參數資料
| 型號： | KSZ8993MLI |
| 廠商： | Micrel Inc |
| 文件頁數： | 26/86頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SWITCH 10/100 3PORT 128-PQFP |
| 標準包裝： | 66 |
| 系列： | * |
| 產品目錄頁面： | 1081 (CN2011-ZH PDF) |
| 其它名稱： | 576-3350 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
Micrel, Inc.
KSZ8993M/ML
October 2008
32
M9999-020606
The MII interface operates in either PHY mode or MAC mode. The interface is a nibble wide data interfaces and
therefore run at the network bit rate (not encoded). Additional signals on the transmit side indicate when data is
valid or when an error occurs during transmission. Likewise, the receive side has indicators that convey when the
data is valid and without physical layer errors. For half duplex operation there is a signal that indicates a collision
has occurred during transmission.
Note that the signal MRXER is not provided on the interface for PHY mode operation and the signal MTXER is
not provided on the interface for MAC mode operation. Normally MRXER would indicate a receive error coming
from the physical layer device. MTXER would indicate a transmit error from the MAC device. These signals are
not appropriate for this configuration. For PHY mode operation, if the device interfacing with the KSZ8993M has
an MRXER pin, it should be tied low. For MAC mode operation, if the device interfacing with the KSZ8993M has
an MTXER pin, it should be tied low.
SNI (7-Wire) Operation
The serial network interface (SNI) or 7-wire is compatible with some controllers used for network layer protocol
processing. In SNI mode, the KSZ8993M acts like a PHY and the external controller functions as the MAC. The
KSZ8993M can interface directly with external controllers using the 7-wire interface. These signals are divided
into two groups, one for transmission and the other for reception. The signals involved are described in the
following table.
Pin Descriptions
External MAC
Controller Signals
KSZ8993M
PHY Signals
Transmit enable
TXEN
SMTXEN
Serial transmit data
TXD
SMTXD[0]
Transmit clock
TXC
SMTXC
Collision detection
COL
SCOL
Carrier sense
CRS
SMRXDV
Serial receive data
RXD
SMRXD[0]
Receive clock
RXC
SMRXC
Table 4. SNI Signals
The SNI interface is a bit wide data interface and therefore runs at the network bit rate (not encoded). An
additional signal on the transmit side indicates when data is valid. Similarly, the receive side has an indicator that
conveys when the data is valid.
For half duplex operation, the KSZ8993M’s SCOL signal is used to indicate that a collision has occurred during
transmission.
MII Management Interface (MIIM)
The KSZ8993M supports the IEEE 802.3 MII Management Interface, also known as the Management Data
Input/Output (MDIO) Interface. This interface allows upper-layer devices to monitor and control the states of the
KSZ8993M. An external device with MDC/MDIO capability can be used to read the PHY status or configure the
PHY settings. Further details on the MIIM interface can be found in section 22.2.4.5 of the IEEE 802.3
specification.
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8993ML | IC SWITCH 10/100 W/TXRX 128PQFP |
| KSZ8995FQ | IC SWITCH 10/100 5PORT 128-PQFP |
| KSZ8995MA | IC SWITCH 10/100 5PORT 128PQFP |
| KSZ8995MI | IC SWITCH 5-PORT 10/100 128PQFP |
| KSZ9021GN TR | TXRX ETHERNET GB GMII/MII 64MLF |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8995FQ | 功能描述:以太網 IC Integrated 5-Port Switch with Fiber on Port 3 & 4, Lead free RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8995FQ-EVAL | 功能描述:以太網開發工具 Integrated 5-Port Switch with Fiber on Port 3 & 4 Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| KSZ8995FQI | 功能描述:以太網 IC 5 Port 10/100 Switch with PHY and Frame Buffers (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8995M | 功能描述:以太網 IC 5 Port 10/100 Switch with PHY and Frame Buffers (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8995MA | 功能描述:以太網 IC 5 Port 10/100 Switch with PHY and Frame Buffers (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。