- 您現在的位置：買賣IC網 > PDF目錄10289 > LTC1408CUH-12#PBF (Linear Technology)IC ADC 12BIT 600KSPS 32-QFN PDF資料下載
參數資料
| 型號： | LTC1408CUH-12#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 10/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 600KSPS 32-QFN |
| 標準包裝： | 73 |
| 位數： | 12 |
| 采樣率（每秒）： | 600k |
| 數據接口： | 串行 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 15mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-QFN 裸露焊盤（5x5） |
| 包裝： | 管件 |
| 輸入數目和類型： | 12 個單端，單極；12 個單端，雙極；6 個差分，單極；6 個差分，雙極 |
| 配用： | DC887A-ND - BOARD SAR ADC LTC1408 |
18
LTC1408-12
140812f
APPLICATIO S I FOR ATIO
WU
UU
High quality tantalum and ceramic bypass capacitors should
be used at the VCC, VDD and VREF pins as shown in the
Block Diagram on the first page of this data sheet. For
optimum performance, a 10
F surface mount tantalum
capacitor with a 0.1
F ceramic is recommended for the
VCC, VDD and VREF pins. Alternatively, 10F ceramic chip
capacitors such as X5R or X7R may be used. The capaci-
tors must be located as close to the pins as possible. The
traces connecting the pins and the bypass capacitors must
be kept short and should be made as wide as possible. The
VCC and VDD bypass capacitor returns to the ground plane
and the VREF bypass capacitor returns to the Pin 22. Care
should be taken to place the 0.1
F VCC and VDD bypass
capacitor as close to Pins 24 and 25 as possible.
Figure 6 shows the recommended system ground connec-
tions. All analog circuitry grounds should be terminated at
the LTC1408-12 Exposed Pad. The ground return from the
LTC1408-12 to the power supply should be low imped-
ance for noise-free operation. The Exposed Pad of the 32-
pin QFN package is also internally tied to the ground pads.
The Exposed Pad should be soldered on the PC board to
reduce ground connection inductance. All ground pins
(GND, DGND, OGND) must be connected directly to the
same ground plane under the LTC1408-12.
HARDWARE INTERFACE TO TMS320C54x
The LTC1408-12 is a serial output ADC whose interface
has been designed for high speed buffered serial ports in
fast digital signal processors (DSPs). Figure 7 shows an
example of this interface using a TMS320C54X.
The buffered serial port in the TMS320C54x has direct
access to a 2kB segment of memory. The ADC’s serial
data can be collected in two alternating 1kB segments, in
real time, at the full 600ksps conversion rate of the
LTC1408-12. The DSP assembly code sets frame sync
mode at the BFSR pin to accept an external positive going
pulse and the serial clock at the BCLKR pin to accept an
external positive edge clock. Buffers near the LTC1408-12
may be added to drive long tracks to the DSP to prevent
corruption of the signal to LTC1408-12. This configura-
tion is adequate to traverse a typical system board, but
source resistors at the buffer outputs and termination
resistors at the DSP, may be needed to match the charac-
teristic impedance of very long transmission lines. If you
need to terminate the SDO transmission line, buffer it first
with one or two 74ACxx gates. The TTL threshold inputs of
the DSP port respond properly to the 3V swing used with
the LTC1408-12.
Figure 6. Recommended Layout
VDD BYPASS,
0.1
F, 0402
OVDD BYPASS,
0.1
F, 0402
VREF BYPASS,
10
F, 0805
VCC BYPASS,
0.1
F, 0402 AND
10
F, 0805
1408 F06
3
30
32
1
2
3-WIRE SERIAL
INTERFACE LINK
OVDD
CONV
SCK
LTC1408-12
SDO
VCC
BFSR
BCLKR
TMS320C54x
BDR
OGND
31
DGND
CONV
0V TO 3V LOGIC SWING
CLK
5V
3V
B11
B10
Figure 7. DSP Serial Interface to TMS320C54x
相關PDF資料 |
PDF描述 |
|---|---|
| D38999/26WJ29AN | CONN HSG PLUG 29POS STRGHT PINS |
| LTC1854CG#TRPBF | IC ADC 12BIT 8CH 100KSPS 28SSOP |
| VI-BNF-IX-B1 | CONVERTER MOD DC/DC 72V 75W |
| AD7366BRUZ-5500RL7 | IC ADC 12BIT DUAL BIPO 24-TSSOP |
| VI-BNF-IW-B1 | CONVERTER MOD DC/DC 72V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1408IUH#PBF | 功能描述:IC ADC 14BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC1408IUH#TRPBF | 功能描述:IC ADC 14BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC1408IUH-12#PBF | 功能描述:IC ADC 12BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC1408IUH-12#TRPBF | 功能描述:IC ADC 12BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1409CG | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。