- 您現在的位置：買賣IC網 > PDF目錄1933 > LT1684CN#PBF (Linear Technology)IC RING TONE GENERATOR 14-DIP PDF資料下載
參數資料
| 型號： | LT1684CN#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 15/16頁 |
| 文件大小： | 0K |
| 描述： | IC RING TONE GENERATOR 14-DIP |
| 標準包裝： | 25 |
| 功能： | 音頻發生器 |
| 電路數： | 1 |
| 工作溫度： | 0°C ~ 125°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 14-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 14-PDIP |
| 包裝： | 管件 |
8
LT1684
Encoded PWM Signal Input Basics
The LT1684 accepts a user-supplied PWM carrier that
represents the desired output ring tone signal. This PWM
input is normalized by the LT1684 such that ring tone
output amplitudes can be accurately encoded into the
PWM input.
The LT1684 accepts a differential input to maximize rejec-
tion of system transients and ground noise. If no differen-
tial signal is readily available from the PWM controller, a
simple inverter/buffer block can be used to create the
differential signal required.
Each differential input is internally connected through a 5k
series resistor to back-to-back isolation-base diodes. These
devices internally clamp the differential input signal to
±100mV greater than the input comparator hysteresis
range. The input comparator toggles with a differential
hysteresis equal to that of a standard diode forward
voltage (0.7V nominal). As such, the differential imped-
ance of the input remains high throughout the input
hysteresis region, then reduces to a nominal value of 10k
(7k minimum) as the input is overdriven beyond the
comparator input threshold. A minimum differential input
of 1.6V is specified to assure valid switching.
The PWM signal can be visualized in terms of instanta-
neous ring tone amplitude, normalized to the LT1684
amplitude reference. For a given desired output voltage
VOUTN, the input pulse train required follows the relation:
VOUTN = 2 VREF (DC – 0.5), or
DC = [VOUTN / (2 VREF)] + 0.5, where:
VREF = 1.25V normalized peak voltage
DC = PWM input duty cycle
A 10% to 90% duty cycle range is a practical limit for a
10kHz input carrier. This corresponds to normalized sig-
nal amplitude of
±1V.Dutycyclesexceedingthisrangecan
cause increased output signal distortion as signal energy
is lost due to finite rise and fall times becoming a signifi-
cant percentage of the signal pulses. The associated
reduction in the pulse energy manifests itself as a “soft
clipping” of the output signal resulting in an increase in
harmonic distortion.
The normalized PWM signal is amplified to the desired
output signal level by the active filter/amplifier stage.
Thus, dividing the desired peak output amplitude by the
peak normalized encoded amplitude (VOUT/VOUTN) yields
the required DC gain of the active filter.
System Considerations
Assuming use of a 10% to 90% maximum PWM range, the
peak normalized signal will be:
VPWM(pk) = ± 0.8 VREF = ±1.0V, and:
VOUT(pk) = VPWM(pk) Filter DC Gain
Thus, the DC gain of the output filter equals the desired
peak voltage of the output ring tone signal.
The frequency characteristics of the lowpass output filter
must reflect the allowable carrier ripple on the output
signal. For example, a 10kHz carrier system could use a
2-pole Butterworth lowpass with a cutoff frequency of
100Hz. This filter provides 40dB of input signal rejection
at 10kHz yielding 25mVP-P output ripple. If the DC gain of
the output filter/amplifier was 100, the output ripple volt-
age would be riding on a
±100V sine wave, and therefore
be about – 78dB relative to the output ring signal.
APPLICATIO S I FOR ATIO
WU
UU
相關PDF資料 |
PDF描述 |
|---|---|
| LT1739IUE#TRPBF | IC AMP XDSL LINE DVR DUAL 12-DFN |
| LT1781CSW#PBF | IC DVR/RCVR 5V RS232 DUAL 16SOIC |
| LT1791HN#TRPBF | IC TXRX RS485/RS422 60V 14-DIP |
| LT1796IS8#TRPBF | IC TXRX CAN FAULT TOLERANC 8SOIC |
| LT3750EMS#TRPBF | IC CONVERTER 10MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1684CS | 功能描述:IC RING TONE GENERATOR 14-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| LT1684CS#PBF | 功能描述:IC RING TONE GENERATOR 14-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| LT1684CS#TR | 功能描述:IC GENERATOR RING TONE 14SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| LT1684CS#TRPBF | 功能描述:IC RING TONE GENERATOR 14-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| LT1684IN | 功能描述:IC RING TONE GENERATOR 14-DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
發布緊急采購，3分鐘左右您將得到回復。