- 您現在的位置：買賣IC網 > PDF目錄2003 > LTC1400IS8 (Linear Technology)IC A/D CONV 12BIT W/SHTDN 8-SOIC PDF資料下載
參數資料
| 型號： | LTC1400IS8 |
| 廠商： | Linear Technology |
| 文件頁數： | 20/20頁 |
| 文件大小： | 0K |
| 描述： | IC A/D CONV 12BIT W/SHTDN 8-SOIC |
| 標準包裝： | 100 |
| 位數： | 12 |
| 采樣率（每秒）： | 400k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 160mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個單端，單極；1 個單端，雙極 |
| 產品目錄頁面： | 1346 (CN2011-ZH PDF) |
LTC1400
9
1400fa
APPLICATIO S I FOR ATIO
W
U
FREQUENCY (kHz)
0
40
80 100
140
180
20
60
120
160
200
AMPLITUDE
(dB)
1400 F05
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
–110
–120
fSAMPLE = 400kHz
fa = 99.512kHz
fb = 102.441kHz
fa fb
3fa
2fb – fa
2fa + fb
2fa – fb
2fb + fa
2fa
3fb
fa + fb
2fb
fb – fa
Figure 5. Intermodulation Distortion Plot in Bipolar Mode
Figure 5 shows the IMD performance at a 100kHz input.
Peak Harmonic or Spurious Noise
Thepeakharmonicorspuriousnoiseisthelargestspectral
component excluding the input signal and DC. This value
is expressed in decibels relative to the RMS value of a
full-scale input signal.
Full Power and Full Linear Bandwidth
The full power bandwidth is the input frequency at which
theamplitudeofthereconstructedfundamentalisreduced
by 3dB for a full-scale input signal.
The full linear bandwidth is the input frequency at which
the S/(N + D) has dropped to 68dB (11 effective bits). The
LTC1400 has been designed to optimize input bandwidth,
allowing the ADC to undersample input signals with fre-
quencies above the converter’s Nyquist Frequency. The
noise oor stays very low at high frequencies; S/(N +
D) becomes dominated by distortion at frequencies far
beyond Nyquist.
Driving the Analog Input
The analog input of the LTC1400 is easy to drive. It draws
only one small current spike while charging the sample-
and-hold capacitor at the end of a conversion. During
conversion, the analog input draws only a small leakage
current. The only requirement is that the amplier driv-
ing the analog input must settle after the small current
spike before the next conversion starts. Any op amp that
settles in 200ns to small load current transient will allow
maximum speed operation. If a slower op amp is used,
more settling time can be provided by increasing the time
between conversions. Suitable devices capable of driving
the ADC’s AIN input include the LT1360 and the LT1363
op amps.
LTC1400 comes with a built-in unipolar/bipolar detection
circuit. If VSS potential is forced below GND, the internal
circuitry will automatically switch to bipolar mode.
The following list is a summary of the op amps that are
suitable for driving the LTC1400, more detailed informa-
tion is available in the Linear Technology databooks or the
Linear Technology Website.
LT1215/LT1216: Dual and quad 23MHz, 50V/μs single
supply op amps. Single 5V to ±15V supplies, 6.6mA
specications, 90ns settling to 0.5LSB.
LT1223: 100MHz video current feedback amplier. ±5V
to ±15V supplies, 6mA supply current. Low distortion up
to and above 400kHz. Low noise. Good for AC applica-
tions.
LT1227: 140MHz video current feedback amplier. ±5V to
±15V supplies, 10mA supply current. Lowest distortion
at frequencies above 400kHz. Low noise. Best for AC
applications.
LT1229/LT1230: Dual and quad 100MHz current feedback
ampliers.±2Vto±15Vsupplies,6mAsupplycurrenteach
amplier. Low noise. Good AC specs.
LT1360: 37MHz voltage feedback amplier. ±5V to ±15V
supplies. 3.8mA supply current. Good AC and DC specs.
70ns settling to 0.5LSB.
LT1363: 50MHz, 450V/μs op amps. ±5V to ±15V supplies.
6.3mA supply current. Good AC and DC specs. 60ns
settling to 0.5LSB.
LT1364/LT1365:Dualandquad50MHz,450V/μsopamps.
±5V to ±15V supplies, 6.3mA supply current per amplier.
60ns settling to 0.5LSB.
Internal Reference
The LTC1400 has an on-chip, temperature compensated,
curvature corrected, bandgap reference, which is factory
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1401IS8#TRPBF | IC A/D CONV 12BIT W/SHTDN 8-SOIC |
| LTC1402IGN#TRPBF | IC ADC 12BIT 2.2MSPS SHDN 16SSOP |
| LTC1403AHMSE#TRPBF | IC ADC 14BIT 2.8MSPS DIFF 10MSOP |
| LTC1403AIMSE-1#TRPBF | IC ADC 14BIT 2.8MSPS DIFF 10MSOP |
| LTC1404IS8#TRPBF | IC A/D CONV 12BIT W/SHTDN 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1400IS8#PBF | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC1400IS8#TR | 功能描述:IC ADC 12BIT 400KSPS SHTDN 8SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1400IS8#TRPBF | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1400IS8PBF | 制造商:Linear Technology 功能描述:ADC SAR 400ksps 12-Bit Serial SOIC8 |
| LTC1401CS8 | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
發布緊急采購，3分鐘左右您將得到回復。