- 您現在的位置：買賣IC網 > PDF目錄44991 > LTC3535EDD#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO12 PDF資料下載
參數資料
| 型號： | LTC3535EDD#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO12 |
| 封裝： | 3 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, DFN-12 |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 249K |
| 代理商： | LTC3535EDD#PBF |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
LTC3535
12
3535f
VIN > VOUT OPERATION
The LTC3535 will maintain voltage regulation even when
the input voltage is above the desired output voltage. Note
that the efciency is much lower in this mode, and the
maximum output current capability will be less. Refer to
the Typical Performance Characteristics.
SHORT-CIRCUIT PROTECTION
The LTC3535 output disconnect feature allows output
short circuit while maintaining a maximum internally set
current limit. To reduce power dissipation under short-
circuit conditions, the peak switch current limit is reduced
to 400mA (typical per channel).
SCHOTTKY DIODE
Although not recommended, adding a Schottky diode from
SW to VOUT will improve efciency by about 2%. Note
that this defeats the output disconnect and short-circuit
protection features.
PCB LAYOUT GUIDELINES
The high speed operation of the LTC3535 demands careful
attention to board layout. A careless layout will result in
reduced performance. Figure 1 shows the recommended
component placement. A large ground pin copper area
will help to lower the die temperature. A multilayer board
with a separate ground plane is ideal, but not absolutely
necessary.
APPLICATIONS INFORMATION
Figure 1. Recommended Component Placement
COMPONENT SELECTION
Inductor Selection
The LTC3535 can utilize small surface mount chip induc-
tors due to their fast 1MHz switching frequency. Inductor
values between 3.3μH and 6.8μH are suitable for most
applications. Larger values of inductance will allow slightly
greater output current capability (and lower the Burst
Mode threshold) by reducing the inductor ripple current.
Increasing the inductance above 10μH will increase com-
ponent size while providing little improvement in output
current capability.
The minimum inductance value is given by:
L
VV
V
Ripple V
IN MIN
OUT MAX
IN MIN
OUT
>
()
(
)
()
(
–
M
MAX)
where:
Ripple = Allowable inductor current ripple (amps peak-
peak)
VIN(MIN) = Minimum input voltage
VOUT(MAX) = Maximum output voltage
The inductor current ripple is typically set for 20% to
40% of the maximum inductor current. High frequency
ferrite core inductor materials reduce frequency dependent
power losses compared to cheaper powdered iron types,
improving efciency. The inductor should have low ESR
(series resistance of the windings) to reduce the I2R power
losses, and must be able to support the peak inductor
current without saturating. Molded chokes and some chip
inductors usually do not have enough core area to support
the peak inductor current of 750mA seen on the LTC3535.
To minimize radiated noise, use a shielded inductor. See
Table 1 for suggested components and suppliers.
VIN2
VIN1
VOUT2
VOUT1
GND
SHDN
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3538EDCB#PBF | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB#TR | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3541EDD-2 | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3541EDD-2#TR | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3535EDD-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter |
| LTC3536EDD#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3536EDD#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3536EMSE#PBF | 功能描述:IC REG BUCK BST SYNC ADJ 12MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3536EMSE#TRPBF | 功能描述:IC REG BUCK BST SYNC ADJ 12MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。