參數資料
型號: LTC1159-5
廠商: Linear Technology Corporation
元件分類: 基準電壓源/電流源
英文描述: 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C
中文描述: 射頻放大器
文件頁數: 10/20頁
文件大?。?/td> 323K
代理商: LTC1159-5
10
LTC1159/LTC1159-3.3/LTC1159-5
APPLICATIU
W
U
U
Figure 4. Minimum Suggested C
OUT
(V
IN
– V
OUT
) VOLTAGE (V)
0
C
O
μ
F600
800
1000
4
LTC1159 TPC04
400
200
0
1
2
3
5
L = 50
μ
H
R
SENSE
= 0.02
L = 25
μ
H
R
SENSE
= 0.02
L = 50
μ
H
R
SENSE
= 0.05
pronounced with low values of R
SENSE
and can be
improved by operating at higher frequencies with lower
values of L. The output remains in regulation at all times.
Load Transient Response
Switching regulators take several cycles to respond to a
step in DC (resistive) load current. When a load step
occurs, V
OUT
shifts by an amount equal to
I
LOAD
×
ESR,
where ESR is the effective series resistance of C
OUT
.
I
LOAD
also begins to charge or discharge C
OUT
until the
regulator loop adapts to the current change and returns
V
OUT
to its steady state value. During this recovery time
V
OUT
can be monitored for overshoot or ringing which
would indicate a stability problem. The I
TH
external
components shown in the Figure 1 circuit will provide
adequate compensation for most applications.
A second, more severe transient is caused by switching in
loads with large (>1
μ
F) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C
OUT
, causing a rapid drop in V
OUT
. No regulator can
deliver enough current to prevent this problem if the load
switch resistance is low and it is driven quickly. The only
solution is to limit the rise time of the switch drive so that
the load rise time is limited to approximately 25
×
C
LOAD
.
Thus a 10
μ
F capacitor would require a 250
μ
s rise time,
limiting the charging current to about 200mA.
Line Transient Response
The LTC1159 has better than 60dB line rejection and is
generally impervious to large positive or negative line
voltage transients. However, one rarely occurring condi-
tion can cause the output voltage to overshoot if the proper
precautions are not observed. This condition is a negative
V
IN
transition of several volts followed within 100
μ
s by a
positive transition of greater than 0.5V/
μ
s slew rate.
The reason this condition rarely occurs is because it takes
tens of amps to slew the regulator input capacitor at this
rate! The solution is to add a diode between the cap and V
IN
pins of the LTC1159 as shown in several of the typical
application circuits. If you think your system could have
this problem, add the diode. Note that in surface mount
applications it can be combined with the P-gate diode by
using a low cost common cathode dual diode.
EXTV
CC
Pin Connection
The LTC1159 contains an internal PNP switch connected
between the EXTV
CC
and V
CC
pins. The switch closes and
supplies the V
CC
power whenever the EXTV
CC
pin is higher
in voltage than the 4.5V internal regulator. This allows the
MOSFET driver and control power to be derived from the
output during normal operation and from the internal
regulator when the output is out of regulation (start-up,
short circuit).
Significant efficiency gains can be realized by powering V
CC
from the output, since the V
IN
current resulting from the
driver and control currents will be scaled by a factor of
(Duty Cycle)/(Efficiency). For 5V regulators this simply
means connecting the EXTV
CC
pin directly to V
OUT
. How-
ever, for 3.3V and other low voltage regulators, additional
circuitry is required to derive V
CC
power from the output.
The following list summarizes the four possible connec-
tions for EXTV
CC
:
1. EXTV
CC
Left Open. This will cause V
CC
to be powered
only from the internal 4.5V regulator resulting in re-
duced MOSFET gate drive levels and an efficiency pen-
alty of up to 10% at high input voltages.
相關PDF資料
PDF描述
LTC1159IS RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
LTC1159IS-3.3 RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
LTC1159IS-5 RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
LTC1174 High Efficiency Step-Down and Inverting DC/DC Converter(高效率,反相DC/DC變換器)
LTC1174-3.3 High Efficiency Step-Down and Inverting DC/DC Converter(高效率,步降DC/DC變換器)
相關代理商/技術參數
參數描述
LTC1159CG 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1159CG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1159CG#TR 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1159CG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR)
LTC1159CG-3.3 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX