- 您現在的位置：買賣IC網 > PDF目錄44991 > LTC3538EDCB (LINEAR TECHNOLOGY CORP) 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | LTC3538EDCB |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 2 X 3 MM, PLASTIC, DFN-8 |
| 文件頁數： | 2/16頁 |
| 文件大?。?/td> | 206K |
| 代理商： | LTC3538EDCB |
LTC3538
10
3538fb
During the period when the LTC3538 is delivering energy
to the output, the peak inductor current will be equal to
800mA typical and the inductor current will terminate
each cycle at zero current. In Burst Mode operation the
maximum average output current that can be delivered
while maintaining output regulation is given by:
I
OUT _ BURST(BOOST) = 0.25
V
IN
V
OUT
A; V
OUT > VIN
I
OUT _ BURST(BUCK) = 0.27A; VOUT < VIN
The maximum average Burst Mode output current that
can be delivered in the four-switch buck-boost region is
limited to the boost equation specied above.
INDUCTOR SELECTION
To achieve high efciency, a low ESR inductor should be
utilized for the converter. The inductor must have a satura-
tion rating greater than the worst case average inductor
current plus half the ripple current. The peak-to-peak cur-
rent ripple will be larger in buck and boost mode than in
the buck-boost region. The peak-to-peak inductor current
ripple for each mode can be calculated from the following
formulas, where f is the frequency (1MHz typical) and L
is the inductance in μH.
ΔIL,P-P,BUCK =
V
OUT VIN –VOUT
() /VIN
f L
A
ΔIL,P-P,BOOST =
V
OUT VOUT –VIN
() /VOUT
f L
A
where f = frequency (1MHz typical), Hz
L = inductor, H
OPERATION
In addition to affecting output current ripple, the size of the
inductor can also affect the stability of the feedback loop.
In boost mode, the converter transfer function has a right
half plane zero at a frequency that is inversely proportional
to the value of the inductor. As a result, a large inductor
can move this zero to a frequency low enough to degrade
the phase margin of the feedback loop. It is recommended
that the inductor value be chosen less than 10μH.
For high efciency, choose a ferrite inductor with a high
frequency core material to reduce core loses. The induc-
tor should have low ESR (equivalent series resistance) to
reduce the I2R losses, and must be able to handle the peak
inductor current without saturating. Molded chokes or chip
inductors usually do not have enough core to support the
peak inductor currents in the 1A to 2A region. To minimize
radiated noise, use a shielded inductor. See Table 1 for a
suggested list of inductor suppliers.
Output Capacitor Selection
The bulk value of the output lter capacitor is selected to
reduce the ripple due to charge into the capacitor each
cycle. The steady state ripple due to charge is given by:
ΔVP-P, BOOST = ILOAD (VOUT – VIN)/(COUT VOUT f)V
ΔVP-P,BUCK = (VIN – VOUT) VOUT/(8 L VIN COUT f
2)V
where COUT = output lter capacitor, F
ILOAD = Output load current, A
SUPPLIER
PHONE
FAX
WEB SITE
Coilcraft
(847) 639-6400
(847) 639-1469
www.coilcraft.com
CoEv Magnetics
(800) 227-7040
(650) 361-2508
www.tycoelectronics.com
Murata
(814) 237-1431
(800) 831-9172
(814) 238-0490
www.murata.com
Sumida
USA: (847) 956-0666
Japan: 81 (3) 3607-5111
USA: (847) 956-0702
Japan: 81(3) 3607-5144
www.sumida.com
TDK
(847) 803-6100
(847) 803-6296
www.component.tdk.com
TOKO
(847) 297-0070
(847) 699-7864
www.tokoam.com
Table 1. Inductor Vendor Information
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3538EDCB#TR | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3541EDD-2 | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3541EDD-2#TR | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3541EDD-3 | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3541EDD-3#TR | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3538EDCB#PBF | 制造商:Linear Technology 功能描述:DC-DC CONV BUCK/BOOST 8000mA DFN-8 制造商:Linear Technology 功能描述:DC-DC CONV, BUCK/BOOST, 8000mA, DFN-8 制造商:Linear Technology 功能描述:DC-DC CONV, BUCK/BOOST, 8000mA, DFN-8, Primary Input Voltage:5.5V, No. of Outputs:1, Output Current:800mA, No. of Pins:8, Operating Temperature Min:-40C, Operating Temperature Max:85C, MSL:MSL 1 - Unlimited, Package / Case:8-DFN , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-SWREG/Monolithic, Cut Tape 800mA, 1MHz Wide Input Voltage Synch Buck-Boost DC |
| LTC3538EDCB#TRMPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3538EDCB#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3538EDCB-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:800mA Synchronous Buck-Boost DC/DC Converter |
| LTC3538EDCB-TR | 制造商:LINER 制造商全稱:Linear Technology 功能描述:800mA Synchronous Buck-Boost DC/DC Converter |
發布緊急采購，3分鐘左右您將得到回復。