- 您現在的位置：買賣IC網 > PDF目錄384606 > LP5520 (National Semiconductor Corporation) RGB Backlight LED Driver PDF資料下載
參數資料
| 型號： | LP5520 |
| 廠商： | National Semiconductor Corporation |
| 元件分類： | LED驅動器 |
| 英文描述： | RGB Backlight LED Driver |
| 中文描述： | RGB背光LED驅動器 |
| 文件頁數： | 14/34頁 |
| 文件大小： | 790K |
| 代理商： | LP5520 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
LED BRIGHTNESS CONTROL
The LED brightness is defined by two factors, the current
through the LED and the PWM duty cycle. The constant cur-
rent outputs ROUT, GOUT and BOUT can be independently
set to sink between 0 and 60 mA. The 8-bit current control has
255 levels and the step size is 235 μA. In manual mode the
current is defined with the
current control (R/G/B)
registers
(01H, 02H and 03H). In automatic mode the current settings
come from the EEPROM.
The PWM control has 12-bit resolution, which means 4095
steps. The minimum pulse width is 200 ns and the frequency
can be set to either 1.2 kHz or 19.2 kHz. The duty cycle range
is from 0 to 100% (0 to 4095). The output PWM value is ob-
tained by multiplication of three factors. The first factor is the
temperature-based value from the EEPROM. The second
factor is the correction register setting, which is independent
for each color. The third factor is the brightness register set-
ting, which is common to all colors.
The temperature based PWM values are stored in the EEP-
ROM at 16°C intervals starting from -40°C and ending to 120°
C. PWM values for the temperatures between the stored
points are interpolated.
LED brightness has 3-bit logarithmic control. The control bits
are in the pwm_brightness (04H) register. The 3-bit value de-
fines a multiplier for the 12-bit PWM value obtained from the
memory according to the following table.
Control byte
<bri[2:0]>
0
0.008
1
0.016
2
0.031
3
0.063
4
0.125
5
0.250
6
0.500
7
1.000
Multiplier
Intensity %
0.8
1.6
3.1
6.3
12.5
25.0
50.0
100.0
PWM Brightness register control
The brightness correction can be used for aging compensa-
tion or other fine-tuning. There is an 8-bit correction register
for each output. The PWM value obtained from the memory
is multiplied by the correction value. The default correction
value is 1. Correction range is from 0 to 2 and the lsb is 0.78%
(1/128).
20186155
LED control principle, shown complete only for red channel
LED PWM CONTROL
The PWM frequency can be selected of two alternatives, slow
and fast, with the control bit
<pwm_fast>
. The slow frequency
is 1.2 kHz. In the fast mode the PWM frequency is multiplied
by 16 and the frequency is 19.2 kHz. Fast mode is the default
mode after reset. The single pulse in normal PWM is split in
16 narrow pulses in fast PWM. Higher frequency helps elim-
inate possible noise from the ceramic capacitors and it also
reduces the ripple in the boost voltage. Minimum pulse length
is 200 ns in both modes.
The PWM pulses of each output do not start simultaneously
in order to avoid high current spike. Red starts in the begin-
ning of the PWM cycle, Green is symmetric with the cycle
center and Blue ends in the end of the cycle. For PWM values
less than 33% for each output, the output currents are com-
pletely non-overlapping. With higher PWM values the over-
lapping increases.
www.national.com
14
L
相關PDF資料 |
PDF描述 |
|---|---|
| LP5520TL | RGB Backlight LED Driver |
| LP5520TLX | RGB Backlight LED Driver |
| LP5521 | Programmable Three Channel LED Driver |
| LP5521TM | Programmable Three Channel LED Driver |
| LP5521TMX | Programmable Three Channel LED Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP5520TL | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:RGB Backlight LED Driver |
| LP5520TL/NOPB | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| LP5520TLX | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:RGB Backlight LED Driver |
| LP5520TLX/NOPB | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| LP5521 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Programmable Three Channel LED Driver |
發布緊急采購，3分鐘左右您將得到回復。