- 您現在的位置：買賣IC網 > PDF目錄44717 > LP3470M5-3.65/NOPB (NATIONAL SEMICONDUCTOR CORP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 PDF資料下載
參數資料
| 型號： | LP3470M5-3.65/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
| 封裝： | SOT-23, 5 PIN |
| 文件頁數： | 6/8頁 |
| 文件大小： | 559K |
| 代理商： | LP3470M5-3.65/NOPB |
Application Information
RESET TIMEOUT PERIOD
The Reset Timeout Period (t
RP) is programmable using an
external capacitor (C
1) connected to pin SRT of LP3470. A
Ceramic chip capacitor rated at or above 10V is sufficient.
The Reset Timeout Period (t
RP) can be calculated using the
following formula:
t
RP (ms) = 2000 x C1 (F).
For example a C
1 of 100 nF will achieve a tRP of 200 ms. If
no delay due to t
RP is needed in a certain application, the pin
SRT should be left floating.
RESET OUTPUT
In applications like microprocessor (P) systems, errors
might occur in system operation during power-up, power-
down, or brownout conditions. It is imperative to monitor the
power supply voltage in order to prevent these errors from
occurring.
The LP3470 asserts a reset signal whenever the V
CC supply
voltage is below a threshold (V
RTH) voltage. Reset is guar-
anteed to be a logic low for V
CC > 0.5V. Once VCC exceeds
the reset threshold, the reset is kept asserted for a time
period (t
RP) programmed by an external capacitor (C1); after
this interval Reset goes to logic high. If a brownout condition
occurs (monitored voltage falls below the reset threshold
minus a small hysteresis), Reset goes low. When V
CC re-
turns above the reset threshold, Reset remains low for a time
period t
RP before going to logic high.
PULL-UP RESISTOR SELECTION
The LP3470’s Reset output structure is a simple open-drain
N-channel MOSFET switch. A pull-up resistor (R
1) should be
connected to V
CC.
R
1 should be large enough to limit the current through the
output MOSFET (Q
1) below 10 mA. A resistor value of more
than 680
guarantees this. R
1 should also be small enough
to ensure a logic high while supplying all the leakage current
through the Reset pin. A resistor value of less than 68k
satisfies this condition. A typical pull-up resistor value of 20
k
is sufficient in most applications.
NEGATIVE-GOING V
CC TRANSIENTS
The LP3470 is relatively immune to short duration negative-
going V
CC transients (glitches). The Typical Operating Char-
acteristics show the Maximum Transient Duration vs. Nega-
tive Transient Amplitude (graph titled Transient Rejection),
for which reset pulses are not generated. This graph shows
the maximum pulse width a negative-going V
CC transient
may typically have without causing a reset pulse to be
issued. As the transient amplitude increases (i.e. goes far-
ther below the reset threshold), the maximum allowable
pulse width decreases. A 0.1 F bypass capacitor mounted
close to V
CC provides additional transient immunity.
Timing Diagram
10001604
LP3470
www.national.com
6
相關PDF資料 |
PDF描述 |
|---|---|
| LP3906SQ-TKXII | SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQX-TKXII | SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQDJXI | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQXJXXI | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQXVPFP | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP3470M5-4.00 | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| LP3470M5-4.00/NOPB | 功能描述:監控電路 TINY POWER ON RESET CIRCUIT RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| LP3470M5-4.38 | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| LP3470M54.38/NOPB | 制造商:Texas Instruments 功能描述: |
| LP3470M5-4.38/NOPB | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。