- 您現在的位置：買賣IC網 > PDF目錄5439 > LT1395CS5#TRM (Linear Technology)IC AMP CURR FEEDBK SNGL TSOT23-5 PDF資料下載
參數資料
| 型號： | LT1395CS5#TRM |
| 廠商： | Linear Technology |
| 文件頁數： | 3/20頁 |
| 文件大小： | 0K |
| 描述： | IC AMP CURR FEEDBK SNGL TSOT23-5 |
| 標準包裝： | 1 |
| 放大器類型： | 電流反饋 |
| 電路數： | 1 |
| 轉換速率： | 800 V/µs |
| -3db帶寬： | 400MHz |
| 電流 - 輸入偏壓： | 10µA |
| 電壓 - 輸入偏移： | 1000µV |
| 電流 - 電源： | 4.6mA |
| 電流 - 輸出 / 通道： | 80mA |
| 電壓 - 電源，單路/雙路(±)： | 4 V ~ 12 V，±2 V ~ 6 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-5 細型，TSOT-23-5 |
| 供應商設備封裝： | TSOT-23-5 |
| 包裝： | 剪切帶 (CT) |
| 其它名稱： | LT1395CS5 LT1395CS5#TRMCT LT1395CS5-ND |
LT1395/LT1396/LT1397
11
139567fd
operation, it is important to keep the EN pin at least 3V
below the V+ supply. If a V+ of less than 3V is desired,
and the amplier will remain enabled at all times, then
the EN pin should be tied to the V– supply. The enable pin
current is approximately 30μA when activated. If using
CMOS open-drain logic, an external 1k pull-up resistor
is recommended to ensure that the LT1395CS6 remains
disabled in spite of any CMOS drain leakage currents.
The enable/disable times are very fast when driven from
standard 5V CMOS logic. The LT1395CS6 enables in about
30ns (50% point to 50% point) while operating on ±5V
supplies (Figure 2). Likewise, the disable time is approxi-
mately 40ns (50% point to 50% point) (Figure 3).
APPLICATIONS INFORMATION
Figure 4. Buffered RGB to Color-Difference Matrix
–
+
A2
1/4 LT1397
–
+
A3
1/4 LT1397
–
+
A1
1/4 LT1397
R7
255Ω
R6
127Ω
R5
255Ω
R10
2320Ω
R9
432Ω
R11
82.5Ω
R
G
B
R12
90.9Ω
R13
76.8Ω
ALL RESISTORS 1%
VS = ±5V
R8
845Ω
75Ω
SOURCES
R1
255Ω
R2
255Ω
R4
255Ω
R3
255Ω
B-Y
Y
R-Y
1395/6/7 F04
–
+
A4
1/4 LT1397
Differential Input Signal Swing
To avoid any breakdown condition on the input transis-
tors, the differential input swing must be limited to ± 5V.
In normal operation, the differential voltage between the
input pins is small, so the ±5V limit is not an issue.
Buffered RGB to Color-Difference Matrix
An LT1397 can be used to create buffered color-difference
signals from RGB inputs (Figure 4). In this application,
the R input arrives via 75Ω coax. It is routed to the non-
inverting input of LT1397 amplier A1 and to a 845Ω
resistor R8. There is also an 82.5Ω termination resistor
R11, which yields a 75Ω input impedance at the R input
when considered in parallel with R8. R8 connects to
the inverting input of a second LT1397 amplier (A2),
which also sums the weighted G and B inputs to create a
–0.5 Y output. LT1397 amplier A3 then takes the
–0.5 Y output and amplies it by a gain of –2, resulting
in the Y output. Amplier A1 is congured in a noninvert-
ing gain of 2 with the bottom of the gain resistor R2 tied
to the Y output. The output of amplier A1 thus results
in the color-difference output R-Y.
The B input is similar to the R input. It arrives via 75Ω
coax, and is routed to the noninverting input of LT1397
amplier A4, and to a 2320Ω resistor R10. There is also
a 76.8Ω termination resistor R13, which yields a 75Ω
VS = ±5V
VIN = 1V
RF = 255Ω
RG = 255Ω
RL = 100Ω
1395/6/7 F02
OUTPUT
EN
VS = ±5V
VIN = 1V
RF = 255Ω
RG = 255Ω
RL = 100Ω
1395/6/7 F03
OUTPUT
EN
Figure 2. Amplier Enable Time, AV = 2
Figure 3. Amplier Disable Time, AV = 2
相關PDF資料 |
PDF描述 |
|---|---|
| TSW-112-06-L-S | CONN HEADER 12POS .100" SGL GOLD |
| TSW-113-06-L-S | CONN HEADER 13POS .100" SGL GOLD |
| 51667-XX001 | V/T REC PWRBLADE |
| TSW-114-06-L-S | CONN HEADER 14POS .100" SGL GOLD |
| 2-30996-1 | CONN RING 22-16 AWG #8 D-GRIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1395CS5-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad 400MHz Current Feedback Amplifier |
| LT1395CS6 | 制造商:Linear Technology 功能描述:OP Amp Single Current Fdbk ±6V/12V 6-Pin TSOT-23 |
| LT1395CS6#PBF | 制造商:Linear Technology 功能描述:OP Amp Single Current Fdbk 6V/12V 6-Pin TSOT-23 制造商:Linear Technology 功能描述:SC-Amps/High Speed, Cut Tape Single 400MHz CFA |
| LT1395CS6#TR | 功能描述:IC AMP CURR FEEDBACK SGL SOT23-6 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
| LT1395CS6#TRM | 功能描述:IC AMP CURR-FEEDBACK SGL SOT23-6 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:2pA 電壓 - 輸入偏移:1000µV 電流 - 電源:85µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOICN 包裝:剪切帶 (CT) 產品目錄頁面:680 (CN2011-ZH PDF) 其它名稱:MCP6L04T-E/SLCT |
發布緊急采購，3分鐘左右您將得到回復。