參數資料
型號: LM27241MTCX
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 穩壓器
英文描述: Synchronous Buck Regulator Controller for Mobile Systems
中文描述: SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20
封裝: PLASTIC, TSSOP-20
文件頁數: 14/27頁
文件大?。?/td> 1336K
代理商: LM27241MTCX
Operation Descriptions
(Continued)
The recovery procedure from a VIN Power-off is the same as
for any fault condition.
VDD POWER-OFF (UVLO)
Whenever VDD starts to fall, and drops below about 3.5V,
LDRV goes high immediately, ‘Power Not Good’ is signaled
and in effect a fault condition (in this case an Under-voltage
lockout) is asserted. Recovery from a fault is discussed in
the "Fault and Recovery" section.
OVER-VOLTAGE PROTECTION
If the voltage on the FB pin exceeds 113% of 0.60V, a Power
Not Good signal is asserted. If the voltage on the FB pin
exceeds 130% of 0.60V, a fault condition is declared, and the
LDRV goes high. If the fault persists, the low-side FET will
stay on and the high-side FET will not turn back on until the
FB pin falls within the power good window, and the Enable
pin is toggled.
CURRENT LIMIT AND PROTECTION
Output current limiting is achieved by sensing the negative
Vds drop across the low-side FET when the FET is turned
ON. The Current Limit Comparator (see Block Diagram)
monitors the voltage at the ILIM pin with 62μA (typical value)
of current being sourced from the pin. The 62μAsource flows
through an external resistor connected between ILIM and
the drain of the low-side FET. The voltage drop across the
ILIM resistor is compared with the drop across the low-side
FET and the current limit comparator trips when the two are
of the same magnitude. This determines the threshold of
current limiting. For example, if excessive inductor current
causes the voltage across the low-side FET to exceed the
voltage drop across the ILIM resistor, the ILIM pin will go
negative (with respect to ground) and trip the comparator.
The comparator then sets a latch that prevents the high-side
FET from turning ON during the next PWM clock cycle. The
high-side FET will resume switching only if the current limit
comparator was not tripped in the previous switching cycle.
Additionally, the Soft-start capacitor at the SS pin is dis-
charged with a 115μA current source when an overcurrent
event is in progress. The purpose of discharging the Soft-
start capacitor during an overcurrent event is to eventually
allow the voltage on the SS pin to fall low enough to cause
additional duty cycle limiting.
R
LIMIT
= (R
DS_ON
x I
LIMIT
/ 62 μA)
20120115
CH1: PGOOD, CH2: VIN, CH3: LDRV, CH4: Vo
Output 1V
@
0.02A, VIN = 9.75V, FPWM, L = 10μH, f = 300kHz, C
OUT
=
660μF
FIGURE 8. VIN Removal in FPWM Mode
20120116
CH1: PGOOD, CH2: VIN, CH3: LDRV, CH4: Vo
Output 1V
@
0.02A, VIN = 9.75V, SKIP, L = 10μH, f = 300kHz, C
OUT
=
660μF
FIGURE 9. VIN Removal in SKIP Mode
L
www.national.com
14
相關PDF資料
PDF描述
LM2746 Low Voltage N-Channel MOSFET Synchronous Buck Regulator Controller
LM2746MXA Low Voltage N-Channel MOSFET Synchronous Buck Regulator Controller
LM2746MXAX Low Voltage N-Channel MOSFET Synchronous Buck Regulator Controller
LM2753SD High Power Switched Capacitor Voltage Convertor/Flash LED Driver
LM2753 High Power Switched Capacitor Voltage Convertor/Flash LED Driver
相關代理商/技術參數
參數描述
LM27241MTCX/NOPB 功能描述:IC REG CTRLR BUCK PWM VM 20TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP(0.300",7.62mm) 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF)
LM27243A E WAF 制造商:Texas Instruments 功能描述:
LM2724A 制造商:NSC 制造商全稱:National Semiconductor 功能描述:High Speed 3A Synchronous MOSFET Driver
LM2724ALD 制造商:NSC 制造商全稱:National Semiconductor 功能描述:High Speed 3A Synchronous MOSFET Driver
LM2724ALD/NOPB 功能描述:IC DRIVER MOSFET DUAL SYNC 8-LLP RoHS:否 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 外部開關 系列:- 標準包裝:50 系列:- 配置:低端 輸入類型:非反相 延遲時間:40ns 電流 - 峰:9A 配置數:1 輸出數:1 高端電壓 - 最大(自引導啟動):- 電源電壓:4.5 V ~ 35 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-6,D²Pak(5 引線+接片),TO-263BA 供應商設備封裝:TO-263 包裝:管件