參數資料
型號: LMC6772AIM
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 運動控制電子
英文描述: Dual Micropower Rail-To-Rail Input CMOS Comparator with Open Drain Output
中文描述: DUAL COMPARATOR, 8000 uV OFFSET-MAX, 4000 ns RESPONSE TIME, PDSO8
封裝: SOIC-8
文件頁數: 8/11頁
文件大?。?/td> 288K
代理商: LMC6772AIM
Typical Applications
(Continued)
One-Shot Multivibrator
A monostable multivibrator has one stable state in which it
can remain indefinitely. It can be triggered externally to an-
other quasi-stable state. A monostable multivibrator can thus
be used to generate a pulse of desired width.
The desired pulse width is set by adjusting the values of C
2
and R
. The resistor divider of R
and R
can be used to de-
termine the magnitude of the input trigger pulse. The
LMC6772 will change state when V
<
V
2
. Diode D
pro-
vides a rapid discharge path for capacitor C
to reset at the
end of the pulse. The diode also prevents the non-inverting
input from being driven below ground.
Bi-Stable Multivibrator
A bi-stable multivibrator has two stable states. The reference
voltage is set up by the voltage divider of R
and R
. A pulse
applied to the SET terminal will switch the output of the com-
parator high. The resistor divider of R
, R
, and R
now
clamps the non-inverting input to a voltage greater than the
reference voltage. A pulse applied to RESET will now toggle
the output low.
Zero Crossing Detector
A voltage divider of R
and R
establishes a reference volt-
age V
at the non-inverting input. By making the series resis-
tance of R
and R
equal to R
, the comparator will switch
when V
= 0. Diode D
insures that V
3
never drops below
0.7V. The voltage divider of R
and R
then prevents V
2
from going below ground. A small amount of hysteresis is
setup to ensure rapid output voltage transitions.
Oscillator
Figure 8 shows the application of the LMC6772 in a square
wave generator circuit. The total hysteresis of the loop is set
by R
, R
and R
. R
and R
provide separate charge and
discharge paths for the capacitor C. The charge path is set
through R
and D
. So, the pulse width t
is determined by
the RC time constant of R
and C. Similarly, the discharge
path for the capacitor is set by R
and D
. Thus, the time t
2
between the pulses can be changed by varying R
, and the
pulse width can be altered by R
. The frequency of the out-
put can be changed by varying both R
4
and R
5
.
DS012347-28
FIGURE 5. One-Shot Multivibrator
DS012347-30
FIGURE 6. Bi-Stable Multivibrator
DS012347-29
FIGURE 7. Zero Crossing Detector
DS012347-31
FIGURE 8. Square Wave Generator
www.national.com
8
相關PDF資料
PDF描述
LMC6772AIMX Dual Micropower Rail-To-Rail Input CMOS Comparator with Open Drain Output
LMC6772AIN Dual Micropower Rail-To-Rail Input CMOS Comparator with Open Drain Output
LMC6772BIM Dual Micropower Rail-To-Rail Input CMOS Comparator with Open Drain Output
LMC6772BIMX Dual Micropower Rail-To-Rail Input CMOS Comparator with Open Drain Output
LMC6772BIN Dual Micropower Rail-To-Rail Input CMOS Comparator with Open Drain Output
相關代理商/技術參數
參數描述
LMC6772AIM 制造商:Texas Instruments 功能描述:COMPARATOR DUAL CMOS 6772 SOIC8
LMC6772AIM/NOPB 功能描述:校驗器 IC Dual Micropwr RRIN CMOS Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓(最大值):6 mV 電源電流(最大值):1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel
LMC6772AIMM 功能描述:校驗器 IC RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓(最大值):6 mV 電源電流(最大值):1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel
LMC6772AIMM/NOPB 功能描述:校驗器 IC Dual Micropwr RRIN CMOS Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓(最大值):6 mV 電源電流(最大值):1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel
LMC6772AIMMX 功能描述:校驗器 IC RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓(最大值):6 mV 電源電流(最大值):1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel