- 您現在的位置：買賣IC網 > PDF目錄2005 > LTC2240CUP-12#PBF (Linear Technology)IC ADC 12BIT 170MSPS 64-QFN PDF資料下載
參數資料
| 型號： | LTC2240CUP-12#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 8/30頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 170MSPS 64-QFN |
| 標準包裝： | 40 |
| 位數： | 12 |
| 采樣率（每秒）： | 170M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 638mW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 64-QFN（9x9） |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
LTC2240-12
16
224012fd
APPLICATIONS INFORMATION
Input Drive Impedance
As with all high performance, high speed ADCs, the dy-
namic performance of the LTC2240-12 can be inuenced
by the input drive circuitry, particularly the second and
third harmonics. Source impedance and input reactance
can inuence SFDR. At the falling edge of ENC, the sample-
and-hold circuit will connect the 2pF sampling capacitor to
the input pin and start the sampling period. The sampling
period ends when ENC rises, holding the sampled input on
the sampling capacitor. Ideally the input circuitry should be
fast enough to fully charge the sampling capacitor during
the sampling period 1/(2fS); however, this is not always
possible and the incomplete settling may degrade the SFDR.
The sampling glitch has been designed to be as linear as
possible to minimize the effects of incomplete settling.
For the best performance, it is recommended to have a
source impedance of 100Ω or less for each input. The
source impedance should be matched for the differential
inputs. Poor matching will result in higher even order
harmonics, especially the second.
Input Drive Circuits
Figure 3 shows the LTC2240-12 being driven by an RF
transformer with a center tapped secondary. The secondary
center tap is DC biased with VCM, setting the ADC input
signal at its optimum DC level. Terminating on the trans-
former secondary is desirable, as this provides a common
mode path for charging glitches caused by the sample and
hold. Figure 3 shows a 1:1 turns ratio transformer. Other
turns ratios can be used if the source impedance seen
by the ADC does not exceed 100Ω for each ADC input.
A disadvantage of using a transformer is the loss of low
frequency response. Most small RF transformers have
poor performance at frequencies below 1MHz.
Figure 4 demonstrates the use of a differential amplier to
convert a single ended input signal into a differential input
signal. The advantage of this method is that it provides
low frequency input response; however, the limited gain
bandwidth of most op amps will limit the SFDR at high
input frequencies.
Figure 5 shows a capacitively-coupled input circuit. The
impedance seen by the analog inputs should be matched.
The 25Ω resistors and 12pF capacitor on the analog inputs
serve two purposes: isolating the drive circuitry from
the sample-and-hold charging glitches and limiting the
Figure 3. Single-Ended to Differential
Conversion Using a Transformer
Figure 4. Differential Drive with an Amplier
Figure 5. Capacitively-Coupled Drive
25Ω
10Ω
0.1μF
AIN
+
AIN
+
AIN
–
AIN
–
12pF
2.2μF
VCM
LTC2240-12
ANALOG
INPUT
0.1μFT1
1:1
T1 = MA/COM ETC1-1T
RESISTORS, CAPACITORS
ARE 0402 PACKAGE SIZE
224012 F03
25Ω
50Ω
AIN
+
AIN
+
AIN
–
AIN
–
12pF
2.2μF
3pF
VCM
LTC2240-12
224012 F04
–
+
CM
ANALOG
INPUT
HIGH SPEED
DIFFERENTIAL
AMPLIFIER
3pF
0.1μF
25Ω
0.1μF
VCM
AIN
+
AIN
+
AIN
–
AIN
–
100Ω
ANALOG
INPUT
12pF
224012 F05
2.2μF
0.1μF
25Ω
LTC2240-12
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2240IUP-10#PBF | IC ADC 10BIT 170MSPS 64-QFN |
| LTC2241IUP-10#PBF | IC ADC 10BIT 210MSPS 64-QFN |
| LTC2242IUP-10#PBF | IC ADC 10BIT 250MSPS 64-QFN |
| LTC2245IUH#TRPBF | IC ADC 14BIT 10MSPS 3V 32-QFN |
| LTC2249IUH#TRPBF | IC ADC 14BIT 80MSPS LP 32-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2240CUP-12-TR | 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 170Msps ADC |
| LTC2240CUP-12-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 170Msps ADC |
| LTC2240IUP-10 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:10-Bit, 170Msps ADC |
| LTC2240IUP-10#PBF | 功能描述:IC ADC 10BIT 170MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2240IUP-10#TRPBF | 功能描述:IC ADC 10BIT 170MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。