參數資料
型號: LM1247AAG/NA/NOPB
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 音頻/視頻放大
英文描述: 3 CHANNEL, VIDEO PREAMPLIFIER, PDIP24
封裝: PLASTIC, DIP-24
文件頁數: 45/48頁
文件大小: 3141K
代理商: LM1247AAG/NA/NOPB
LM1253A and LM1237 Compatibility
In order to maintain register compatibility with the LM1253A
and LM1237 preamplifier datasheet assignments for bias
and brightness, the color assignments are recommended as
shown in Table 2. If datasheet compatibility is not required,
then the DAC assignments can be arbitrary.
TABLE 2. LM1253A/LM1237 Compatibility
DAC Bias Outputs
LM1247 Pin:
DAC 1
DAC 2
DAC 3
DAC 4
Assignment:
Blue
Green
Red
Brightness
OSD vs Video Intensity
The OSD amplitude has been increased over the LM1237
level. During monitor alignment, the three gain registers are
used to achieve the desired front of screen color balance.
This also causes the OSD channels to be adjusted accord-
ingly, since these are inserted into the video channels prior
to the gain attenuators. This provides the means to fine tune
the intensity of the OSD relative to the video as follows. If a
typical starting point for the alignment is to have the gains at
maximum (0x7F) and the contrast at 0x55, the resultant
OSD intensity will be higher than if the starting point is with
the gains at 0x55 and the contrast at maximum (0x7F). This
tradeoff allows fine tuning the final OSD intensity relative to
the video. In addition, the OSD contrast register, 0x8438
[4:3], provides 4 major increments of intensity. Together,
these allow setting the OSD intensity to the most pleasing
level.
ESD Protection
The LM1247 features a 3.0 KV ESD protection level (see
(Notes 4, 13)). This is provided by special internal circuitry
which activates when the voltage at any pin goes beyond the
supply rails by a preset amount. At that time the protection is
applied to all pins, including SDA and SCL. If any signal
other than these two is applied to the LM1247 while the V
CC
is near zero, such as horizontal and vertical deflection pulses
of sufficient amplitude, this protection will activate and pre-
vent any communication on the I
2C bus common to the
LM1247, until the other signal or signals are removed. Nor-
mally, with all other pins unenergized, the LM1247 will not
affect I
2C communication when it is powered down.
LM1247
www.national.com
6
相關PDF資料
PDF描述
LM1253AAE/NA ON-SCREEN DISPLAY IC, PDIP28
LM1267NA/NOPB 3 CHANNEL, VIDEO PREAMPLIFIER, PDIP24
LM1269NA/NOPB 3 CHANNEL, VIDEO PREAMPLIFIER, PDIP24
LM1276AAA/NA 1 CHANNEL, VIDEO PREAMPLIFIER, PDIP28
LM1279AN/NOPB 3 CHANNEL, VIDEO AMPLIFIER, PDIP20
相關代理商/技術參數
參數描述
LM1247DMC/NA 制造商:Texas Instruments 功能描述:
LM124A 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Power Quad Operational Amplifiers
LM124AD 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:LOW POWER QUAD OPERATIONAL AMPLIFIERS
LM124ADR 制造商:TI 制造商全稱:Texas Instruments 功能描述:QUADRUPLE OPERATIONAL AMPLIFIERS
LM124ADT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Feedback Operational Amplifier