- 您現在的位置：買賣IC網 > PDF目錄384604 > LMX2485 (NATIONAL SEMICONDUCTOR CORP) 50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL PDF資料下載
參數資料
| 型號： | LMX2485 |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | XO, clock |
| 英文描述： | 50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL |
| 中文描述： | PLL FREQUENCY SYNTHESIZER, 3000 MHz, PQCC24 |
| 封裝： | 4 X 4 MM, 0.8 MM, PLASTIC, LLP-24 |
| 文件頁數： | 19/37頁 |
| 文件大小： | 861K |
| 代理商： | LMX2485 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Bench Test Setups
(Continued)
20087771
Input Impedance Measurement Procedure
The above block diagram shows the test setup used for measuring the input impedance for the LMX2485. The DC blocking
capacitor used between the input SMA connector and the pin being measured must be changed to a zero Ohm resistor. This
procedure applies to the FinRF, FinIF, and OSCin pins. The basic test procedure is to calibrate the network analyzer, ensure that
the part is powered up, and then measure the input impedance. The network analyzer can be calibrated by using either calibration
standards or by soldering resistors directly to the evaluation board. An open can be implemented by putting no resistor, a short
can be implemented by soldering a zero ohm resistor as close as possible to the pin being measured, and a short can be
implemented by soldering two 100 ohm resistors in parallel as close as possible to the pin being measured. Calibration is done
with the PLL removed from the PCB. This requires the use of a clamp down fixture that may not always be generally available.
If no clamp down fixture is available, then this procedure can be done by calibrating up to the point where the DC blocking
capacitor usually is, and then implementing port extensions with the network analyzer. Zero ohm resistor is added back for the
actual measurement. Once the setup is calibrated, it is necessary to ensure that the PLL is powered up. This can be done by
toggling the power down bits (RF_PD and IF_PD) and observing that the current consumption indeed increases when the bit is
disabled. Sometimes it may be necessary to apply a signal to the OSCin pin in order to program the part. If this is necessary,
disconnect the signal once it is established that the part is powered up. It is useful to know the input impedance of the PLL for
the purposes of debugging RF problems and designing matching networks. Another use of knowing this parameter is make the
trace width on the PCB such that the input impedance of this trace matches the real part of the input impedance of the PLL
frequency of operation. In general, it is good practice to keep trace lengths short and make designs that are relatively resistant
to variations in the input impedance of the PLL.
L
www.national.com
19
相關PDF資料 |
PDF描述 |
|---|---|
| LMX2485E | 50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL |
| LMX2485ESQ | 50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL |
| LMX2485ESQX | 50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL |
| LMX2485SQ | 50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL |
| LMX2485SQX | 50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMX2485_0610 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800 MHz Integer PLL |
| LMX2485_08 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 800MHz Integer PLL |
| LMX24856211EVAL | 功能描述:時鐘和定時器開發工具 LMX2485 & LM6211 ACTIVE FILTER RoHS:否 制造商:Texas Instruments 產品:Evaluation Modules 類型:Clock Conditioners 工具用于評估:LMK04100B 頻率:122.8 MHz 工作電源電壓:3.3 V |
| LMX2485E | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:50 MHz - 3.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum? Frequency Synthesizers with 800 MHz Integer PLL |
| LMX2485E EVAL | 功能描述:BOARD EVALUATION LMX2485E RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:PLLatinum™ 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
發布緊急采購，3分鐘左右您將得到回復。