- 您現在的位置：買賣IC網 > PDF目錄44991 > LTC3533EDE (LINEAR TECHNOLOGY CORP) 7 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO14 PDF資料下載
參數資料
| 型號： | LTC3533EDE |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 7 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | 4 X 3 MM, 0.75 MM HEIGHT, PLASTIC, MO-229WGED-3, DFN-14 |
| 文件頁數： | 2/16頁 |
| 文件大小： | 313K |
| 代理商： | LTC3533EDE |
LTC3533
10
3533f
OPERATION
For automatic operation a lter capacitor must also be
connected from BURST to ground. The equation for the
minimum capacitor value is:
C
CV
BURST MIN
OUT
()
,
≥
60 000
where CBURST(MIN) and COUT are in F.
In the event that a load transient causes FB to drop by
more than 4% from the regulation value while in Burst
Mode operation, the LTC3533 will immediately switch
to xed frequency mode and an internal pull-up will be
momentarily applied to BURST, rapidly charging CBURST.
This prevents the IC from immediately re-entering Burst
mode operation once the output achieves regulation.
Manual Burst Mode Operation
For manual control of Burst Mode operation, the RC
network connected to BURST can be eliminated. To force
xed frequency mode, BURST should be connected to
VIN. To force Burst Mode operation, BURST should be
grounded. When commanding Burst Mode operation
manually, the circuit connected to BURST should be able
to sink up to 2mA.
For optimum transient response with large dynamic loads,
the operating mode should be controlled digitally by the
host. By commanding xed frequency operation prior to a
sudden increase in load, output voltage droop can be mini-
mized. Note that if the load current applied during forced
Burst Mode operation (BURST pin is grounded) exceeds
the current that can be supplied, the output voltage will
start to droop and the LTC3533 will automatically come out
of Burst Mode operation and enter xed frequency mode,
raising VOUT. Once regulation is achieved, the LTC3533 will
then enter Burst Mode operation once again (since the user
is still commanding this by grounding BURST), and the
cycle will repeat, resulting in about 4% output ripple.
Burst Mode Operation to Fixed Frequency Transient
Response
In Burst Mode operation, the compensation network is
not used and VC is disconnected from the error amplier.
During long periods of Burst Mode operation, leakage
currents in the external components or on the PC board
could cause the compensation capacitor to charge (or
discharge), which could result in a large output transient
when returning to xed frequency mode of operation, even
at the same load current. To prevent this, the LTC3533
incorporates an active clamp circuit that holds the voltage
on VC at an optimal voltage during Burst Mode operation.
This minimizes any output transient when returning to
xed frequency mode operation. For optimum transient
response, Type 3 compensation is also recommended
to broad band the control loop and roll off past the two
pole response of the output LC lter. (See Closing the
Feedback Loop).
Soft-Start
The soft-start function is combined with shutdown. When
the RUN/SS pin is brought above 1V typical, the LTC3533
is enabled but the error amplier duty cycle is clamped
from VC. A detailed diagram of this function is shown in
Figure 3. The components RSS and CSS provide a slow
ramping voltage on RUN/SS to provide a soft-start function.
To ensure that VC is not being clamped, RUN/SS must be
raised above 1.6V.
VIN
VC
RUN/SS
3533 F03
Figure 3.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3535EDD#PBF | SWITCHING REGULATOR, PDSO12 |
| LTC3538EDCB#PBF | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB#TR | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3541EDD-2 | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3533EDE#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 14DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3533EDE#PBF | 制造商:Linear Technology 功能描述:DC/DC Converter IC |
| LTC3533EDE#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 14DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3533EDEPBF | 制造商:Linear Technology 功能描述:2A 1.8-5.5V Synch Buck-Boost DC/DC DFN14 |
| LTC3534 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:40V, 2A Synchronous Buck-Boost DC/DC |
發布緊急采購，3分鐘左右您將得到回復。