- 您現在的位置：買賣IC網 > PDF目錄10301 > LTC2356CMSE-12#PBF (Linear Technology)IC ADC 12BIT 3.5MSPS 10-MSOP PDF資料下載
參數資料
| 型號： | LTC2356CMSE-12#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 3/18頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 3.5MSPS 10-MSOP |
| 標準包裝： | 50 |
| 位數： | 12 |
| 采樣率（每秒）： | 3.5M |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 18mW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 |
| 供應商設備封裝： | 10-MSOP 裸露焊盤 |
| 包裝： | 管件 |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
| 配用： | DC1082A-E-ND - BOARD SAR ADC LTC2356-14 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
LTC2356-12/LTC2356-14
11
2356fb
DRIVING THE ANALOG INPUT
ThedifferentialanaloginputsoftheLTC2356-12/LTC2356-14
may be driven differentially or as a single-ended input (i.e.,
theAIN–inputissettoVCM).Bothdifferentialanaloginputs,
AIN+ and AIN–, are sampled at the same instant. Any
unwanted signal that is common to both inputs of each
input pair will be reduced by the common mode rejec-
tion of the sample-and-hold circuit. The inputs draw
only one small current spike while charging the sample-
and-hold capacitors at the end of conversion. During
conversion, the analog inputs draw only a small leakage
current. If the source impedance of the driving circuit
is low, then the LTC2356-12/LTC2356-14 inputs can be
driven directly. As source impedance increases, so will
acquisition time. For minimum acquisition time with
high source impedance, a buffer amplifier must be used.
The main requirement is that the amplifier driving the
analog input(s) must settle after the small current spike
before the next conversion starts (settling time must be
39ns for full throughput rate). Also keep in mind while
choosing an input amplifier the amount of noise and
harmonic distortion added by the amplifier.
CHOOSING AN INPUT AMPLIFIER
Choosing an input amplifier is easy if a few requirements
are taken into consideration. First, to limit the magnitude of
the voltage spike seen by the amplifier from charging the
samplingcapacitor,chooseanamplifierthathasalowoutput
impedance(<100Ω)attheclosed-loopbandwidthfrequency.
For example, if an amplifier is used with a gain of 1 and has a
unity-gainbandwidthof50MHz,thentheoutputimpedanceat
50MHz must be less than 100Ω. The second requirement is
thattheclosed-loopbandwidthmustbegreaterthan40MHz
to ensure adequate small-signal settling for full throughput
rate. If slower op amps are used, more time for settling can
be provided by increasing the time between conversions.
The best choice for an op amp to drive the LTC2356-12/
LTC2356-14 will depend on the application. Generally, ap-
plications fall into two categories: AC applications where
dynamic specifications are most critical and time domain
applications where DC accuracy and settling time are most
critical. The following list is a summary of the op amps that
are suitable for driving the LTC2356-12/LTC2356-14. (More
APPLICATIONS INFORMATION
detailed information is available in the Linear Technology
Databooks and our website at www.linear.com.)
LTC1566-1: Low Noise 2.3MHz Continuous Time Low-
Pass Filter.
LT1630: Dual 30MHz Rail-to-Rail Voltage FB Amplifier.
2.7V to ±15V supplies. Very high AVOL, 500V offset and
520ns settling to 0.5LSB for a 4V swing. THD and noise
are –93dB to 40kHz and below 1LSB to 320kHz (AV = 1,
2VP-P into 1kΩ, VS = 5V), making the part excellent for
AC applications (to 1/3 Nyquist) where rail-to-rail perfor-
mance is desired. Quad version is available as LT1631.
LT1632: Dual 45MHz Rail-to-Rail Voltage FB Amplifier.
2.7V to ±15V supplies. Very high AVOL, 1.5mV offset and
400ns settling to 0.5LSB for a 4V swing. It is suitable
for applications with a single 5V supply. THD and noise
are –93dB to 40kHz and below 1LSB to 800kHz (AV = 1,
2VP-P into 1kΩ, VS = 5V), making the part excellent for
ACapplicationswhererail-to-railperformanceisdesired.
Quad version is available as LT1633.
LT1813: Dual 100MHz 750V/s 3mA Voltage Feedback
Amplifier.5Vto±5Vsupplies.Distortionis–86dBto100kHz
and –77dB to 1MHz with ±5V supplies (2VP-P into 500Ω).
Excellent part for fast AC applications with ±5V supplies.
LT1801: 80MHz GBWP, –75dBc at 500kHz, 2mA/Amplifier,
8.5nV/√Hz.
LT1806/LT1807: 325MHz GBWP, –80dBc Distortion at
5MHz, Unity-Gain Stable, R-R In and Out, 10mA/Ampli-
fier, 3.5nV/√Hz.
LT1810:180MHzGBWP,–90dBcDistortionat5MHz,Unity-
Gain Stable, R-R In and Out, 15mA/Amplifier, 16nV/√Hz.
LT1818/LT1819: 400MHz, 2500V/s,9mA, Single/Dual
Voltage Mode Operational Amplifier.
LT6200: 165MHz GBWP, –85dBc Distortion at 1MHz,
Unity-Gain Stable, R-R In and Out, 15mA/Amplifier,
0.95nV/√Hz.
LT6203: 100MHz GBWP, –80dBc Distortion at 1MHz,
Unity-Gain Stable, R-R In and Out, 3mA/Amplifier,
1.9nV/√Hz.
LT6600-10: Amplifier/Filter Differential In/Out with 10MHz
Cutoff.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-24X-CU-S | CONVERTER MOD DC/DC 5.2V 200W |
| VI-200-MX-S | CONVERTER MOD DC/DC 5V 75W |
| VE-23H-MY | CONVERTER MOD DC/DC 52V 50W |
| VE-B4D-MW-S | CONVERTER MOD DC/DC 85V 100W |
| MS27474T14F18SC | CONN RCPT 18POS JAM NUT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2356CMSE-14#PBF | 功能描述:IC ADC 14BIT 3.5MSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC2356CMSE-14#TRPBF | 功能描述:IC ADC 14BIT 3.5MSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC2356IMSE-12#PBF | 功能描述:IC ADC 12BIT 3.5MSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2356IMSE-12#TRPBF | 功能描述:IC ADC 12BIT 3.5MSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2356IMSE-14 | 制造商:Linear Technology 功能描述:IC ADC 14BIT 3 WIRE SPI 3.5MSPS |
發布緊急采購，3分鐘左右您將得到回復。