣IC網 > PDF目錄44991 > LTC3547BEDDB (LINEAR TECHNOLOGY CORP) 0.7 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | LTC3547BEDDB |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.7 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 3 X 2 MM, 0.75 MM HEIGHT, PLASTIC, M0-229WECD-1, DFN-8 |
| 文件頁數： | 14/16頁 |
| 文件大?。?/td> | 270K |
| 代理商： | LTC3547BEDDB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁
LTC3547B
7
3547bfa
OPERATIO
U
The LTC3547B uses a constant-frequency current mode
architecture. The operating frequency is set at 2.25MHz.
Both channels share the same clock and run in-phase.
The output voltage is set by an external resistor divider
returned to the VFB pins. An error amplier compares the
divided output voltage with a reference voltage of 0.6V and
regulates the peak inductor current accordingly.
Main Control Loop
During normal operation, the top power switch (P-channel
MOSFET) is turned on at the beginning of a clock cycle
when the VFB voltage is below the reference voltage. The
current into the inductor and the load increases until the
peak inductor current (controlled by ITH) is reached. The
RS latch turns off the synchronous switch and energy
stored in the inductor is discharged through the bottom
switch (N-channel MOSFET) into the load until the next
clock cycle begins, or until the inductor current begins to
reverse (sensed by the IRCMP comparator).
The peak inductor current is controlled by the internally
compensated ITH voltage, which is the output of the er-
ror amplier. This amplier regulates the VFB pin to the
internal 0.6V reference by adjusting the peak inductor
current accordingly.
At very low load currents, the LTC3547B automatically
transitions from constant frequency operation to discon-
tinuous operation, where the regulator begins skipping
pulses. Even though the total power loss decreases with
load, the efciency of the switching regulator will drop,
because the power delivered to the output becomes very
small. For applications where light load efciency is a
priority, consider using the LTC3547 instead.
Dropout Operation
When the input supply voltage decreases toward the out-
put voltage the duty cycle increases to 100%, which is the
dropout condition. In dropout, the PMOS switch is turned
on continuously with the output voltage being equal to the
input voltage minus the voltage drops across the internal
P-channel MOSFET and the inductor.
An important design consideration is that the RDS(ON)
of the P-channel switch increases with decreasing input
supply voltage (see Typical Performance Characteristics).
Therefore, the user should calculate the worst-case power
dissipation when the LTC3547B is used at 100% duty cycle
with low input voltage (see Thermal Considerations in the
Applications Information Section).
Soft-Start
In order to minimize the inrush current on the input by-
pass capacitor, the LTC3547B slowly ramps up the output
voltage during start-up. Whenever the RUN1 or RUN2 pin is
pulled high, the corresponding output will ramp from zero
to full-scale over a time period of approximately 650s. This
prevents the LTC3547B from having to quickly charge the
output capacitor and thus supplying an excessive amount
of instantaneous current.
Short-Circuit Protection
When either regulator output is shorted to ground, the
corresponding internal N-channel switch is forced on for
a longer time period for each cycle in order to allow the
inductor to discharge, thus preventing current runaway.
This technique has the effect of decreasing switching
frequency. Once the short is removed, normal operation
resumes and the regulator output will return to its nominal
voltage.
(Refer to Functional Diagram )
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3549EDCB#TRM | 0.6 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3549EDCB#TR | 0.6 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3553EUD#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| LTC3553EUD#PBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| LTC3554EPD#TRPB | 0.5 A BATTERY CHARGE CONTROLLER, 1295 kHz SWITCHING FREQ-MAX, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3547BEDDB#PBF | 制造商:Linear Technology 功能描述:BUCK 2.5 - 5.5V 0.3A 2.25MH |
| LTC3547BEDDB#TRMPBF | 功能描述:IC REG BUCK SYNC ADJ .3A DL 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC3547BEDDB#TRPBF | 功能描述:IC REG BUCK SYNC ADJ .3A DL 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC3547BEDDB-1#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 2.5V to 5.5V 8-Pin DFN EP |
| LTC3547BEDDB-1#TRMPBF | 功能描述:IC REG BUCK SYNC ADJ .3A DL 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
發布緊急采購，3分鐘左右您將得到回復。