參數資料
型號： LM3477AMMX
廠商： NATIONAL SEMICONDUCTOR CORP
元件分類： 穩壓器
英文描述： High Efficiency High-Side N-Channel Controller for Switching Regulator
中文描述： 1 A SWITCHING CONTROLLER, 575 kHz SWITCHING FREQ-MAX, PDSO8
封裝： MSOP-8
文件頁數： 15/23頁
文件大?。?/td> 815K
代理商： LM3477AMMX
Design Section
(Continued)
Example: V
IN(MIN)
= 4.5V, V
OUT
= 2.5V, I
OUT(MAX)
= 3A
The hysteretic threshold is derived in a similar manner, the
only difference being that V
is compared V
(V
). Notice that V
does not vary with the duty cycle.
The hysteretic threshold is predetermined by the selection of
R
SN
above. The hysteretic threshold is:
Continuing with the example above,
If the
peak switch current
decreases below this threshold,
the LM3477/A will operate in hysteretic mode (see
OVER
VOLTAGE PROTECTION
section). In some designs, it will
be desired to use R
so that lower valued inductors can be
used (see
DEFAULT/ADJUSTABLE SLOPE COMPENSA-
TION
section and Inductor section). Using R
SL
will lower the
current limit and the hysteretic threshold. See
Figure 8
. R
effectively adds an additional slope to the existing slope of
the V
C
waveform.
When R
SL
is used, the following equations apply:
where MIN(V
50x10
-6
x R
x D
, 0) is the smaller of
the two values in the parenthesis and V
is 0.032V and
0.011V for the LM3477 and LM3477A, respectively. R
can
be used creatively to intentionally lower the hysteretic
threshold, allowing for better performance at lower loads.
However, when R
is used, there may be a minimum load
requirement (see
START-UP/SOFT-START
section).
Power Inductor Section
The LM3477/A operates at a high switching frequency of
500kHz, which allows the use of small inductors. This is
made apparent in the following set of equations used to
calculate the output voltage ripple.
V
OUT(Pk-Pk)
)
i
L(Pk-Pk)
x R
ESR
(V)
As the switching frequency fs increases, the inductance
required for a given output voltage ripple decreases. The
equations above for
V
OUT
and
i
L
provide criteria for
choosing the inductance. The maximum voltage ripple in
steady-state, PWM operation can be controlled by limiting
i
L
which in turn is set by the inductance value. Alternatively,
one can simply choose
i
L
as a percentage of the maximum
output current. Clearly, the size of the output capacitor ESR,
R
ESR
, will have an affect on which criteria is used to choose
the inductance. When the ESR is relatively low (less than
100m
), such as in ceramic, OSCON, and some low ESR
tantalum capacitors, it is convenient to choose the induc-
tance based on setting
i
to 30% of Iout(max). If the ESR is
high, then it may be necessary to restrict
i
to a lower value
so that the output voltage ripple is not too high. Generally
speaking, the former suggestion of setting
i
L
to 30% of
I
OUT(MAX)
is recommended.
The inductance also affects the stability of the converter. The
slopes S
and S
in
Figure 4
are functions of the inductance,
while the compensation ramp, S
, is fixed by default. There-
fore if the inductance is too small, the converter may expe-
rience sub-harmonic oscillations. The LM3477/A provides
sufficient internal slope compensation to allow for induc-
tances chosen according to the
i
= 0.3 x I
guideline in
most cases. Still, one should check to make sure the induc-
tance is not too low before continuing the design process. If
it is found that the selected inductance is too low, a patented
scheme to increase the compensation ramp, S
, is provided
in the LM3477/A (see
DEFAULT/ADJUSTABLE SLOPE
COMPENSATION
section). In the calculations that follow, if it
is found that the chosen inductance is too small, R
SL
can be
used to increase Se so that the inductance can be used.
In a current mode control architecture, there is an inherent
resonance
at
half
the
DEFAULT/ADJUSTABLE SLOPE COMPENSATION
sec-
switching
frequency
(see
200033K4
FIGURE 8. Current Limit and Hysteretic Threshold vs
Duty Cycle with R
SL
L
www.national.com
15
相關PDF資料
PDF描述
LM3477MM High Efficiency High-Side N-Channel Controller for Switching Regulator
LM3477MMX High Efficiency High-Side N-Channel Controller for Switching Regulator
LM3478 High Efficiency Low-Side N-Channel Controller for Switching Regulator
LM3478MM High Efficiency Low-Side N-Channel Controller for Switching Regulator
LM3478MMX High Efficiency Low-Side N-Channel Controller for Switching Regulator
相關代理商/技術參數
參數描述
LM3477AMMX/NOPB 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
LM3477EVAL 功能描述:電源管理IC開發工具 EVAL KIT FOR LM3477 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
LM3477MM 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
LM3477MM 制造商:Texas Instruments 功能描述:SWITCH CONTROLLER SMD 3477 MSOP8
LM3477MM/NOPB 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*