- 您現在的位置：買賣IC網 > PDF目錄44717 > LP3972SQXA514 (NATIONAL SEMICONDUCTOR CORP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, QCC40 PDF資料下載
參數資料
| 型號： | LP3972SQXA514 |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, QCC40 |
| 封裝： | 5 X 5 MM, LLP-40 |
| 文件頁數： | 11/60頁 |
| 文件大小： | 1171K |
| 代理商： | LP3972SQXA514 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
20207612
FIGURE 2. Typical PFM Operation
During PFM operation, the converter positions the output volt-
age slightly higher than the nominal output voltage during
PWM operation, allowing additional headroom for voltage
drop during a load transient from light to heavy load. The PFM
comparators sense the output voltage via the feedback pin
and control the switching of the output FETs such that the
output voltage ramps between <0.6% and <1.7% above the
nominal PWM output voltage. If the output voltage is below
the “high” PFM comparator threshold, the PMOS power
switch is turned on. It remains on until the output voltage
reaches the ‘high’ PFM threshold or the peak current exceeds
the IPFM level set for PFM mode. The typical peak current in
PFM mode is: IPFM = 112 mA + V
IN/27. Once the PMOS
power switch is turned off, the NMOS power switch is turned
on until the inductor current ramps to zero. When the NMOS
zero-current condition is detected, the NMOS power switch is
turned off. If the output voltage is below the ‘high’ PFM com-
parator threshold (see Figure 3), the PMOS switch is again
turned on and the cycle is repeated until the output reaches
the desired level. Once the output reaches the ‘high’ PFM
threshold, the NMOS switch is turned on briefly to ramp the
inductor current to zero and then both output switches are
turned off and the part enters an extremely low power mode.
Quiescent supply current during this ‘sleep’ mode is 21
μA
(typ), which allows the part to achieve high efficiencies under
extremely light load conditions. When the output drops below
the ‘low’ PFM threshold, the cycle repeats to restore the out-
put voltage (average voltage in PFM mode) to <1.15% above
the nominal PWM output voltage. If the load current should
increase during PFM mode (see Figure 3) causing the output
voltage to fall below the ‘low2’ PFM threshold, the part will
automatically transition into fixed-frequency PWM mode. Typ-
ically when V
IN = 3.6V the part transitions from PWM to PFM
mode at 100 mA output current .
20207613
FIGURE 3. Operation in PFM Mode and Transfer to PWM Mode
SHUTDOWN MODE
During shutdown the PFET switch, reference, control and
bias circuitry of the converters are turned off. The NFET
switch will be open in shutdown to discharge the output. When
the converter is enabled, EN, soft start is activated. It is rec-
ommended to disable the converter during the system power
up and undervoltage conditions when the supply is less than
2.7V.
SOFT START
The buck converter has a soft-start circuit that limits in-rush
current during start-up. During start-up the switch current limit
is increased in steps. Soft start is activated only if EN goes
from logic low to logic high after V
IN reaches 2.7V. Soft start
is implemented by increasing switch current limit in steps of
213 mA, 425 mA, 850 mA and 1700 mA (typ. Switch current
limit). The start-up time thereby depends on the output ca-
pacitor and load current demanded at start-up. Typical start-
19
www.national.com
LP3972
相關PDF資料 |
PDF描述 |
|---|---|
| LP3972SQ-5810 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, QCC40 |
| LP3972SQXE514 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, QCC40 |
| LPB48DP | 2-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| LPB24DP | 2-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| LPB15SP | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP3972SQX-A514 | 功能描述:PMIC 解決方案 RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| LP3972SQX-A514/NOPB | 功能描述:PMIC 解決方案 RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| LP3972SQX-BI414/NOPB | 功能描述:PMIC 解決方案 RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| LP3972SQXE514 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Power Management Unit for Advanced Application Processors |
| LP3972SQX-E514 | 功能描述:PMIC 解決方案 RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。