- 您現在的位置：買賣IC網 > PDF目錄44717 > LP2975IMMX-3.3/NOPB (NATIONAL SEMICONDUCTOR CORP) SPECIALTY ANALOG CIRCUIT, PDSO8 PDF資料下載
參數資料
| 型號： | LP2975IMMX-3.3/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| 封裝： | MINI, SOP-8 |
| 文件頁數： | 10/20頁 |
| 文件大?。?/td> | 1135K |
| 代理商： | LP2975IMMX-3.3/NOPB |
Application Hints (Continued)
High ESR Unstable without Feed-Forward
10003429
As shown, moving the location of f
z lower in frequency
extends the bandwidth, pushing the crossover frequency f
c
out to about 200 kHz. In viewing the plot, it can be seen that
f
p and fz essentially cancel out, leaving only the controller
pole and f
pg. However, since fpg now occurs well before fc,it
will cause enough phase shift to leave very little phase
margin. This application would either oscillate continuously
or be marginally stable (meaning it would exhibit severe
ringing on transient steps).
This can be improved by adding a feed-forward capacitor C
F,
which adds a zero (f
zf) and a pole (fpf) to the gain plot (see
graph HIGH ESR CORRECTED WITH FEED-FORWARD).
In this case, C
F is selected to place fzf at about the same
frequency as f
pg (essentially cancelling out the phase shift
due to f
pg). Assuming the added pole fpf is near or beyond
the f
c frequency, it will add < 45 of phase lag, leaving a
phase margin of > 45 (adequate for good stability).
High ESR Corrected with Feed-Forward
10003431
LOW ESR: To illustrate how an output capacitor with low
ESR can cause an LDO regulator to oscillate, the same
example will be shown except that the ESR will be reduced
sufficiently to increase the original f
z from 5 kHz to 50 kHz.
The plot now shows (see graph LOW ESR UNSTABLE
WITHOUT FEED-FORWARD) that the crossover frequency
f
c has moved down to about 8 kHz. Since fz is 6X fc, it means
that the zero f
z can only provide about 9 of phase lead at fc,
which is not sufficient for stability.
Low ESR Unstable without Feed-Forward
10003430
This application can also be improved by adding a feed-
forward capacitor. C
F will add both a zero fzf and pole fpf to
the gain plot (see graph LOW ESR CORRECTED WITH
FEED-FORWARD).
The crossover frequency f
c is now about 10 kHz. If CF is
selected so that f
zf is about 5 kHz, and fpf is about 20 kHz
(which means V
OUT = 5V), the phase margin will be consid-
erably improved. Calculating out all the poles and zeroes,
the phase margin is increased from 9 to 43 (adequate for
good stability).
Low ESR Corrected with Feed-Forward
10003432
EXCESSIVE GATE CAPACITANCE: Higher values of gate
capacitance shift the pole f
pg to lower frequencies, which can
cause stability problems (see previous section GATE CA-
PACITANCE POLE FREQUENCY). As shown in the graph
f
pg vs. CEFF, the pole fpg will likely fall somewhere between
40 kHz and 500 kHz. How much phase shift this adds
depends on the crossover frequency f
c.
The effect of gate capacitance becomes most important at
high values of ESR for the output capacitor (see graph HIGH
ESR UNSTABLE WITHOUT FEED-FORWARD). Higher val-
ues of ESR increase f
c, which brings fpg more into the
positive gain portion of the curve. As f
pg moves to a lower
frequency (corresponding to higher values of gate capaci-
tance), this effect becomes even worse.
This points out why FET’s should be selected with the lowest
possible gate capacitance: it makes the design more tolerant
of higher ESR values on the output capacitor.
The use of a feed-forward capacitor C
F will help reduce
excess phase shift due to f
pg, but its effectiveness depends
on output voltage (see next section).
LP2975
www.national.com
18
相關PDF資料 |
PDF描述 |
|---|---|
| LP2975AIMM-12/NOPB | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| LP3470M5X-4.38/NOPB | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
| LP3470IM5X-3.65/NOPB | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
| LP3470M5X-3.65/NOPB | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
| LP3470M5-3.65/NOPB | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP2975IMMX-5.0 | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP2975IMMX-5.0/NOPB | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP2978AY-3.8 WAF | 制造商:Texas Instruments 功能描述: |
| LP2978IM5-3.8 | 制造商:Rochester Electronics LLC 功能描述:50MA LDO REGULATOR, LOW-NOISE - Bulk 制造商:Texas Instruments 功能描述: |
| LP2978IM5X-3.8 | 制造商:Rochester Electronics LLC 功能描述:50MA LDO REGULATOR, LOW-NOISE - Bulk 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。