- 您現在的位置：買賣IC網 > PDF目錄2003 > LTC1414IGN#TRPBF (Linear Technology)IC A/D CONV 14BIT SAMPLNG 28SSOP PDF資料下載
參數資料
| 型號： | LTC1414IGN#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 20/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC A/D CONV 14BIT SAMPLNG 28SSOP |
| 標準包裝： | 2,500 |
| 位數： | 14 |
| 采樣率（每秒）： | 2.2M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 230mW |
| 電壓電源： | 雙 ± |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
9
LTC1414
APPLICATIONS INFORMATION
WU
U
IMD f
f
amplitude at f
f
amplitude at f
ab
a
±
()=
±
()
20log
The full-linear bandwidth is the input frequency at which
the S/(N + D) has dropped to 74dB (12 effective bits). The
LTC1414 has been designed to optimize input bandwidth,
allowing the ADC to undersample input signals with fre-
quencies above the converter’s Nyquist frequency. The
noise floor stays very low at high frequencies; S/(N + D)
becomes dominated by distortion at frequencies far be-
yond Nyquist.
Driving the Analog Input
The differential analog inputs of the LTC1414 are easy to
drive. The inputs may be driven differentially or as a single-
ended input (i.e., the AIN– input is grounded). The A IN+ and
AIN– inputs are sampled at the same instant. Any
unwanted signal that is common mode to both inputs will
be reduced by the common mode rejection of the sample-
and-hold circuit. The inputs draw only one small current
spike while charging the sample-and-hold capacitors at
the end of conversion. During conversion, the analog
inputs draw only a small leakage current. If the source
impedance of the driving circuit is low then the LTC1414
inputs can be driven directly. As source impedance
increases so will acquisition time (see Figure 6). For
minimum acquisition time, with high source impedance, a
buffer amplifier should be used. The only requirement is
that the amplifier driving the analog input(s) must settle
after the small current spike before the next conversion
starts (settling time must be 70ns for full throughput rate).
Peak Harmonic or Spurious Noise
The peak harmonic or spurious noise is the largest spec-
tral component excluding the input signal and DC. This
value is expressed in dB relative to the RMS value of a full-
scale input signal.
Full-Power and Full-Linear Bandwidth
The full-power bandwidth is that input frequency at which
the amplitude of the reconstructed fundamental is re-
duced by 3db for a full-scale input signal.
FREQUENCY (kHz)
0
400
800
200
600
1000
AMPLITUDE
(dB)
1414 F05a
0
–20
–40
–60
–80
–100
–120
fSAMPLE = 2.2MHz
fIN1 = 80.566kHz
fIN2 = 97.753kHz
FREQUENCY (kHz)
0
400
800
200
600
1000
AMPLITUDE
(dB)
1414 F05b
0
–20
–40
–60
–80
–100
–120
fSAMPLE = 2.2MHz
fIN1 = 970.019kHz
fIN2 = 1.492MHz
Figure 6. Acquisition Time vs Source Resistance
SOURCE RESISTANCE (
)
10
0.01
ACQUISITION
TIME
(
s)
0.1
1
10
100
1k
1414 FO6
10k
100k
Figure 5a. Intermodulation Distortion Plot
with Inputs at 80kHz and 97kHz
Figure 5b. Intermodulation Distortion Plot
with Input Signals of 1MHz and 1.5MHz
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1415CG#TRPBF | IC A/D CONV 12BIT SAMPLNG 28SSOP |
| LTC1416IG#TR | IC ADC 14BIT 400KSPS SMPL 28SSOP |
| LTC1417AIGN#TR | IC ADC 14BIT 400KSPS SMPL 16SSOP |
| LTC1418ACG#TRPBF | IC A/D CONV 14BIT SRL&PAR 28SSOP |
| LTC1419AISW#TRPBF | IC A/D CONV 14BIT SAMPLNG 28SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1415CG | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC1415CG#PBF | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC1415CG#TR | 功能描述:IC ADC 12BIT 1.25MSPS SMP 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC1415CG#TRPBF | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC1415CSW | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。