參數資料
型號: LTC3543EDCB#PBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 1.3 A SWITCHING REGULATOR, 2250 kHz SWITCHING FREQ-MAX, PDSO6
封裝: 2 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, MO-229, DFN-6
文件頁數: 7/20頁
文件大小: 329K
代理商: LTC3543EDCB#PBF
LTC3543
15
3543fa
Checking Transient Response
The regulator loop response can be checked by looking
at the load transient response. Switching regulators take
several cycles to respond to a step in load current. When
a load step occurs, VOUT immediately shifts by an amount
equal to (
ΔILOAD ESR), where ESR is the effective series
resistance of COUT.
ΔILOAD also begins to charge or dis-
charge COUT, which generates a feedback error signal.
The regulator loop then acts to return VOUT to its steady
state value. During this recovery time, VOUT can be moni-
tored for overshoot or ringing that would indicate a stability
problem. For a detailed explanation of the switching control
loop theory, see Application Note 76.
A second, more severe transient is caused by switching
in loads with large (>1μF) supply bypass capacitors. The
discharged bypass capacitors are effectively put in paral-
lel with COUT, causing a rapid drop in VOUT. No regulator
can deliver enough current to prevent this problem if the
load switch resistance is low and it is driven quickly. The
only solution is to limit the rise time of the switch drive
so that the load rise time is limited to approximately
25 CLOAD. Thus, a 10μF capacitor charging to 3.3V would
require a 250μs rise time, limiting the charging current
to about 130mA.
PC Board Layout Checklist
When laying out the printed circuit board, the follow-
ing checklist should be used to ensure proper opera-
tion of the LTC3543. These items are also illustrated
graphically in Figures 5 and 6. Check the following in
your layout:
1. The power traces, consisting of the GND trace, the SW
trace, and the VIN trace should be kept short, direct
and wide.
2. Does the VFB pin connect directly to the feedback volt-
age reference? Ensure that there is no load current
running from the feedback reference voltage and the
VFB pin.
3. Does the (+) plate of CIN connect to VIN as closely as
possible? This capacitor provides the AC current to the
internal power MOSFETs.
4. Keep the switching node, SW, away from the sensitive
VFB node.
5. Keep the (–) plates of CIN and COUT as close as pos-
sible.
APPLICATIONS INFORMATION
4
5
6
3
2
1
R1
R2
SW
VIN
VFB
MODE
RUN
CFWD
CIN
C1
GND
L
VIN
CAP
VOUT
COUT
3543 F05
+–
+
+
+–
Figure 5. LTC3543 Layout Diagram
相關PDF資料
PDF描述
LTC3543EDCB#TRM 1.3 A SWITCHING REGULATOR, 2250 kHz SWITCHING FREQ-MAX, PDSO6
LTC3543EDCB 1.3 A SWITCHING REGULATOR, 2250 kHz SWITCHING FREQ-MAX, PDSO6
LTC3544BEUD#TR 0.8 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC16
LTC3544EUD 0.8 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC16
LTC3547BEDDB 0.7 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
LTC3544 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad Synchronous Step-Down Regulator: 2.25MHz, 300mA, 200mA, 200mA, 100mA
LTC3544B 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad Synchronous Step-Down Regulator: 2.25MHz, 300mA, 200mA, 200mA, 100mA
LTC3544BEUD 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad Synchronous Step-Down Regulator: 2.25MHz, 300mA, 200mA, 200mA, 100mA
LTC3544BEUD#PBF 功能描述:IC REG BUCK SYNC ADJ QUAD 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LTC3544BEUD#TRPBF 功能描述:IC REG BUCK SYNC ADJ QUAD 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤