the source resistance seen by IN
參數資料
型號： LTC2430CGN#TRPBF
廠商： Linear Technology
文件頁數： 17/40頁
文件大?。?/td> 0K
描述： IC ADC 20BIT DIFFINPUT/REF16SSOP
標準包裝： 2,500
位數： 20
采樣率（每秒）： 7.5
數據接口： MICROWIRE?，串行，SPI?
轉換器數目： 2
功率耗散（最大）： 1mW
電壓電源： 單電源
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 16-SSOP（0.154"，3.90mm 寬）
供應商設備封裝： 16-SSOP
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分，雙極
LTC2430/LTC2431
24
24301f
The typical +FS and –FS errors as a function of the sum of
the source resistance seen by IN+ and IN– for large values
of CIN are shown in Figure 15.
In addition to this gain error, an offset error term may also
appear. The offset error is proportional with the mismatch
between the source impedance driving the two input pins
IN+ and IN– and with the difference between the input and
reference common mode voltages. While the input drive
circuit nonzero source impedance combined with the
converter average input current will not degrade the INL
performance, indirect distortion may result from the modu-
lation of the offset error by the common mode component
of the input signal. Thus, when using large CIN capacitor
values, it is advisable to carefully match the source imped-
ance seen by the IN+ and IN– pins. When FO = LOW
(internal oscillator and 60Hz notch), every 1
mismatch
in source impedance transforms a full-scale common
mode input signal into a differential mode input signal of
0.023ppm. When FO = HIGH (internal oscillator and 50Hz
notch), every 1
mismatch in source impedance trans-
forms a full-scale common mode input signal into a
differential mode input signal of 0.019ppm. When FO is
driven by an external oscillator with a frequency fEOSC,
every 1
mismatch in source impedance transforms a
full-scale common mode input signal into a differential
mode input signal of 0.15 10–6 fEOSCppm. Figure 16
shows the typical offset error due to input common mode
voltage for various values of source resistance imbalance
between the IN+ and IN– pins when large CIN values are
used.
If possible, it is desirable to operate with the input signal
common mode voltage very close to the reference signal
common mode voltage as is the case in the ratiometric
measurement of a symmetric bridge. This configuration
eliminates the offset error caused by mismatched source
impedances.
The magnitude of the dynamic input current depends upon
the size of the very stable internal sampling capacitors and
upon the accuracy of the converter sampling clock. The
accuracy of the internal clock over the entire temperature
and power supply range is typically better than 1%. Such
APPLICATIO S I FOR ATIO
WU
UU
Figure 15a. + FS Error vs RSOURCE at IN+ or IN– (Large CIN)
Figure 15b. – FS Error vs RSOURCE at IN
+ or IN– (Large CIN)
RSOURCE ()
0
+FS
ERROR
(ppm)
10
15
800
2431 F15a
5
0
200
400 500
1000
20
600
100
300
900
700
CIN = 0.01F
CIN = 0.1F
CIN = 1F, 10F
VCC = 5V
VREF+ = 5V
VREF– = GND
VIN+ = 3.75V
VIN– = 1.25V
FO = GND
TA = 25°C
RSOURCE ()
0
–
FS
ERROR
(ppm)
–10
–5
800
2431 F15b
–15
–20
200
400 500
1000
0
600
100
300
900
700
CIN = 0.01F
CIN = 0.1F
CIN = 1F, 10F
VCC = 5V
VREF+ = 5V
VREF– = GND
VIN+ = 1.25V
VIN– = 3.75V
FO = GND
TA = 25°C
Figure 16. Offset Error vs Common Mode Voltage
(VINCM = VIN+ = VIN–) and Input Source Resistance Imbalance
(
RIN = RSOURCEIN+ – RSOURCEIN–) for Large CIN Values (CIN ≥ 1F)
VINCM (V)
0
OFFSET
ERROR
(ppm)
0
20
4
–20
–40
1
2
2.5
5
40
A
B
C
D
E
F
G
3
0.5
1.5
4.5
3.5
VCC = 5V
VREF+ = 5V
VREF– = GND
VIN+ = VIN– = VINCM
FO = GND
RSOURCEIN– = 500
CIN = 10F
TA = 25°C
2431 F16
A:
RIN = +1k
B:
RIN = +500
C:
RIN = +200
D:
RIN = 0
E:
RIN = –200
F:
RIN = –500
G:
RIN = –1k
相關PDF資料
PDF描述
VI-B2P-IX-B1 CONVERTER MOD DC/DC 13.8V 75W
VI-B2P-IW-B1 CONVERTER MOD DC/DC 13.8V 100W
VI-B2M-IX-B1 CONVERTER MOD DC/DC 10V 75W
VI-B2M-IW-B1 CONVERTER MOD DC/DC 10V 100W
D38999/26WE26SBLC CONN HSG PLUG 26POS STRGHT SCKT
相關代理商/技術參數
參數描述
LTC2430IGN 功能描述:IC ADC 20BIT DIFFINPUT/REF16SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2430IGN#PBF 功能描述:IC ADC 20BIT DIFFINPUT/REF16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2430IGN#TR 功能描述:IC ADC 20BIT DIFFINPUT/REF16SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2430IGN#TRPBF 功能描述:IC ADC 20BIT DIFFINPUT/REF16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2431CMS 功能描述:IC ADC 20BIT DIFFINPUT/REF10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*