- 您現在的位置：買賣IC網 > PDF目錄384633 > LTC1649CS (LINEAR TECHNOLOGY CORP) Low Power Timer 8-SOIC -40 to 85 PDF資料下載
參數資料
| 型號： | LTC1649CS |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Low Power Timer 8-SOIC -40 to 85 |
| 中文描述： | 20 A SWITCHING CONTROLLER, 260 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SO-16 |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 201K |
| 代理商： | LTC1649CS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁
11
LTC1649
The CP
OUT
pin can typically supply 50mA at 5V, adequate
to power the V
CC
and PV
CC
pins. This supply can also be
used to power external circuitry, but any additional current
drawn from CP
OUT
subtracts from the current available to
drive the external MOSFETs. Circuits with small external
MOSFETs can draw as much as 20mA or 30mA from
CP
OUT
without hindering performance. High output cur-
rent circuits with large or multiple external MOSFETs may
need every milliamp they can get from CP
OUT
, and external
loads should be minimized. The charge pump at PV
CC1
is
more limited in its abilities, and should not be connected
to anything except PV
CC1
. In particular, do not connect a
bypass capacitor from PV
CC1
to ground—it will steal
charge from the charge pump and actually degrade perfor-
mance.
Compensation and Transient Response
The LTC1649 voltage feedback loop is compensated at the
COMP pin; this is the output node of the internal g
m
error
amplifier. The loop can generally be compensated prop-
erly with an RC network from COMP to GND and an
additional small C from COMP to GND (Figure 5). Loop
stability is affected by inductor and output capacitor
values and by other factors. Optimum loop response can
be obtained by using a network analyzer to find the loop
poles and zeros; nearly as effective and a lot easier is to
empirically tweak the R
C
values until the transient recovery
looks right with an output load step.
Output transient response is set by three major factors: the
time constant of the inductor and the output capacitor, the
ESR of the output capacitor, and the loop compensation
components. The first two factors usually have much
more impact on overall transient recovery time than the
third; unless the loop compensation is way off, more
improvement can be had by optimizing the inductor and
the output capacitor than by fiddling with the loop com-
pensation components. In general, a smaller value induc-
tor will improve transient response at the expense of ripple
and inductor core saturation rating. Minimizing output
capacitor ESR will also help optimize output transient
response. See Input and Output Capacitors for more
information.
Soft Start and Current Limit
The LTC1649 includes a soft start circuit at the SS pin; this
circuit is used both for initial start-up and during current
limit operation. SS requires an external capacitor to GND
with the value determined by the required soft start time.
An internal 12
μ
A current source is included to charge the
external capacitor. Soft start functions by clamping the
maximum voltage that the COMP pin can swing to, thereby
controlling the duty cycle (Figure 6). The LTC1649 will
begin to operate at low duty cycle as the SS pin rises to
about 2V below the V
CC
pin. As SS continues to rise, the
duty cycle will increase until the error amplifier takes over
and begins to regulate the output. When SS reaches 1V
below V
CC
the LTC1649 will be in full operation. An internal
switch shorts the SS pin to GND during shutdown.
APPLICATIO
S I
N
FOR
ATIO
U
W
U
LTC1649
COMP
1659 F05
C1
C
C
R
C
Figure 5. Compensation Pin Hook-Up
Figure 6. Soft Start Clamps COMP Pin
1649 F06
C
SS
COMP
SS
LTC1649
12
μ
A
V
CC
FB
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1666 | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
| LTC1666CG | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
| LTC1666IG | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
| LTC1667 | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
| LTC1667CG | 12-Bit, 14-Bit, 16-Bit, 50Msps DACs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1649CS#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC1649CS#TR | 功能描述:IC REG CTRLR BUCK PWM VM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1649CS#TRPBF | 功能描述:IC REG CTRLR BUCK PWM VM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1649IS | 功能描述:IC REG CTRLR BUCK PWM VM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1649IS#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。