- 您現在的位置：買賣IC網 > PDF目錄384633 > LTC1667 (Linear Technology Corporation) 12-Bit, 14-Bit, 16-Bit, 50Msps DACs PDF資料下載
參數資料
| 型號： | LTC1667 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
| 中文描述： | 12位，14位，16位，50 MSPS的數模轉換器 |
| 文件頁數： | 15/24頁 |
| 文件大?。?/td> | 888K |
| 代理商： | LTC1667 |
15
LTC1666/LTC1667/LTC1668
APPLICATIOU
Resistor Loaded Outputs
A differential resistor loaded output configuration is shown
in Figure 6. It is simple and economical, but it can drive
only differential loads with impedance levels and ampli-
tudes appropriate for the DAC outputs.
The recommended single-ended resistor loaded configu-
ration is essentially the same circuit as the differential
resistor loaded, case—simply use the I
OUT A
output,
referred to ground. Rather than tying the unused I
OUT B
output to ground, it is preferred to load it with the equiva-
lent R
LOAD
of I
OUT A
. Then I
OUT B
will still swing with a
waveform complementary to I
OUT A
.
W
U
U
helps reduce distortion by limiting the high frequency
signal amplitude at the op amp inputs. The circuit swings
±
1V around ground.
Figure 8 shows a simplified circuit for a single-ended
output using I-to-V converter to produce a unipolar
buffered voltage output. This configuration typically has
the best DC linearity performance, but its AC distortion at
higher frequencies is limited by U1’s slewing capabilities.
Digital Interface
The LTC1666/LTC1667/LTC1668 have parallel inputs that
are latched on the rising edge of the clock input. They
accept CMOS levels from either 5V or 3.3V logic and can
accept clock rates of up to 50MHz.
Referring to the Timing Diagram and Block Diagram, the
data inputs go to master-slave latches that update on the
rising edge of the clock. The input logic thresholds, V
IH
=
2.4V min, V
IL
= 0.8V max, work with 3.3V or 5V CMOS
levels over temperature. The guaranteed setup time, t
DS
,
is 8ns minimum and the hold time, t
DH
, is 4ns minimum.
The minimum clock high and low times are guaranteed at
6ns and 8ns, respectively. These specifications allow the
LTC1666/LTC1667/LTC1668 to be clocked at up to 50Msps
minimum.
For best AC performance, the data and clock waveforms
need to be clean and free of undershoot and overshoot.
Clock and data interconnect lines should be twisted pair,
coax or microstrip, and proper line termination is impor-
tant. If the digital input signals to the DAC are considered
as analog AC voltage signals, they are rich in spectral
components over a broad frequency range, usually in-
Op Amp I to V Converter Outputs
Adding an op amp differential to single-ended converter
circuit to the differential resistor loaded output gives the
circuit of Figure 7.
This circuit complements the capabilities of the trans-
former-coupled application at lower frequencies, since
available op amps can deliver good AC distortion perfor-
mance at signal frequencies of a few MHz down to DC. The
optional capacitor adds a single real pole of filtering, and
Figure 6. Differential Resistor-Loaded Output
I
OUT B
I
OUT A
52.3
52.3
1666/7/8 F07
LTC1666/
LTC1667/
LTC1668
Figure 8. Single-Ended Op Amp I to V Converter
200
1666/7/8
F09
I
OUT A
I
OUT B
LADCOM
R
FB
200
V
0V TO 2V
I
OUTFS
10mA
C
OUT
–
+
U1
LT
1812
LTC1666/
LTC1667/
LTC1668
I
OUT B
I
OUT A
52.3
500
52.3
1666/7/8 F08
–
+
200
500
200
60pF
LT1809
±
1V
10dBm
V
OUT
LTC1666/
LTC1667/
LTC1668
Figure 7. Differential to Single-Ended Op Amp I-V Converter
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1667CG | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
| LTC1667IG | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
| LTC1760 | Dual Smart Battery System Manager |
| LTC1760CFW | Dual Smart Battery System Manager |
| LTC2286 | Dual 10-Bit, 65/40/25Msps Low Noise 3V ADCs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1667CG | 功能描述:IC D/A CONV 14BIT 50MSPS 28-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| LTC1667CG#PBF | 功能描述:IC D/A CONV 14BIT 50MSPS 28-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| LTC1667CG#TR | 功能描述:IC D/A CONV 14BIT 50MSPS 28-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| LTC1667CG#TRPBF | 功能描述:IC D/A CONV 14BIT 50MSPS 28-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| LTC1667IG | 功能描述:IC D/A CONV 14BIT 50MSPS 28-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
發布緊急采購，3分鐘左右您將得到回復。