- 您現在的位置：買賣IC網 > PDF目錄384593 > LIS2L02AS4 (意法半導體) MEMS INERTIAL SENSOR: 2-Axis - 【2g/【6g LINEAR ACCELEROMETER PDF資料下載
參數資料
| 型號： | LIS2L02AS4 |
| 廠商： | 意法半導體 |
| 英文描述： | MEMS INERTIAL SENSOR: 2-Axis - 【2g/【6g LINEAR ACCELEROMETER |
| 中文描述： | MEMS慣性傳感器：兩軸- 【2克/【六克線性加速度計 |
| 文件頁數： | 6/14頁 |
| 文件大?。?/td> | 167K |
| 代理商： | LIS2L02AS4 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁
LIS2L02AS4
6/14
4
Functionality
The LIS2L02AS4 is a high performance, low-power, analog output two axes linear accelerometer pack-
aged in a SO24 package. The complete device includes a sensing element and an IC interface able to
take the information from the sensing element and to provide an analog signal to the external world.
4.1 Sensing element
A proprietary process is used to create a surface micro-machined accelerometer. The technology allows
to carry out suspended silicon structures which are attached to the substrate in a few points called anchors
and are free to move in the direction of the sensed acceleration. To be compatible with the traditional pack-
aging techniques a cap is placed on top of the sensing element to avoid blocking the moving parts during
the moulding phase of the plastic encapsulation.
When an acceleration is applied to the sensor the proof mass displaces from its nominal position, causing
an imbalance in the capacitive half-bridge. This imbalance is measured using charge integration in re-
sponse to a voltage pulse applied to the sense capacitor.
At steady state the nominal value of the capacitors are few pF and when an acceleration is applied the
maximum variation of the capacitive load is up to 100fF.
4.2 IC Interface
In order to increase robustness and immunity against external disturbances the complete signal process-
ing chain uses a fully differential structure. The final stage converts the differential signal into a single-end-
ed one to be compatible with the external world.
The signals of the sensing element are multiplexed and fed into a low-noise capacitive charge amplifier
that implements a Correlated Double Sampling (CDS) at its output to cancel the offset and the 1/f noise.
The output signal is de-multiplexed and transferred to two different S&Hs, one for each channel and made
available to the outside.
The low noise input amplifier operates at 200 kHz while the two S&Hs operate at a sampling frequency of
66 kHz. This allows a large oversampling ratio, which leads to in-band noise reduction and to an accurate
output waveform.
All the analog parameters (zero-g level, sensitivity and self-test) are ratiometric to the supply voltage. In-
creasing or decreasing the supply voltage, the sensitivity and the offset will increase or decrease almost
linearly. The self test voltage change varies cubically with the supply voltage.
4.3 Factory calibration
The IC interface is factory calibrated for Sensitivity (So) and Zero-g Level (Voff). The trimming values are
stored inside the device by a non volatile structure. Any time the device is turned on, the trimming param-
eters are downloaded into the registers to be employed during the normal operation. This allows the user
to employ the device without further calibration.
相關PDF資料 |
PDF描述 |
|---|---|
| LIS2L06AL | MEMS INERTIAL SENSOR: 2-axis - +/- 2g/6g ULTRACOMPACT LINEAR ACCELEROMETER |
| LIS2L06ALTR | MEMS INERTIAL SENSOR: 2-axis - +/- 2g/6g ULTRACOMPACT LINEAR ACCELEROMETER |
| LIS302ALK | MEMS motion sensor 3-axis-【2g analog output "piccolo" accelerometer |
| LIS302ALKTR | MEMS motion sensor 3-axis-【2g analog output "piccolo" accelerometer |
| LIS3L02AS4 | MEMS INERTIAL SENSOR 3-Axis - 【2g/【6g LINEAR ACCELEROMETER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LIS2L02AS4-TR | 功能描述:加速計 - 板上安裝 LINEAR ACCELEROMETER 2 AXIS 2G/6G RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
| LIS2L02AS-TR | 制造商:STMicroelectronics 功能描述:LINEAR ACCELEROMETER 2 AXIS - Tape and Reel |
| LIS2L06A | 制造商:STMicroelectronics 功能描述:ACCELERATION SENSOR IC |
| LIS2L06AL | 功能描述:加速計 - 板上安裝 2-axis +/-2g/+/-6g MEMS Intertial Sensr RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
| LIS2L06AL_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:MEMS INERTIAL SENSOR:2-axis - +/- 2g/6g ultracompact linear accelerometer |
發布緊急采購，3分鐘左右您將得到回復。