- 您現在的位置：買賣IC網 > PDF目錄369783 > LM2418 Triple Video Amplifier PDF資料下載
參數資料
| 型號： | LM2418 |
| 元件分類： | 視頻放大器 |
| 英文描述： | Triple Video Amplifier |
| 中文描述： | 三路視頻放大器 |
| 文件頁數： | 6/11頁 |
| 文件大?。?/td> | 815K |
| 代理商： | LM2418 |
Application Hints
(Continued)
NSC Demonstration Board
Figures 11, 12 show routing and component placement on
the NSC LM2202/2412 demonstration board. The schematic
of the board is shown in Figure 10 This board provides a
good example of a layout that can be used as a guide for
future layouts. Note the location of the following compo-
nents:
C47 - V
bypass capacitor, located very close to pin 6
and ground pins. (Figure 12)
C49 - V
bypass capacitor, located close to pin 10 and
ground. (Figure 12)
C46 and C77 - V
bypass capacitors, near LM2412A
and V
clamp diodes. Very important for arc protection.
(Figure 11)
The routing of the LM2412A outputs to the CRT is very
critical to achieving optimum performance. Figure 13 shows
the routing and component placement from pin 1 to the blue
cathode. Note that the components are placed so that they
almost line up from the output pin of the LM2412Ato the blue
cathode pin of the CRT connector. This is done to minimize
the length of the video path between these two components.
The direct video path is shown in by a dark gray line through
the components and the PCB traces. Note also that D24,
D25, R58 and D19 are placed to keep the size of the video
nodes to a minimum (R58 is located under D19). This mini-
mizes parasitic capacitance in the video path and also en-
hances the effectiveness of the protection diodes. The traces
in the video nodes to these components are shown by the
white line. The anode of protection diode D25 is connected
directly to the ground plane giving a short and direct path to
the LM2412A ground pins. The cathode of D24 is connected
to V
very close to decoupling capacitor C78 (Figure 13)
which is connected to the same section of the ground plane
as D25. The diode placement and routing is very important
for minimizing the voltage stress on the LM2412A during an
arc-over event. Lastly, notice that S3 is placed very close to
the blue cathode and is tied directly to CRT ground.
L
www.national.com
6
相關PDF資料 |
PDF描述 |
|---|---|
| LM249 | |
| LM2577MX-15 | Current-Mode SMPS Controller |
| LM2577MX-ADJ | Current-Mode SMPS Controller |
| LM2577SX-12 | Current-Mode SMPS Controller |
| LM1575K-12 | Voltage-Mode SMPS Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2418T | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| LM2419 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Triple 65 MHz CRT Driver |
| LM2419T | 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel |
| LM242 | 制造商:LM TECHNOLOGIES 功能描述:BASE UNIT SMA CONNX W/1.5M CABLE 制造商:LM TECHNOLOGIES 功能描述:BASE UNIT, SMA CONNX W/1.5M CABLE 制造商:LM TECHNOLOGIES 功能描述:BASE UNIT, SMA CONNX W/1.5M CABLE; Impedance:50ohm ;RoHS Compliant: Yes |
| LM2421 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Monolithic Triple Channel HDTV Driver |
發布緊急采購，3分鐘左右您將得到回復。