參數資料
型號： LT3575EFE#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 4.2 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16
封裝： 4.40 MM, LEAD FREE, PLASTIC, TSSOP-16
文件頁數： 7/24頁
文件大?。?/td> 240K
代理商： LT3575EFE#PBF
LT3575
15
3575f
APPLICATIONS INFORMATION
schematics in the Typical Applications section for other
possible values). If too large of an RC value is used, the part
will be more susceptible to high frequency noise and jitter. If
too small of an RC value is used, the transient performance
will suffer. The value choice for CC is somewhat the inverse
of the RC choice: if too small a CC value is used, the loop
may be unstable, and if too large a CC value is used, the
transient performance will also suffer. Transient response
plays an important role for any DC/DC converter.
Design Example
The following example illustrates the converter design
process using LT3575.
Given the input voltage of 20V to 28V, the required output
is 5V, 1A.
VIN(MIN) = 20V, VIN(MAX) = 28V, VOUT = 5V, VF = 0.5V
and IOUT = 1A
1. Select the transformer turns ratio to accommodate
the output.
The output voltage is reected to the primary side by a
factor of turns ratio N. The switch voltage stress VSW is
expressed as:
N
VV
N V
V
P
S
SW MAX
IN
OUT
F
=
=+
+
<
()
50
Or rearranged to:
N
V
VV
IN MAX
OUT
F
<
+
50
()
On the other hand, the primary side current is multiplied by
the same factor of N. The converter output capability is:
ID
NI
D
NV
V
VN
OUT MAX
PK
OUT
F
IN
()
. (
)
()
=
+
08
1
2
(()
VV
OUT
F
+
Minimum Load Requirement
The LT3575 obtains output voltage information through
the transformer while the secondary winding is conducting
current. During this time, the output voltage (multiplied
times the turns ratio) is presented to the primary side of
the transformer. The LT3575 uses this reected signal to
regulate the output voltage. This means that the LT3575
must turn on every so often to sample the output voltage,
which delivers a small amount of energy to the output.
This sampling places a minimum load requirement on the
output of 1% to 2% of the maximum load.
A Zener diode with a Zener breakdown of 20% higher
than the output voltage can serve as a minimum load if
pre-loading is not acceptable. For a 5V output, use a 6V
Zener with cathode connected to the output.
BIAS Pin Considerations
For applications with an input voltage less than 15V, the
BIAS pin is typically connected directly to the VIN pin. For
input voltages greater than 15V, it is preferred to leave the
BIAS pin separate from the VIN pin. In this condition, the
BIAS pin is regulated with an internal LDO to a voltage of
3V. By keeping the BIAS pin separate from the input voltage
at high input voltages, the physical size of the capacitors
can be minimized (the BIAS pin can then use a 6.3V or
10V rated capacitor).
Overdriving the BIAS Pin with a Third Winding
The LT3575 provides excellent output voltage regulation
without the need for an optocoupler, or third winding, but
for some applications with higher input voltages (>20V),
it may be desirable to add an additional winding (often
called a third winding) to improve the system efciency.
For proper operation of the LT3575, if a winding is used as
a supply for the BIAS pin, ensure that the BIAS pin voltage
is at least 3.15V and always less than the input voltage.
For a typical 24VIN application, overdriving the BIAS pin
will improve the efciency gain 4-5%.
Loop Compensation
The LT3575 is compensated using an external resistor-
capacitor network on the VC pin. Typical values are in
the range of RC = 50k and CC = 1.5nF (see the numerous
相關PDF資料
PDF描述
LT3585EDDB-1#PBF 0.65 A BATTERY CHARGE CONTROLLER, PDSO10
LT3585EDDB-2#PBF 0.95 A BATTERY CHARGE CONTROLLER, PDSO10
LT3641EUFD#PBF 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PQCC28
LT3641IUFD#TRPBF 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PQCC28
LT3641EFE#TRPBF 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
LT3575IFE#PBF 功能描述:IC REG FLYBACK ISO ADJ 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LT3575IFE#TRPBF 功能描述:IC REG FLYBACK ISO ADJ 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LT3579 制造商:LINER 制造商全稱:Linear Technology 功能描述:6A Boost/Inverting DC/DC Converter with Fault Protection
LT3579-1 制造商:LINER 制造商全稱:Linear Technology 功能描述:6A Boost/Inverting DC/DC Converter with Fault Protection
LT3579EFE#PBF 功能描述:IC REG MULTI CONFIG SYNC 20TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*