- 您現在的位置：買賣IC網 > PDF目錄44985 > LT3580MPMS8E#TRPBF (LINEAR TECHNOLOGY CORP) 2.8 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | LT3580MPMS8E#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 2.8 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | LEAD FREE, PLASTIC, MSOP-8 |
| 文件頁數： | 28/28頁 |
| 文件大?。?/td> | 289K |
| 代理商： | LT3580MPMS8E#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁
LT3580
9
3580fg
APPLICATIONS INFORMATION
provided to a load (IOUT). In order to provide adequate
load current, L should be at least:
L
>
DC V
IN
2(f) I
LIM
|V
OUT | IOUT
V
IN η
for boost, topologies, or:
L
>
DC V
IN
2(f) I
LIM
V
OUT IOUT
V
IN η
I
OUT
for the SEPIC and inverting topologies.
where:
L = L1||L2 for uncoupled dual inductor topologies
DC = switch duty cycle (see previous section)
ILIM = switch current limit, typically about 2.4A at 50%
duty cycle (see the Typical Performance Characteristics
section).
η = power conversion efficiency (typically 88% for
boost and 75% for dual inductor topologies at high
currents).
f = switching frequency
Negative values of L indicate that the output load current
IOUT exceeds the switch current limit capability of the
LT3580.
Avoiding Subharmonic Oscillations: The LT3580’s internal
slope compensation circuit will prevent subharmonic oscil-
lations that can occur when the duty cycle is greater than
50%, provided that the inductance exceeds a minimum
value. In applications that operate with duty cycles greater
than 50%, the inductance must be at least:
L
>
V
IN 2 DC – 1
()
(1
DC)(f)
for boost, coupled inductor SEPIC, and coupled inductor
inverting topologies, or:
L1 L2
>
V
IN 2 DC – 1
()
(1
DC)(f)
for the uncoupled inductor SEPIC and uncoupled inductor
inverting topologies.
Maximum Inductance: Excessive inductance can reduce
current ripple to levels that are difficult for the current com-
parator (A3 in the Block Diagram) to cleanly discriminate,
thus causing duty cycle jitter and/or poor regulation. The
maximum inductance can be calculated by:
L
MAX =
V
IN –VCESAT
I
MIN
RIPPLE
DC
f
where LMAX is L1||L2 for uncoupled dual inductor topolo-
gies and IMIN-RIPPLE is typically 95mA.
Current Rating: Finally, the inductor(s) must have a rating
greater than its peak operating current to prevent inductor
saturation resulting in efficiency loss. In steady state, the
peak input inductor current (continuous conduction mode
only) is given by:
I
L1
PEAK =
V
OUT IOUT
V
IN η
+
V
IN DC
2 L1 f
for the boost, uncoupled inductor SEPIC and uncoupled
inductor inverting topologies.
For uncoupled dual inductor topologies, the peak output
inductor current is given by:
I
L2
PEAK =IOUT +
V
OUT 1– DC
()
2 L2 f
For the coupled inductor topologies:
I
OUT 1+
V
OUT
ηV
IN
+
V
IN DC
2 L f
Note: Inductor current can be higher during load transients.
It can also be higher during start-up if inadequate soft-start
capacitance is used.
Capacitor Selection
Low ESR (equivalent series resistance) capacitors should
be used at the output to minimize the output ripple voltage.
Multilayer ceramic capacitors are an excellent choice, as
they have an extremely low ESR and are available in very
small packages. X5R or X7R dielectrics are preferred, as
相關PDF資料 |
PDF描述 |
|---|---|
| LT3582EUD-12#PBF | 0.72 A SWITCHING REGULATOR, PQCC16 |
| LT3582EUD-5#TRPBF | 0.72 A SWITCHING REGULATOR, PQCC16 |
| LT3582EUD#TRPBF | 0.72 A SWITCHING REGULATOR, PQCC16 |
| LT3582EUD-12#TRPBF | 0.72 A SWITCHING REGULATOR, PQCC16 |
| LT3582EUD#PBF | 0.72 A SWITCHING REGULATOR, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3581 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3.3A Boost/Inverting DC/DC Converter with Fault Protection |
| LT3581EDE#PBF | 功能描述:IC REG MULTI CONFIG ADJ 14DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT3581EDE#TRPBF | 功能描述:IC REG MULTI CONFIG ADJ 14DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT3581EDE-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3.3A Boost/Inverting DC/DC Converter with Fault Protection |
| LT3581EDE-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3.3A Boost/Inverting DC/DC Converter with Fault Protection |
發布緊急采購，3分鐘左右您將得到回復。