- 您現在的位置：買賣IC網 > PDF目錄44985 > LT3579IFE#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO20 PDF資料下載
參數資料
| 型號： | LT3579IFE#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO20 |
| 封裝： | 4.40 MM, LEAD FREE, PLASTIC, TSSOP-20 |
| 文件頁數： | 17/40頁 |
| 文件大?。?/td> | 503K |
| 代理商： | LT3579IFE#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
LT3579/LT3579-1
24
35791f
appenDix
SETTING THE OUTPUT VOLTAGE
The output voltage is set by connecting a resistor (RFB)
from VOUT to the FB pin. RFB is determined from the
following equation:
RFB =
| VOUT – VFB |
83.3A
where VFB is 1.215V (typical) for non-inverting topologies
(i.e. boost and SEPIC regulators) and 9mV (typical) for
inverting topologies (see Electrical Characteristics).
POWER SWITCH DUTY CYCLE
In order to maintain loop stability and deliver adequate
current to the load, the power NPNs (Q1 and Q2 in the
BlockDiagram)cannotremain“on”for100%ofeachclock
cycle. The maximum allowable duty cycle is given by:
DCMAX =
TP –MinOffTime
(
)
TP
100%
where TP is the clock period and MinOffTime (found in the
Electrical Characteristics) is typically 45nS.
Conversely, the power NPNs (Q1 and Q2 in the Block
Diagram) cannot remain “off” for 100% of each clock
cycle, and will turn on for a minimum time (MinOnTime)
wheninregulation.ThisMinOnTimegovernstheminimum
allowable duty cycle given by:
DCMIN =
MinOnTime
(
)
TP
100%
where TP is the clock period and MinOnTime (found in the
Electrical Characteristics) is typically 55nS.
Theapplicationshouldbedesignedsuchthattheoperating
duty cycle is between DCMIN and DCMAX.
Duty cycle equations for several common topologies are
given below where VD is the diode forward voltage drop
and VCESAT is typically 250mV at 5.5A for a combined
SW1 and SW2 current.
For the boost topology (see Figure 6):
DCBOOST
VOUT – VIN + VD
VOUT + VD – VCESAT
For the SEPIC or Dual Inductor Inverting topology (see
Figures 7 and 8):
DCSEPIC_&_INVERT
VD +|VOUT |
VIN +|VD | + VOUT VCESAT
For the Single Inductor Inverting topology (see Figure 14):
DCSI_INVERT
| VOUT |VIN + VCESAT + 3 VD
| VOUT | + 3 VD
The LT3579 can be used in configurations where the duty
cycle is higher than DCMAX, but it must be operated in
the discontinuous conduction mode so that the effective
duty cycle is reduced.
INDUCTOR SELECTION
The high frequency operation of the LT3579 allows for
the use of small surface mount inductors. For high
efficiency, choose inductors with high frequency core
material, such as ferrite, to reduce core losses. Also to
improve efficiency, choose inductors with more volume
for a given inductance. The inductor should have low
DCR (copper-wire resistance) to reduce I2R losses, and
must be able to handle the peak inductor current without
saturating. Note that in some applications, the current
handling requirements of the inductor can be lower, such
as in the SEPIC topology where each inductor only carries
one half of the total switch current. Multilayer chokes or
chip inductors usually do not have enough core volume to
support peak inductor currents in the 4A to 7A range. To
minimizeradiatednoise,useatoroidalorshieldedinductor.
See Table 5 for a list of inductor manufacturers.
相關PDF資料 |
PDF描述 |
|---|---|
| LT3579IFE-1#TRPBF | SWITCHING REGULATOR, PDSO20 |
| LT3579EUFD-1#TRPBF | SWITCHING REGULATOR, PQCC20 |
| LT3579IUFD-1#PBF | SWITCHING REGULATOR, PQCC20 |
| LT3579IFE#TRPBF | SWITCHING REGULATOR, PDSO20 |
| LT3579EFE#TRPBF | SWITCHING REGULATOR, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3579IFE-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:6A Boost/Inverting DC/DC Converter with Fault Protection |
| LT3579IUFD#PBF | 功能描述:IC REG MULTI CONFIG SYNC 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT3579IUFD#TRPBF | 功能描述:IC REG MULTI CONFIG SYNC 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT3579IUFD-1#PBF | 功能描述:IC REG MULTI CONFIG SYNC 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT3579IUFD-1#TRPBF | 功能描述:IC REG MULTI CONFIG SYNC 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
發布緊急采購，3分鐘左右您將得到回復。