- 您現在的位置：買賣IC網 > PDF目錄385502 > LTC1263 (Linear Technology Corporation) Regulated 12V, 60mA output DC/DC converter.(12V穩壓, 60mA輸出DC/DC變換器) PDF資料下載
參數資料
| 型號： | LTC1263 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Regulated 12V, 60mA output DC/DC converter.(12V穩壓, 60mA輸出DC/DC變換器) |
| 中文描述： | 調節12V，60mA的輸出直流/直流轉換器。（12V的穩壓，60mA的輸出直流/直流變換器） |
| 文件頁數： | 5/8頁 |
| 文件大小： | 195K |
| 代理商： | LTC1263 |
5
LTC1263
The LTC1263 uses a charge pump tripler to generate 12V
from a V
CC
of 5V. The charge pump is clocked by an
internal oscillator. The oscillator frequency is not critical
and may vary from the typical value of 300kHz. When the
oscillator output is low, C1 and C2 are each connected
between V
CC
and GND, charging them to V
CC
(see Figure
3). When the oscillator output goes high, C1 and C2 are
stacked in series with the bottom plate of C1 pulled to V
CC
(see Figure 4). The top plate of C2 is switched to charge
C
OUT
, which enables V
OUT
to rise.
V
OUT
is regulated to within 5% of 12V by an oscillator pulse
gating scheme that turns the charge pump on and off
based on the comparator results of V
OUT
and a reference
voltage. First, a resistor divider senses V
OUT
; if the output
of the divider (V
DIV
) is less than the output of a bandgap
(V
BGAP
) by the hysteresis voltage (V
HYST
) of the compara-
tor, then oscillator pulses are applied to the charge pump
to raise V
OUT
. When V
DIV
is above V
BGAP
by V
HYST
, the
OPERATIO
U
oscillator pulses are prevented from clocking the charge
pump. As a result, V
OUT
drops until V
DIV
is below V
BGAP
by
V
HYST
again.
To ensure proper start-up when V
OUT
is lower than V
CC
and maintain proper operation when V
OUT
is higher than
V
CC
, the gates of all internal switches are driven between
GND and the higher of either V
OUT
or V
CC
.
To reduce supply current, the LTC1263 may be put into
shutdown mode by “floating” the SHDN pin or connecting
it to V
CC
. In this mode, the bandgap, comparator, oscilla-
tor and resistor divider are switched off to reduce the
supply current to typically 0.5
μ
A. At the same time an
internal switch shorts V
OUT
to V
CC
; V
OUT
takes 10ms (typ)
to reach 5.1V (see t
OFF
in Figure 1). When the SHDN pin
is low, the LTC1263 exits shutdown and the charge pump
operates to raise V
OUT
to 12V. V
OUT
takes 600
μ
s (typ) to
reach the lower regulation limit of 11.4V (see t
ON
in Figure 1).
+
C1
+
C2
V
CC
LTC1263 F03
Figure 3. C1 and C2 Charge to V
CC
Figure 4. C1 and C2 Stacked in Series with C1
–
Tied to V
CC
+
C1
+
C2
V
CC
LTC1263 F04
V
OUT
C
OUT
APPLICATIO
S I
FOR
ATIO
U
Choice of Capacitors
The LTC1263 is tested with the capacitors shown in Figure
2. C1 and C2 are 0.47
μ
F ceramic capacitors and C
IN
and
C
OUT
are 10
μ
F tantalum capacitors. Refer to Table 1 if
other choices are desired.
W
U
U
Table 1. Recommended Capacitor Types and Values
CAPACITOR
CERAMIC
C1, C2
0.47
μ
F to 1
μ
F
C
OUT
10
μ
F (Min)
C
IN
10
μ
F (Min)
TANTALUM
Not Recommended
10
μ
F (Min)
10
μ
F (Min)
ALUMINUM
Not Recommended
10
μ
F (Min)
10
μ
F (Min)
C1 and C2 should be ceramic capacitors with values in the
range of 0.47
μ
F to 1
μ
F. Higher values provide better load
regulation. Tantalum capacitors are not recommended as
the higher ESR of these capacitors degrades performance
at high load currents and V
CC
= 4.75V.
C
IN
and C
OUT
can be ceramic, tantalum or electrolytic
capacitors. The ESR of C
OUT
introduces steps in the V
OUT
waveform whenever the charge pump charges C
OUT
. This
tends to increase V
OUT
ripple. Ceramic or tantalum capaci-
tors are recommended for C
OUT
if minimum ripple is
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1264CSW | High Speed, Quad Universal Filter Building Block |
| LTC1265-3.3 | 1.2A, High Efficiency Step-Down Current Mode DC/DC Converter(3.3V,12A,高效率,電流模式步降DC/DC變換器) |
| LTC1265-5 | 1.2A, High Efficiency Step-Down Current Mode DC/DC Converter(5V,12A,高效率,電流模式步降DC/DC變換器) |
| LTC1266-3.3 | Synchronous Switching Regulator Controller for N- or P-Channel MOSFETs(3.3V,同步穩壓控制器(用于N或P溝道MOS場效應管)) |
| LTC1272(中文) | 12-Bit 3μS 250KHz Sampling ADC(12位3μs 250KHz采樣ADC) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1263CS8 | 功能描述:IC DC/DC CONV FLASHMEM 12V 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1263CS8#PBF | 功能描述:IC DC/DC CONV FLASHMEM 12V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:2,000 系列:- 應用:控制器，DSP 輸入電壓:4.5 V ~ 25 V 輸出數:2 輸出電壓:最低可調至 1.2V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:30-TFSOP（0.173"，4.40mm 寬） 供應商設備封裝:30-TSSOP 包裝:帶卷 (TR) |
| LTC1263CS8#TR | 功能描述:IC CONV DC/DC FLASH MEMORY 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1263CS8#TRPBF | 功能描述:IC DC/DC CONV FLASHMEM 12V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1263CS8PBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Up 4.75-5.5V SOIC8 |
發布緊急采購，3分鐘左右您將得到回復。